Hello sorry my english is bad. I got problem with my phone. Phone dont turn on, when i connect to wall charger or pc only red led turn on. Pc see phone as semc usb device. When a try to flash with flashtool only this show device coonected with usb debugging off for 2011 devices line be sure you are not in mtp mode how i can turn on debugging usb when i cant run the phone. Seus dont see phone. Please help.:crying:
Try this method
If it helps you then thank me
First off everything remove the SIM card and let the phone rest for five minutes and put the SIM and
Press the power button and volume up button at the same time for little long time your phone wil start as normal
Some times **** happens bro
Sent from my LT26i using xda app-developers app
Dont work for me
lukasz8504 said:
Hello sorry my english is bad. I got problem with my phone. Phone dont turn on, when i connect to wall charger or pc only red led turn on. Pc see phone as semc usb device. When a try to flash with flashtool only this show device coonected with usb debugging off for 2011 devices line be sure you are not in mtp mode how i can turn on debugging usb when i cant run the phone. Seus dont see phone. Please help.:crying:
Click to expand...
Click to collapse
Connect in flashtool, relock bootloader. Use seus to install fresh fw.
lukasz8504 said:
Dont work for me
Click to expand...
Click to collapse
Ok i find this tread http://forum.xda-developers.com/showthread.php?t=1527159 but when i try to enter flashmode i see this message device conected with usb debugging off for 2011 devices line be sure you are not in mtp mode
Try to use a different charger. I got the same bug with a sola . It worked with a samsung wallcharger. The sola was not loading with the sony charger when i turned it of. Other's reported this bug when phone turns off because of empty battery.
I try charger from se x10, xperia s, iphone 3gs and zte blade and nothing change still red led and after few minute red turn off and then pc see phone but in flashtool only this message device coonected with usb debugging off for 2011 devices line be sure you are not in mtp mode
lukasz8504 said:
I try charger from se x10, xperia s, iphone 3gs and zte blade and nothing change still red led and after few minute red turn off and then pc see phone but in flashtool only this message device coonected with usb debugging off for 2011 devices line be sure you are not in mtp mode
Click to expand...
Click to collapse
I think your phone hard bricked !
In this situation if you couldn't reset your phone by holding power+volume up till it 3 times vibrate , try power+volume down when you connected to pc sometimes it reset your phone.
try power+volume up when you plugged in wall charger till 3 times vibrate ( in some situations it happens after 30 second you hold both.
If none on this reset your phone , its only way that you send it to repare service of sony to re write your bootloader by JTAG box. I had the same problem when I install an improper kernel and I search all of net and try all thing I found but after 2 week I can't solve the problem and only way to back your phone to work is, re writing your bootloader by JTAG box
Anybody can help? maybe trim area problem??
that happened to me once. I removed the battery, connected the wall charger, and then put the battery back. It was the last thing I tried and it worked.
(Yes, I had to open the phone, so I don't have warranty)
waiflih said:
that happened to me once. I removed the battery, connected the wall charger, and then put the battery back. It was the last thing I tried and it worked.
(Yes, I had to open the phone, so I don't have warranty)
Click to expand...
Click to collapse
I try this and red led blink now
Can you now plug in to pc holding volume down to get flash mode though?
Sent from my LT26i using Tapatalk 2
When i connect to pc with volume down in flashtool see for devices 2011... mtp mode, device manager show semc flash device and somthing new sony ericsson seehcri control device
Does the led stop going red then?
Sent from my LT26i using Tapatalk 2
Yes when connect to pc red led turn off, flashtool see phono but not in flashmode
Did you repaired it bro
No my phone is in second service and i must wait. I find possible solution but cant try it. http://forum.xda-developers.com/showthread.php?t=1910029
Are you sure you're connecting.phone to PC in flashmode? (holding down the volume button while plugging in the phone)
Good luck there then
lukasz8504 said:
Hello sorry my english is bad. I got problem with my phone. Phone dont turn on, when i connect to wall charger or pc only red led turn on. Pc see phone as semc usb device. When a try to flash with flashtool only this show device coonected with usb debugging off for 2011 devices line be sure you are not in mtp mode how i can turn on debugging usb when i cant run the phone. Seus dont see phone. Please help.:crying:
Click to expand...
Click to collapse
I had this pr0blem but s0lved it ..!!"
Jxt remove y0ur sim card wait f0r 10 sec0ndz Then v0lume up + P0wer f0r 5 sec0ndz and the ph0ne will vibrate 3 times after that release butt0nz n p0wer 0n the device d0nt plug in the charger then it will turn 0n and say shutting d0wn and after when it shut down plug it ........ Pr0b s0lved
hello all, sorry for my bad inglish but i will try to explain my problem as best as possible, i'm tried to flash my xperia play via flashtool, i am not doing this first time so i have experience, i did everything as it must be but it stucked at 14% while flashing, with nomoving on, i plug out the cable, took out the battery, put it back, and now when i try to connect it again to PC led is burning red and on pc says that unknown device is connected, no green light while flashmode and no blue light while fastboot mode, it only shows red light, when plug in with charger wthout battery, the green led is burning permanently, i can't flash my device and can't switch it on, what should i do ?
Check this thread for your solution
http://forum.xda-developers.com/showthread.php?t=2126311
maybe you have a problem with your usb port (cmiiw)
Sent from my R800i using xda premium
Hey guys i hope someone can help me out : )
Problem:
I froze some system apps on my xperia pro including mtp (the one that you need for the usb to connect to the computer)?!
well then i was using the phone like regularly and it suddenly froze.
Rebooted the phone ..black screen , the phone is booting normally but i cant see a thing of course.
Fastboot / Flash mode
With flashtool It says its connecting but then i get an error
With the cmd fastboot method its just stating "waiting for device" and when i connect it in fastboot mode nothing is happening just windows telling me thats something wrong with the usb connection and it wont work.
When the phone is turned on and connected to the computer i can see it listed in the device manager as mk16i
if that is relevant
Thanks for reading.
problem 1 : is your phone hardware qwerty button light up when you turn it on and dim when wait a few second? if similiar like that maybe you need to replace the flex cable
problem 2 : try reinstall your phone's driver and make sure you connect the phone in fastboot mode with blue notification led light up.
Hello guys. I just got this Xperia Acro S with the red light when it is connected to the charger. The phone was working all right and then it suddenly went off. When it is connected to the wall charger (Samsung or Sony charger) it gives a red led for a while, depends on how long it was disconnected from the charger and then the led goes off. If I connect to the pc, I get SEMC Flash Device. I tried everything I saw in lots of forums and nothing helped. If I hold the Volume + with power button, I don't get any vibration, no matter how long I hold. The same thing with the Volume - and the same with the Volume + - and the power button together. If I connect to the pc, the red led will come on, then after a while it will go off and only then the pc sees the device as SEMC Flash. I tried to remove the battery and reconnected it, but still no results as well. The flashtool says For 2011 devices line, be sure you are not in MTP mode. SUS doesn't see the phone, but the PC companion behaves strangly. When it says connect the phone, I plug it in and then the Pc companion says: Please update Pc companion. When I check for latest version it tells me that is the latest one. It can't be an old version, because I just downloaded it from the sony website. If I launch the repair services, it says press volume down and connect usb. I did that but the phone keeps entering into SEMC Flash mode. Please help me out
Hi,
I can't get into fastboot mode on my Sony Acro S. I hold the volume up button and then insert the USB cable. The blue led light up and everything seams to be ok but after some seconds the led get dark and the phone shows the Sony logo. The computer recognize the phone and the device manager shows an unknown device but It disapear after a while...
Anyone that have seen this before and maybe have a solution?
//Robert
That means your computers system is unable to install essential fastboot drivers for your phone. Try alternative USB ports.
If still it doesn't work then try it on another system. Also have a look on this,
http://forum.xda-developers.com/showthread.php?t=2447319