unit: o2 XDA IIs(htc blue angel)
device information:
rom version: 1.40.00 WWE
radio version: 1.12.00
protocol version: 1337.42
extrom version: none
history:
just revived this unit using sd rom backup after a bad flash.
after sd flashing the rom boots perfectly. smooth screen alignment.set time etc.
didn't get any problem with that.
but it appears to have errors:
*saved data error is corrupted - will erase all the data to fix this problem
* default o2 apps didn't install automatically
problem:
the system freezes after going idle. touch will not respond buttons as well unless i performed a soft reset to get my IIs back to business.
tried flashing it with wm6 after the update, hard reset no,yes yes booting option. but the rom didn't boot, am stucked in white screen. tried to reset but gives me the bootloader mode screen. good thing i still have sd rom backup.
what seems to be the problem.,
is it a hardware problem?
any fix for this.
thanks. email me at [email protected] or reply on this thread
Related
I have just had a pleasant email from O2 talking about the problems of the latest ROM crashing the XDA IIs.
ROM version: 1.31.00 WWE
ROM date: 12/13/04
Radio Version: 1.06.00
Protocol version: 1337.38
ExtRom version: 1.31.139 WWE
Sorry if I am not the first person to report this, but this is what they say:
We believe the problem to be a memory leak were by programs are not releasing system thus meaning other programs do not have enough available memory to run on thus resulting in the device freezing. We are working with Microsoft and HTC to resolve the problem and should have a permanent solution soon. However in the mean time we have found that removing the active menu stabilizes the device so below are the instructions on how to do this.
Please be aware that the fix involves a hard reset which will wipe all data from the device, using backup/restore will reinstate the bug so we recommend that you use active sync to sync all data with outlook instead. Hard reset the device (hold the power button and press the reset button (with the stylus). Follow the onscreen instructions until you have set the time zone. After 2 - 3 minutes of installation you will be prompted to select a mode (personal or corporate) Please select corporate and enter the code 0506 with the numbers that appear at the bottom of the box. Tap finish and the device will state that the active user interface will not be installed. This is now the corporate mode and will not show the o2 branded software.
Hi
I've been running my Jasjar for a while now with no problems until a few days ago. Then I thought I'd flash the ROM to the latest version from the iMate website, also unlock it using Buzz Lightyear's unlocking solution.
Unlocking and then flashing the ROM appeared to go smoothly and, once I'd downloaded the latest Activesync (4.1.0, build 4841), I was once again able to connect to the Jasjar and everything was hunky dory once more - until I tried to reinstall some programs...
Basically, when I try to install Tomtom navigator, also some other programs I use for work (including SQL CE from the MS website) the install appears to start OK but then - depending on the program - it either crashes and wants to report a problem to M$, or it just vanishes from the PC screen. However some other programs, such as M$' remote display control, install OK!!
So, I tried it from my laptop - exactly the same result!
I've tried trawling through the registry on my PC and deleting any suspect entries, but this has made no difference.
All the above programs that are failing to install were running fine before the ROM update.
Current settings info, after the ROM update, is:
Rom version: 1.30.76 WWE (02/20/06)
Radio version: 1.09.00
Protocol version: 42.42.P8
HELP!
Hi Guys/Gals
Before I return my device for warranty repair I thought I'd check out if anyone else has had this problem, and whether there is a simple fix.
My device has been running flawlessly (well almost) since I installed the latest Qtek ROM up until the following episode:
I sync with 2 PC's and noticed a couple of days ago that when syncing with one of these, the sync went on all day. I therefore 'soft reset' the device as this normally solves these sort of problems but the device failed to reboot.
After numerous 'soft resets' without success, I tried a hard reset, which gave me the 'push 0 to reset... x to exit' options and I slected 0 to hard reset. Still no reboot/response from the device. Then I tried the 'x to exit' option... nothing.
Removed SD Card/SIM and tried all the above again...and again... and again, all to no effect the device appeared dead other than for giving me the 'push 0 to reset... x to exit' options. No charging light etc.
So I tried to 'reflash'. The device successfully enters 'bootloader' (USB mode) and when I run the MauUpgradeNOID I get the message that my device is about to be upgraded to etc etc, then get the 'updating radio' progress bar as normal with the device screen also indicating that the 'radio stack is being upgraded...please wait' screen. As expected the software kicks me out with 'country ID error'. If I persevere and rerun the software I get back to the 'upgrading radio' bit and then it just sits there... for hours...
My device has (had) the latest Qtek ROM, with unlocked ExtendedROM where I installed just Wisbar and PhoneAlarm. Most of my other software running from SD Card.
I am completely frustrated!!! Can anybody help, or do you think this is a 'warranty' return issue?
ROM version: 1.30.77 WWE QTEK
ROM date: 02/20/06
Radio version: 1.09.00
Protocol version: 42.42.P8
i have been lookin' around to find help to unlock my tytn. Unfortunately everything i have done with the instructions found here were not helpful!
i do have a HTC Tytn with the following version:
ROM version: 1.18.260.2
ROM date: 07/22/06
Radio version: 1.03.03.10
Protocol version: 32.34.7010.01H
ExtROM version: 1.18.260.105
Model: HERM200
IMEI: 357719006002855
I’m using a XP Home Edition, 2002 version, and for some reason the HTC_Hermes_SIM_CID_Unlock_v3a does not start automatically.
I’ve tried already the manual steps and on the tri-colour screen appears 1.09.ds (which i guess is the bootloader) and if i connect the phone to the pc by the USB cable does nothing! Then i must reset, so that it can start up and i'm able to run the RUU_Hermes.... and appears an error (200): invalid update tool. Although the error is different from the one u mention on the forum i ignore and carry on with the process.
i run Herm_Unlock, click unlock and check both boxes to unlock (sim/cid) wait and seen the success message.
i soft reset or turn off and turn on with a diferent sim card (from another company) and appears a new message saying "u have tried 13 times, plz wait until the waiting time will be exceed..." (did I exceed the number of time permitted?) and from there, there is nothing i can do!!! Neither put the code: 22051978 as u mentioned in ur forum because the OK button is unavailable!!!!
I’ve tried many times and the last one has yesterday at around 11am until this morning nothing happen. This message does stills there!!!!!!!
i am sorry for been so long but i really need ur very usefullll helppppppp.
thankssssss so much!!!!!!!!!!!!!!!!!!!!
waiting for ur replay!!!!
chears,
MESO-HTC
hi all. A friend of mine gave me an S100, and after i played for a few days with it, i decided to update it's rom. A "country error" problem appeared,cause i have the greek version, so i ran MaUpgradeUt_noID.exe which completed (as showed 100% process). My (new) problem is that i cannot update anymore. Every time i enter boot menu, i ran the upgrade
(HTCMAG_ROM_WWE_O2.rar) following all the steps normally. When the device resets (so the upgrade is going to start), it's re-reseting again and showing ERROR 101 connection error. Any ideas?
Qtek Greek version
R 1.12.00
G 1337.42
D 1.12.00 WWE
P.S. apart the problem everything is function properly