Hi can someone identify what kind of connector the antenna uses?
It broke off with the cable need to replace a new one.
If you can give exact model, it would be much appreciated.
attached with picture of board
Related
Hi guys, I am looking to replace the flex ribbon cable on a Galaxy Nexus i9250 and would like to know the following:
1. Does the cable revision have to be identical to the one that you have currently?
2. Does anything need to be soldered (like the mic) or attached that requires extra tools?
http://cellphone-repair-shop.com/samsung-galaxy-nexus-global-micro-usb-charge-port-pcb/
Thank you in advance.
Hi guys.
my usb pot in i9250 is broken end i need to replaced. any one have a god guide how to do it? thank you.
He guys new to the forum, have a question for some help, I'm going to add an external USB port, because that part of my mother board is shot from some previous shotty solder work from someone, anyways, I'm trying to figure out where to solder the 5 wires, the pads from the old port are crap, trying to find somewhere else to solder wires, any help would be appreciated.
Hi i replace the screen of my i747 and when i pull out the antenna from the connector, the whole connector has removed!!! :crying:
theres is any way to fix it? or something???
So I was replacing the two external antenna/test points on my SGH-T999 and did not have my air temp correct which caused me to remove the solder pads along with the connector . If you look at the linked drawing on pg 4, the offset pad attaches to a via that connects it to the other side of the board. I need to find that point for both the connectors. So does anyone know where to get a copy of the schematics AND the pcb assembly dwg? Or does anyone already know where this point is? I'd be greatly appreciated.
Thanks!
While replacing my screen I accidentally damaged the ribbon connector on the Charging Board. Help needed getting another board or ideas on how to fix is appreciated. Thanks