G3 reset problem - G3 Q&A, Help & Troubleshooting

So i rooted my G3 and did a factory reset , now when i am at the setup , My G3 turns off , and reboots , and again , and i can t do nothing , what should i do?

So what is the state of your phone, stock rooted, stock rooted bumped?
---------- Post added at 01:24 PM ---------- Previous post was at 01:15 PM ----------
There is probably a better way but you can use the flashtool and flash the right kdz for your phone which will fix your problem. There might be an easier way so you might want to wait and see what someone else says but flashing the kdz will definitely fix it.

Related

[Q] Fimware upgrade encountered an issue

Some one plz help me out on this...
Am on DN3 Rom, and am stuck on
"Firmware Upgrade encountered an issue please select recovery mode in Kies and try"" screen.
I cant get into download mode or recovery mode so,
flahing stock or anything seems difficult.
Even ODin ask to boot into download mode so as to fix the issue.
i cant get to download,mode or get past the"" Firmware Upgrade encountered an issue"" screen.
All drivers are installed.
some one plz help me out as this is the only phone i have now
What ROM did you flash exactly? Link?
What recovery are you on?
And what exact steps did you take.
---------- Post added at 02:51 PM ---------- Previous post was at 02:48 PM ----------
Your post history shows note 2?? Are you sure you're in the right section? This is the s2 t989 section.

URGENT!! Help needed! PLEASE (bootloop)

Hey guys.
Ok so i sideloaded the latest update and i went ahead and unlocked the bootloader,then i flashed custom twrp and i attempted to install a custom rom. Prior to that i wiped data and i cancelled the process thinking it was taking too long,i rebooted into recovery again and flashed the custom rom and it was successful,now after a reboot its stuck on the "Asus welcome screen" powered by android,it continues in that loop,i cant seem to access fastboot or bootloader or recovery or anything?? Am i screwed???:crying:
Did you tried with volume up + power ? (release power when the phone vibrates) thats the fastboot, it displays a usb logo?
---------- Post added at 10:40 PM ---------- Previous post was at 10:35 PM ----------
My phone (ZE551ML) shows an USB logo and if it i let it boot normally shows asus screen and reboots, that's it. I've read about intel phone flash tool and intel manufacturing flash tool but i dont have the RAW firmware needed to flash, no one seems to have it :S im considering taking it to service at USA even when i live in Venezuela and that will be pretty expensive $$$, but i dont see any other options
[/COLOR]My phone (ZE551ML) shows an USB logo and if it i let it boot normally shows asus screen and reboots, that's it. I've read about intel phone flash tool and intel manufacturing flash tool but i dont have the RAW firmware needed to flash, no one seems to have it :S im considering taking it to service at USA even when i live in Venezuela and that will be pretty expensive $$$, but i dont see any other options[/QUOTE]
refering to your problem i did find that their isnt a raw firmware for the 551 out that anyone knows of yet but theirs one out for the 550 and i remember reading that after you flash it with "asus flash tool" then u need to flash 551 files over it to make it 551 again. dont know if your interested in trying that but if you are i will do my best to find all the information on it and post it for you. best of luck with your problem.

LG G3 D855 TWRP Problem

Hello together,
I have a very big problem with my G3. A few days ago i tried to install CM13 on it, I thought everyting was fine but later in night the phone frezze always. Then i would restore the backup, but i canĀ“t. I got an error, but I cant remember what error..
Than I tried to wipe, I got errors again. i just want to take a photo, and it suddenly works...
But installing the rom takes very long. It stays at:
"Patching system image unconditionally..."
(sorry cant insert the image)
Sorry for the few informations and my bad English, but I hope for help
Thank you, and merry christmas!
--edit:
I updated twrp to 2.8.7.0 bevore I could whipe.
I used this to repair my phone:
http://open-freax.fr...ick-your-lg-g3/
I thought it was working.. But now it is broken again..
The phone worked very fine for one day. And today it freezed suddenly, then I pulled out the battery and tried to reboot. From this moment it stuck on the screen with the cm logo..
I can't wipe, it stuck.. Installing the Rom give an error..
The Rom which is installed is: cm-12.1-20151117-SNAPSHOT-YOG7DAO1K8-d855.zip
And the gaps: arm 5.1 nano 25 December 2015 from opengaps
Probably the guide I used was not the right one for my problem..
I hope that I haven't destroyed the good G3 :'(
Download a diffrent rom on pc put is on a flashdrive an on the go cable then flash it in twrp
---------- Post added at 07:57 AM ---------- Previous post was at 07:57 AM ----------
Or kdz or tot method back to stock and start again
Flashing a different rom was impossible, too.
tot method gives always errors.
And with using the kdz method, stuck at the the firmware update screen, after retrying now I stuck at the LG logo...
bricked again :good:

Stuck in a bootloop

I flashed official lg 6.0 software on my g3(without rooting) and after a month of normal use I got stuck in a bootloop. I can't go into safe mode, but can get into download mode. Is there any way that I can keep all my data and flash the same firmware again?
esadc said:
I flashed official lg 6.0 software on my g3(without rooting) and after a month of normal use I got stuck in a bootloop. I can't go into safe mode, but can get into download mode. Is there any way that I can keep all my data and flash the same firmware again?
Click to expand...
Click to collapse
Flash phone with lg up...you can flash the same firmware you had or any update version....in lg up choose upgrade it will not touch your data...but there is a problem how long i remember your phone have to be fully booted to connect with lg up...
Anik49 said:
Flash phone with lg up...you can flash the same firmware you had or any update version....in lg up choose upgrade it will not touch your data...but there is a problem how long i remember your phone have to be fully booted to connect with lg up...
Click to expand...
Click to collapse
I flashed my phone and it is still stuck in that bootloop
Same problem here. Got a new G3 from LG and back to the same point after 24h : bootloop again and again ! I really think there is a software issue with that phone.
fredzeone said:
Same problem here. Got a new G3 from LG and back to the same point after 24h : bootloop again and again ! I really think there is a software issue with that phone.
Click to expand...
Click to collapse
I had to hard rest it and now it works normally, you just need to hold the power button and volume down button until you see the lg screen. Then let it go and press it again until you see recovery mode where you can wipe your phone and it will work just fine.
esadc said:
I flashed my phone and it is still stuck in that bootloop
Click to expand...
Click to collapse
Then you have to choose refubris in lg up ..also use differen version of software for example if you have v30b then use v30c .....but you loose all your data.
---------- Post added at 07:33 PM ---------- Previous post was at 07:31 PM ----------
do a factory reset also work

H815 Died After Successfully Flashing Stock Firmware

Hey Guys, I have a problem with my h815. It is refurbished and I tried to flash other stock firmware it competed to 100% and the phone died ( i flash it with LGflashtool2014). I tried QPST flashtool it flashed something and error 1006 appeared and when I wait it a little the LED starts blinking, but the error was still there. So I decided to use the SD card method and finaly I entered in download mode.... I tried over 10 firmwares for H815, but with no success..... lg up stops at prepareafterdownload etc., lgflashtol2014 stops at 9% too... I havent eject the sd card while flashing the firmwares. Please help
---------- Post added at 11:10 AM ---------- Previous post was at 10:53 AM ----------
@TheMadScientist Bro, Can you help ?

Categories

Resources