LG G3 D855 TWRP Problem - G3 Q&A, Help & Troubleshooting

Hello together,
I have a very big problem with my G3. A few days ago i tried to install CM13 on it, I thought everyting was fine but later in night the phone frezze always. Then i would restore the backup, but i canĀ“t. I got an error, but I cant remember what error..
Than I tried to wipe, I got errors again. i just want to take a photo, and it suddenly works...
But installing the rom takes very long. It stays at:
"Patching system image unconditionally..."
(sorry cant insert the image)
Sorry for the few informations and my bad English, but I hope for help
Thank you, and merry christmas!
--edit:
I updated twrp to 2.8.7.0 bevore I could whipe.

I used this to repair my phone:
http://open-freax.fr...ick-your-lg-g3/
I thought it was working.. But now it is broken again..
The phone worked very fine for one day. And today it freezed suddenly, then I pulled out the battery and tried to reboot. From this moment it stuck on the screen with the cm logo..
I can't wipe, it stuck.. Installing the Rom give an error..
The Rom which is installed is: cm-12.1-20151117-SNAPSHOT-YOG7DAO1K8-d855.zip
And the gaps: arm 5.1 nano 25 December 2015 from opengaps
Probably the guide I used was not the right one for my problem..
I hope that I haven't destroyed the good G3 :'(

Download a diffrent rom on pc put is on a flashdrive an on the go cable then flash it in twrp
---------- Post added at 07:57 AM ---------- Previous post was at 07:57 AM ----------
Or kdz or tot method back to stock and start again

Flashing a different rom was impossible, too.
tot method gives always errors.
And with using the kdz method, stuck at the the firmware update screen, after retrying now I stuck at the LG logo...
bricked again :good:

Related

[Q] LG e975 won't boot, stuck on logo of LG

My new phone had been arived a few days ago, i want to install cyanogenmod 11 (kitkat) on my phone, so i installed the nightly buil.d
After that i found a big problem, the phone doesn't detect my sim card (european card), so i have flashed my phone back to stock. That is where the big problem started, the phone won't fully boot anymore. It stucks on te animated LG logo, it doesn't go further.
I tried to solve this by reboot, reflash with original LG software (not a KDZ file as in the first try), but all doesn't work.
The problem still occur.
Can anyone help me to solve this problem?
Your sincereley,
Robert1996
PM: I am sorry for my bad english, it is not the language that my parrents teached me when i grow up......
in fast boot, wipe everything and hard reset. Should solve the issue.
akahroba said:
in fast boot, wipe everything and hard reset. Should solve the issue.
Click to expand...
Click to collapse
To expand on the above answer in more detail, this type of recovery is covered in the FAQ - http://forum.xda-developers.com/showthread.php?t=2434917
13.Q: I tried custom roms, now I want to go back to stock. How do I do that?
A: Use kdz updater. HERE (http://forum.xda-developers.com/showpost.php?p=44874388&postcount=36) is how to use it. I made simple. Original thread HERE (http://forum.xda-developers.com/showthread.php?t=2010624). IMPORTANT : IF YOU GET STUCK AT LG LOGO AFTER USING KDZ UPDATER,YOU NEED TO PERFORM A HARD RESET. After this,the phone will boot.
Hope this helps
this here is very common that ppl don't wipe and hard reset their phones after flashing stock rom comming from a custom rom, even i forgot that the first couple of times :victory:

Bricked D855

I think i bricked my D855.
I was on Lam Hoang 1.8 rom, but i wanted to restore the original firmware v20h.
I've done the same thing i did many times, i tried to use kdz tools to flash the stock rom.
Everything was working fine when i got stuck at 10% in S/W Updating process.
I unplugged my phone after about 30 minutes, then i tried again, with the same result.
So i tried the TOT method, but the problem is the same, stuck at 10%.
It seems to be stuck on modem installation, as the last line in the log is MODEM.
Does anyone know how to fix this?
Thank you.
Resolved.
It was my pc fault.
I'm sorry.

Newbie mistake bootloop after update, help? ;/

I'm really new to this, hopefully someone can help me. I rooted my phone via method 3 in the Zenfone 2 resources thread. I didn't want to update but the phone downloaded it and I thought it might be ok. The phone updated and got stuck in a bootloop. I believe the update was Z00A 2.19.40.22 ( it was like 34mb?). I read all the threads I could and came to this one. I downloaded the preroot image Z00A 2.19.22 because in my recovery at the top ,it said that was what was on it now. Did I make a mistake there, should I have downloaded an older preroot image? I followed all the directions on recovering from a bootloop ( This thread http://forum.xda-developers.com/zenfone2/general/guide-to-apply-ota-bootloop-rooted-zf2-t3127835. The phone booted up after the install and I was able to go through the setup. The phone suddenly froze though and I restarted. It gets past the Asus logo and then is stuck at a black screen with the green led blinking. What do I do from here? Is the phone just dead now? Is there a possibility of saving it?
More info- Before downloading the preroot I did try to factory reset from recovery. I was still stuck with bootloop. If anyone can help me I would really appreciate it a lot.

Stuck in a bootloop

I flashed official lg 6.0 software on my g3(without rooting) and after a month of normal use I got stuck in a bootloop. I can't go into safe mode, but can get into download mode. Is there any way that I can keep all my data and flash the same firmware again?
esadc said:
I flashed official lg 6.0 software on my g3(without rooting) and after a month of normal use I got stuck in a bootloop. I can't go into safe mode, but can get into download mode. Is there any way that I can keep all my data and flash the same firmware again?
Click to expand...
Click to collapse
Flash phone with lg up...you can flash the same firmware you had or any update version....in lg up choose upgrade it will not touch your data...but there is a problem how long i remember your phone have to be fully booted to connect with lg up...
Anik49 said:
Flash phone with lg up...you can flash the same firmware you had or any update version....in lg up choose upgrade it will not touch your data...but there is a problem how long i remember your phone have to be fully booted to connect with lg up...
Click to expand...
Click to collapse
I flashed my phone and it is still stuck in that bootloop
Same problem here. Got a new G3 from LG and back to the same point after 24h : bootloop again and again ! I really think there is a software issue with that phone.
fredzeone said:
Same problem here. Got a new G3 from LG and back to the same point after 24h : bootloop again and again ! I really think there is a software issue with that phone.
Click to expand...
Click to collapse
I had to hard rest it and now it works normally, you just need to hold the power button and volume down button until you see the lg screen. Then let it go and press it again until you see recovery mode where you can wipe your phone and it will work just fine.
esadc said:
I flashed my phone and it is still stuck in that bootloop
Click to expand...
Click to collapse
Then you have to choose refubris in lg up ..also use differen version of software for example if you have v30b then use v30c .....but you loose all your data.
---------- Post added at 07:33 PM ---------- Previous post was at 07:31 PM ----------
do a factory reset also work

H815 Died After Successfully Flashing Stock Firmware

Hey Guys, I have a problem with my h815. It is refurbished and I tried to flash other stock firmware it competed to 100% and the phone died ( i flash it with LGflashtool2014). I tried QPST flashtool it flashed something and error 1006 appeared and when I wait it a little the LED starts blinking, but the error was still there. So I decided to use the SD card method and finaly I entered in download mode.... I tried over 10 firmwares for H815, but with no success..... lg up stops at prepareafterdownload etc., lgflashtol2014 stops at 9% too... I havent eject the sd card while flashing the firmwares. Please help
---------- Post added at 11:10 AM ---------- Previous post was at 10:53 AM ----------
@TheMadScientist Bro, Can you help ?

Categories

Resources