hey guys, i recently bought a gs3 lcd + digitizer on ebay, and when i got it, i installed it right away. After installing it, i turned on the phone the digitizer displayed the boot up, but i noticed that it the boot took wayyy longer than before and after it booted it displayed the lock screen, but then my problem is that the touch doesnt work, the back button works but no touch response at all. help???
Related
Hi,
I recently flashed to JB and everything was working fine, I then wanted to lower the lcd density, so I downloaded lcd density modder and set it to 200 and rebooted the phone, only to have it stuck on a glowing black screen.. meaning it wasn't that the screen was off, it was on, but it was just black.. not responsive (it was plugged in as well into a wallcharger) I tried the same thing again, and while waiting for it to reboot, passed out and fell asleep. woke up in the morning to find it on that same screen, so went into recovery and rebooted the device, only to have a VERY sensitive power button.. even when im not pressing on it and am pressing above the button on the side of the phone it reacts.. it's very annoying and inconvenient..
I have a SGH t989d with Telus. I was running CM10 4.1.1 alpha1a with Darkside 6.0
I've tried recovering to before this issue and it still exists, I tried reflashing everything from scratch and it still exists, and I even tried to open up my phone and see if there was anything that was stuck there, and nothing..
any help would be greatly appreciated
Hi Guys,
Recently my screen has not been working properly. On the CM10 Nightly I was using, the screen would not display the right image, and would be slightly fuzzy. Other times, the screen would not turn on but the soft buttons at the bottom of the screen would still be working.
The solution that came to my mind was to flash back to Android Revolution HD, which had worked perfectly for me in the past. The screen fuzziness has been fixed, but unfortunately the screen no longer turns on. My phone has decided to randomly work again, but later the screen will stop working again.
Any help would be greatly appreciated.
Thanks,
DarkyHero
Hi all,
Today i recieved my 4th display for my one x.
The first one cracked, the second and third display were DOA (Dead spots in digitizer).
I took out the old screen and placed the new one.
Tested the phone before assembling again, and it worked perfectly fine.
Assembled the phone, and the screen didnt turn on, the button lights did though.
Disassembled the phone and it worked.
After assembling another time i couldn't get it to work at all anymore.
When i press my power button, the button lights go on but the screen stays black (it's not only the backlight).
The previous screen doesn't work anymore either.
It's not the connection, and the mainbord looks perfectly fine.
Rebooting the phone doesn't give me a solution either.
Is there anyone who had this problem before / Knows what it could be and how to fix it?
Thanks in advantage!
Hi, got a new screen, new power and capacitive button flex cables for my friends note 2. Turned on the device and verified new screen is working before taping the screen. Now I turn on the phone, but nothing shows on screen, however its recognizing my touches.. Checked all connections, all good. Any help appreciated. Thanks!
i have problem with my phone its touch hangs alot but when i lock the phone after relocking it works fine but after some time same problem.the other problem is that its touch is not working between middle.