Please help.....
I installed Schaps 3.6a Rom on HTC8525 (TyTn), been working for a week... Today I got a white screen... No icons.... I did a soft boot and hard boot and also removed the battery... when turned on just a white screen shows..
Any ideas?
Ah thought the screen of death was gone but i guess its back. by chance what version of hard SPL do you have if you have anything lower than SPLv7 upgrade as some thought this to be the case some thought that roms that had been ran through Taz's tools to cause this issue,.
austinsnyc said:
Ah thought the screen of death was gone but i guess its back. by chance what version of hard SPL do you have if you have anything lower than SPLv7 upgrade as some thought this to be the case some thought that roms that had been ran through Taz's tools to cause this issue,.
Click to expand...
Click to collapse
Thank you for your response. Please forgive my ignorance... I tried to locate the SPLv version on my HTC8525 but failed. i would not know where to look except to try to hard boot by pressing the two side buttons and getting the multi color screen. Is there a fix that you know of for the white screen? Do you recommend I change ROM and downgrade radio?
Again... Thank you for your help.
This white screen syndrome is intermittent and the phone goes back to normal after 45 minutes or if an incoming call is received... Strange... still I have not figured it out... Please help if you can...
Hey.. kan anybody help me?. My P3300 goes black several times a day?? i have flashed it back to its original ROM to check if that would help, but i didn´t.
The phone just goes black and i cant turn it on again without soft-resetting it. Sometimes the screen flicker and some stribes are showing across the screen before it turnes black??
I hope you can help me
Best regards Michael
i had the same problem, i send it to repair by t-mobile and they changed the lcd screen problem fixed
Seems to be a common problem, as I have exactly the same with my P3300. Send and email to the HTC customer support to ask if it could be a software issue (no reply yet) - but now that I read this post I guess I can send my device for repair right away...
I don't think the LCD is to blame for this issue. (why would the phone firmware "crash" - and unable to reboot ? )
@MicTh : those updates you've installed ? were they recent Mobile6 (B&B > 4.1, Vanilla 2.0,.. ?) from this board ?
I've got the same problem, T-Mobile replaced my handset twice (new IMEI) - reason "motherboard replaced" ???
I DO believe that USPL unlock is causing this problem now - too many MDA 3c's failing - while HTC 3000 / Orbits seem to run fine.
No.. I run the original WM6 ROM
No.. I run the original WM6 ROM, and I have also switched back to the one it came with, but i does not help
I'm getting this problem too... screen fades to black, and only way to re-start is to soft-reset. I have had two new motherboards in my original, and now HTC have replaced with a new unit, with factory WM6 and problem is the same. I was wondering if it was anything to do with software, as i do have a number of applications installed - but which one is to blame?
After I removed Spb Time, my P3300 works fine (for a week now)
pnyg
do I have sbp time? (is it "standard" or 3rd party s/w?) if I do, how do I remove it?
no, I've not got spb time, so its not that in my case....
I also experienced this problem when I installed Meschle 3.01 ROM. Cant remember if its vanilla or full version as I installed both.
I am now back to Original WM6 WWE from HTC. No problem at the moment.
first hang-up end with black scream
I have the same problem..I think
started with WM5 ..but even with WM6 is the same!
Problem description:
first of all app is hanging (ones a week)
first time rest ,its trying to start windows but will hang-up by start-up windows
second rest hangs on white scream (with WM version number)
further resetting doesn't help
white scream changes to black (some times in columns) and them totally black
some time the black scream is flashing
can any one help me?
i don’t know what to tray anymore? I think is some Hardware issue?
hang-up and later ended with black scream
I have the same problem..I think
started with WM5 ..but even with WM6 is the same!
Problem description:
first of all app is hanging (ones a week)
first time rest ,its trying to start windows but will hang-up by start-up windows
second rest hangs on white scream (with WM version number)
further resetting doesn't help
white scream changes to black (some times in columns) and them totally black
some time the black scream is flashing
can any one help me?
i don’t know what to tray anymore? I think is some Hardware issue?
I've had at least 3 separate P3300s with this problem. I'm sure its a hardware issue, and I have finally persuaded my supplier to refund 75% of my purchase price, so I can buy something different. I am sure HTC must know this is a problem, but the uk repair centre seem unable to fix it, presumably as its a batch problem, and all the boards they have are faulty.
i have exactly the same problem with my Dopod M70 (Artemis300). Maybe it have some problem in the motherboard design which HTC should let us know
My orbit do the same, when it boot win everythink is working fine. Someone did say: When you apply pressure, it fade to black. I think it maybe have something with the housing design or battery.
keckek said:
i have exactly the same problem with my Dopod M70 (Artemis300). Maybe it have some problem in the motherboard design which HTC should let us know
Click to expand...
Click to collapse
I think i solve my own problem, after hours, i found out when we press in the back phone, near the display cable position, the screen become black and hang immediatetly. so i try to open back cover, remove cable and motherboard. Use alcohol to clean the contact display cable then put its together. Tighten motherboard, and wow, my Dopod M700 are back to life again, now how hard i press, everything stay fine. No strange behavitor for 5 days. GREAT!!!
Hope everyone think my experience useful
Sounds great but...
Hey.. sounds great.. but i´m affraid to take mine appart.. i think it is very difficult to take the cover appart without ruin it
MicTh said:
Hey.. sounds great.. but i´m affraid to take mine appart.. i think it is very difficult to take the cover appart without ruin it
Click to expand...
Click to collapse
No it is easy(much easier than TyTN) to open Orbit/P3300, you have intructions in the wiki. First you check if you have right tools...
igord said:
My orbit do the same, when it boot win everythink is working fine. Someone did say: When you apply pressure, it fade to black. I think it maybe have something with the housing design or battery.
Click to expand...
Click to collapse
That's probably me from this post?
http://forum.xda-developers.com/showthread.php?t=290414
I find that if you apply pressure on the outside casing at approximately where the simcard would be it switches itself off....
Yes it's your post. I have same problem. My orbit is working fine all day, but it is on the desk, didn't touch it. I bought P3300 housing, so I will change it, maybe it fix a problem.
hello to all,
I've searched many white screen problem threads, but didn't find any similar.
i am sorry if I missed one.
I am asking you for help.
I have spv m3100(hermes 100)
I bought it used and it had instaled htc europe wm6 rom. after few days I decided to flash black x rc.
before i did this, I made super cid with RUU_HERM_Unlock_v3a.exe and than also flash hard spl v7. everything was fine until few days ago when butons stop working. and at the end the green led was blinking all the time and green and red phone light was on all the time as well (also if phone was in flight mode).
I decided to flash official rom and I checked my bootloader it was showing ipl 1.04 and hard spl 2.10.
I flashed WWE 3.54.255.3 with radio 1.48.00.10 and everything went just fine at the end was written congratulation....
it costumized and make one or two soft reset and than I start to instal my favorite programs (few spb, smartmovie, dictionary...).
I do not remember why but after I set regional settings I did not soft reset with stylus but I put out battery when phone was stil on.
after that screen is white all the time. I made many soft resets, hard resets, try to enter bootloader but screen is all the time white.
when i turn it on and it is white I connect it to computer and it connects normal and i can also explore my files, but screen is all the time white.
I left it more than 20min without battery and try again but is stil the same.
after that I keep battery out of phone and leave it sop over the night. in the morning was stil the same.
i do not know what to do.
please help.
thank you and best regards
miha
since you mention a problem with the buttons, it *could* be hardware related. There is a thread up here where those problems (connections usually) are explained.
would you be so kind and tell me which thread you meant.
it seemed nothing wrong is with my phone only colors are missing (everything is white). i think also touchscreen is working. if I turn it off with power button (holding for few seconds), it beeps and you get message if you realy want to turn it off. because I know exactly where yes button is, the phone goes off.
I apreciate every help I can get.
thanks
I had a white screen issue .. do this in this specific order
1) make sure you have olipro latest version (use the search)
if problem persists
2) Use an WM5 rom and see if the white screen is happening
if problem perisists
3) Replace the battery (cheapest option)
if problem perisists
4) Its a hardware fault and you will have to send it off to get fixed or replace the unit .. sorry
alive again
I solved the problem.
thanks to this thread
http://forum.xda-developers.com/showthread.php?p=1698828#post1698828
and this instructions http://inuchanbt.blog54.fc2.com/blog-entry-100.html.
thanks to people who answer my problem
Medon
I have the same problem, the link to the blog below takes you to How to disassemble your device.... could you find the correct link & repost pretty please?
Thanks,
Andy
I,ll be using my diamond for 2 weeks until a day I tap the screen and I noted that everytime I tap the screen open the start menu program...always!no matter what I do or tap anywhere on the screen always do the same thing open the start menu and I have to move manually everything by the wheel... so I do a hard reset!! Now I try to align the screen more than 50 times with the finger and with the stylus and nothing work!so if anybody can help me with this problem before I send to the HTC servicing......I appreciate that,thanks [/B]
p.s I upload 2 pic for idea!
having the same problem tried almost a hundred times to align the screen but doesnt wrk at all
HOPE IF SOME1 CAN HELP!!!!!!!!!
if you hard reset and it still doesnt work, then its most likely a hardware fault.
2 ppl having this same weird prob...!! anyways like loomx said.. should be a hardware fault//
I had same problem also with screen alignment.
I had been using the phone all day without problem.
After I had been using the Diamond for Wired Internet connection I noticed the touch screen was not working properly.
I tried hard reset which made it worse! Tried to calibrate but it would not at all.
After the hard reset I did a soft reset, and had to use the cursor button to navigate to the system menu so I could get to the screen alignment program.
Eventually I regained control of the screen after doing a calibration of screen.
I have been using BSB WM 6.5Q. Is there some bug in this verion WM6.5 ??
What version were you other people using when this happened?
try this it worked for me
i had a similar problem with my diamond not as serious as yours but i ran mtty with the task 28 55aa comand reinstalled the rom and everything back to normal this may help. worth a try there is a tutorial on mtty called
THE DEFFINATIVE MTTY THREAD its very well written and easy to follow
Could you please explain in more detail how to do the mtty thing? I'm afraid I havent used that before and I have the same issue!
follow the tutorial in this thread its a brilliant guide and it sorted mine a treat http://forum.xda-developers.com/showthread.php?t=540290
Hey guys... when i flash any rom i am getting stuck on the align screen. It tells me to tap the target and so on... when i do it the cross (target) appeard again at the beginning on and on. Can't do anything with it... please help! sorry if this thread has been solved somewhere else... i couldn't find it via search.
Sounds like you might have a bad digitiser. Did you flash because the touchscreen was a problem?
If it wasn't, try flashing a different rom and see if that helps. Otherwise you might need to replace the LCD and digitiser - the digitiser is a thin sheet that fits over the LCD, it registers the touch of the stylus so the Hermes knows where its been touched... If it goes, it usually opens the start menu no matter where you touched the screen.
Good luck in fixing this.
well as you said... i was trying to flash the rom because of this problem (that you have described). I was just curious because the screen aligning was working and it recognized when i touched the target in the center of the cross. So if there's no other way how to get through this problem. I'll do it. Thanks a lot!