[Q] wifi debian - Kindle Fire Q&A, Help & Troubleshooting

can sombody please give me detailed instructions for setting up wireless wpa2 on the kindle. like how to set up moduels and where to get android firmware. I tried to use insmod for moduels and the firmware file from the akop build im duel botting it with. Im just a bit lost thanks for the help.

Related

[Q] Upgraded to FRX04, and Kernal 1253 still no WIFI

Hello,
I have been reading for hours and have tried several different things,
please see my other post http://forum.xda-developers.com/showthread.php?t=926284
This evening I upgraded to Kernal 1253, my tilt 2 shows that it is running FRX04 and also kernal 1253 but still when I turn on wifi I get the same result (it starts and then it says scanning and then it says staring and then it says disconnected.
I also followed the tips in http://forum.xda-developers.com/archive/index.php/t-695230.html which involve putting your mac iaddress into wifi-nvram.txt but that didn't work either. Should Wifi be working on a Tilt2 with the latest kernal and FRX04?
Also, I have noticed that the GPS doesn't apear to be working either. Otherwise the phone works great. Still wish I could get bluetooth working but have not seen anything helpful on that either.
is ur wifi WEP password protected?
because no rhodium android works with that sadly =(
switch it to WPA
You'd probably get better info if you posted in the Android section. Good luck.
This will fix your problem. Find your MAC ADDRESS on your phone and write it in the WIFI-NVRAM.TXT then place the WIFI-NVRAM.TXT in the root of your storage card. Now replace your FROYO.USER.CONF with the one in this zip. The FROYO.USER.CONF is in this folder ANDBOOT/CONF. Now boot android and you'll have wifi working.
www.4shared.com/file/UXS_y76U/WIFI-NVRAM.html
[Q] Upgraded to FRX04, and Kernal 1253 still no WIFI
Hello,
I have been reading for hours and have tried several different things,
please see my other post http://forum.xda-developers.com/showthread.php?t=926284
This evening I upgraded to Kernal 1253, my tilt 2 shows that it is running FRX04 and also kernal 1253 but still when I turn on wifi I get the same result (it starts and then it says scanning and then it says staring and then it says disconnected.
I also followed the tips in http://forum.xda-developers.com/arch.../t-695230.html which involve putting your mac iaddress into wifi-nvram.txt but that didn't work either. Should Wifi be working on a Tilt2 with the latest kernal and FRX04?
Also, I have noticed that the GPS doesn't apear to be working either. Otherwise the phone works great. Still wish I could get bluetooth working but have not seen anything helpful on that either.
_________________________________________________
Hi
im having this same problem, even when trying the wifi workaround. i wish there was a way
Wifi totally not working or just cannot connect to hotspots?

[Q] Android 2.3.3 wifi compatability problems in custom roms

hi guys, go easy on me its my first post
love the website the guides have helped me to successfully downgrade, s-off and flash custom roms to my dhd
I searched for the answer to this question but couldnt find anything. Is there any plan for custom rom developers to fix the 2.3.3 rom wifi compatability problems with speedtouch modems, as this is the only reason i cant use 2.3.3 based roms? (a lot of people have this problem with the stock rom but it is also in leedroids new one, android rev. etc) Would like to ask this in the android dev section but i need 10 posts for that.
Thanks for the help you lot have already given me, and i love the video!
Steve
Hi, welcome and congrats on your first post.
What specifically is the problem with the wifi? Is it specific to a type of authorisation (WEP, WPA/2) issue or something else?
thanks
this is a link to a detailed description of this exact problem: http://forum.xda-developers.com/archive/index.php/t-1063103.html
i really dont expect anyone to go through the hassle of reading this, so summarized it says that ever since the gingerbread 2.3.3 update the phone is capable of connecting to all modems, but cannot transfer data on certain ones (such as the speedtouch modems)
I found a good post on this in a german forum a couple of weeks ago but i cant find it now, (i'll keep looking) but it said the problem was that some modems transmit with n and some with b or something like that. and that the only answer was to wait (ages) for a stock rom update (2.3.4?) as 2.3.3 isn't compatible with these types of modems
i would have expected this had been solved in the custom roms though
this is a qoute from the link below
"It turns out the Be Box router which Be supplied, which is a THOMSON ST585v6, is not compatible but also other versions of THOMSON routers as well."
ptth://vvv.htcdesirehdforum.com/htc-desire-hd-troubleshooting/wifi-issue-with-gingerbread-update/ (change the ptth to http and vvv to www) i cant post outside links
Ok, just read through that thread. What model of Speedtouch router are you using?
One workaround is to use a static IP. Have you tried this? I can help you set this up if required.
HTC seem to blame this issue on Google, as an Android issue. Not sure about that as any ROM that uses Gingerbread would exhibit the same problem, which isn't the case.
modem is a Thompson Speedtouch ST585 v6
Thanks but i have already tried and the modem only works with dynamic IPs (tried to solve it with a static IP for ages with my dad but it didnt work xD)
This qoute from dioky on page 4 of the link below states (i'm pretty certain) the problem: (i clicked the thanks button for this answer)
"Hi there,
I have the same WiFi problems as all of you.
Furthermore I can confirm that changing ROM (ARHD or Leedroid) won't help, if you stay with Gingerbread versions, that is.
I found out that:
* Data won't flow (although connected fine) to SpeedTouch WiFi access point (b/g).
* Data won't flow (although connected fine) through D-Link DAP1360 .
* BUT: does flow (and connected fine off course) through Belkin G Plus MIMO access point (g)!
I have rechecked it by reflashing back to ARHD 3.7 returning to ARHD 5.1.7 and ARHD 5.1.4 and LeeDroiD 3.0.3.
Which in all, makes me conclude that there definitely is something on the software side concerning compatibility!
For now, I will return to ARHD 3.7 Android 2.2.1 until solution is found.
Regards,"
http://forum.xda-developers.com/showthread.php?p=13922024
Does anybody know if the Rom devs.plan to solve this (or even know about this problem)?
any ideas peeps?? this is a major problem for me
You want to try giving a static IP another shot?
i'm pretty sure it wont work as i tried to solve the prob like this but whatever i did i couldnt get it to work. but i'll give it another shot. another idea would maybe be updating the modem drivers if there is such a thing?
What is your routers current firmware version? And is that a branded router?
i really have no idea. i'm a total noob with routers
can you tell me an easy way how i could find out?
Sure, are you using your PC to access the web at the minute?
If you install TeamViewer I could show you.
?????? What is that ?
Its a piece of software that will allow me to remotely control a computer.
I can confirm that I have this problem with 2.3.3 and my Thomson/SpeedTouch 585v6 (FW 6.1.4.3) too.
It seems to connect WiFi fine, even assigns an IP but nothing actually works.
Solution for Wifi problem 2.3.3
Hello!
I have the same problem on my DHD with 2.3.3
Before there is an permanent fix for this You could manually configure the IP adress in the phones Wifi and it works great.
You can not use the DHCP in the phone.
it-solutions4u.se said:
Hello!
I have the same problem on my DHD with 2.3.3
Before there is an permanent fix for this You could manually configure the IP adress in the phones Wifi and it works great.
You can not use the DHCP in the phone.
Click to expand...
Click to collapse
I should have mentioned that I actually have a HTC Desire (not HD). But the ROM is a 2.3.3. It actually assigns the IP via DHCP just fine.
I have already tried manually assigning the IP address (and other fields) but still no luck.
There are those who can connect with a manual IP and a few, even after assigning it manually, still can not connect.
i tried using a static IP but it doesnt work..tried for days now
sounds like i am one of the few it doesnt work for after assigning manually...
i am a total noob but i was wondering if it would be possible for a custom rom dev to take the wifi drivers from froyo and use them in a gingerbread based rom??
UPDATE
I called up my ISP requesting a newer firmware for the 585v6 router (although I know it is no longer supported). Anyway, without any hassle at all, they gave me the newer: TG585 v7 router with firmware 8.2.23.0 (pre-installed).
This connects without any problems to my 2.3.3 ROM (RCMix 2.0).

[Q] Arc s, Wifi and no Connection at all

Hey there,
I am having the following problem and I hope that someone on this lovely Board will be able to help me solve it.
I have updated my Arc s to ICS yesterday. The Flashing Process worked very well, thanks to the Guide on the Board. After the last Reboot of my Phone I was greeted with the new Start Animation Logo and the Guide to Customize some Options, including Wifi settings. I skipped it. When the Process was finished, I went to the Settings Memu to Setup my Wifi on my Device, entered the Password (no Typos, Triple-Checked), touched Connect and....it shows "Authentification Problem". Every Time I try to connect. Before the Update everything was working perfectly nornal.
Then I went to look through the Board, found a Theread were a Fix was offered. I downloaded it to my PC. Now for the Tricky part:
As I have mentioned, I don`t have a Wifi Connection with my Phone. So, how do I Install .apk files onto my Phone? I neither have Bluetooh on my PC, nor do I have a File Manager installed in my Phone.
Thanks in advance
Jack
There can be problems with .70 baseband. Try flashing .66 baseband with flashtool.
sinksterĀ©

Kernel Help

Hi guys,
hope I can post this here. Part of android development but if not please move
I'm using a ROM that has sense in at the moment. The issue is that I can connect to my Access Point but I can't browse the internet. This was also the issue on my Stock ROM.
I then tested a senseless ROM and the wifi works 100% (wifi also works on several other devices. My HTC does work when I connect it to the router itself and not a access point.)
So this comes then down to software. I did read a bit and looks like it might be fix-able by changing the kernel a bit. Is it possible to take the "wifi" part of the senseless kernel and put it in the Sense kernel
What is the error?
You can change roms, you can change kernels, but if you just want wifi working it would be best to debug it with the stock kernel in case you get stuck later...
Do this: Dial *#*#4636#*#* -> Phone information -> Run ping test. Then post the results.
zvieratko said:
What is the error?
You can change roms, you can change kernels, but if you just want wifi working it would be best to debug it with the stock kernel in case you get stuck later...
Do this: Dial *#*#4636#*#* -> Phone information -> Run ping test. Then post the results.
Click to expand...
Click to collapse
With any rom, including the Stock rom, I can connect to my access point but then I can't browse using my phone. My laptop, blackberry and HTC Sensation works 100% with the same connection.
When I flash my HTC One X rom with a AOSP (think it's that. The rom without sense) then my wifi connects and I can browse.
I installed terminal emulator and I can ping other devices on the network including the access point but not the router.
I did dial *#*#4636#*#* and Run Ping Test.
Ping IpAddr: Fail: IP Addr not reachable

please help me! Nexus 7 2013 flo wifi authentication problem

please anyone could help me out to restore my nexus 7 2013 wifi tablet. I couldnt be able to get pass the wifi opening set up it says authentication problem, I tried several wifi devices but it just can't connect through. It was happen after when i change its mac address. The story there is, i change my mac address because one of our neighbor's wifi seems always blocking my mac address so i really need to have or change it into a new one so i could connect to their wifi again, at the first place it worked smoothly as if everything is not screwd (here is the directory/path ive changed "/persist/wifi/.mcadress" then i edited the values) running kitkat version 4.4.4 ktup8. So this morning i decided to wipe its data and cache and it booted but now i cannot connect to any wifi im stuck in the opening set up, tried also reverting to another stock rom 6.0.1 marshmallow still the problem exist and i can still see the mcaddress it still not change to the default one even though i reflashed it into a different firmware. Please i dont want to lose my tablet im begging you guys. And Iam so careless that I dont have any a nandroid back up or please anyone could give me a file a nandroid back up so I could restore it using wugfresh toolkit. Please help me....
tldr; He was freeloading off his neighbor's wifi and the neighbor blocked him via his mac address. So he changed his mac address to get around it and the neighbor blocked that one too. Now he can't change it again and corrupted his network stack in the process.
ssenemosewa said:
tldr; He was freeloading off his neighbor's wifi and the neighbor blocked him via his mac address. So he changed his mac address to get around it and the neighbor blocked that one too. Now he can't change it again and corrupted his network stack in the process.
Click to expand...
Click to collapse
sir please, can you help me how to disable or skip the wifi set up or push a custom rom file on my device, i did try to push a file using nexus root toolkit but it didnt work since it require to enable my usb debugging and i cant do to enable it since i cannot go through with it, im stuck in the opening wifi set up.

Categories

Resources