Broken antenna connector - AT&T, Rogers, Bell, Telus Samsung Galaxy S III

Hi i replace the screen of my i747 and when i pull out the antenna from the connector, the whole connector has removed!!! :crying:
theres is any way to fix it? or something???

Related

[Q] [hardware] what kind of connector is the antenna?

Hi can someone identify what kind of connector the antenna uses?
It broke off with the cable need to replace a new one.
If you can give exact model, it would be much appreciated.
attached with picture of board

[Q] Destroyed solder pads doing antenna connector rework

So I was replacing the two external antenna/test points on my SGH-T999 and did not have my air temp correct which caused me to remove the solder pads along with the connector . If you look at the linked drawing on pg 4, the offset pad attaches to a via that connects it to the other side of the board. I need to find that point for both the connectors. So does anyone know where to get a copy of the schematics AND the pcb assembly dwg? Or does anyone already know where this point is? I'd be greatly appreciated.
Thanks!

[Q] Need N7 2013 LTE USB Charging Board (P/N 60NK0090-SU1030)

While replacing my screen I accidentally damaged the ribbon connector on the Charging Board. Help needed getting another board or ideas on how to fix is appreciated. Thanks

Xperia m board - antenna connectors - socket/connector broken - How to fix?

Hi,
the socket and the connector are broken, well I damaged them,
How ca I fix it?
Can I soldering the cable direkt on the whole socket or only to the small pin in the center of the socket?
Waiting for yor help?
Just get a new ANT board for approx USD10.00

Replaced USB port, now no sound from speaker?

Hey guys,
I recently replaced the usb port on my LG G3, and while re-flowing the port i knocked off one of the resistor banks and re-flowed the IC directly below the usb port.
has anybody got a high res image of that area of the board so that I can ascertain if I am missing any of the components?
i think i am missing one of the 0102 resistors from the back.
Cheers .
found the schematic.
http://forum.xda-developers.com/lg-g3/general/lg-g3-d855-service-manual-t2890900
discovered that the flux that i used to de-solder the usb connector and gummed up the springs contacts for the speaker , so i dropped the board in some alcohol to remove what i could and added a bit of solder to the speaker terminals to give it a bit of height.
works like a charm now.. i can stop looking for a new phone.

Categories

Resources