P3300 rom doesn't install - P3300, MDA Compact III General

Hello, i have a new P3300. The first time i opened it it started installing some basic stuff/programs and then worked quite good. Then i turned it off and when i turned it on again it shows the first splash screen with the htc logo, shows IPL and SPL versions on the left top side (like it should do) and then it instantly turns off. I have tried installing the official WM6 ROM again and again but after the installation finishes the problem remains. Also, when in confirmation dialog for the ROM to be installed or not when it shows the old and the new version, the old is completely blanc.
P.S.: Something else, when i connect it to charger (or USB cable) the orange light keeps going on and off about every 30 seconds.
Any help would be highly appreciated guys.

Send it back to your vendor for warranty...
Cheers

After many tries i managed to install some older official ROM but again after the initial screen calibration and the other stuff some customizations started installing and when PDA rebooted the problem appeared again. But tomorrow I'm getting it to service (and getting my Qtek 8310 back which by the way got a repair although unlocked ).

Related

Any last words?

Alright, forum friends. On Friday I flashed Anryl Beta 3 using sspl on my sd card. During the day on Friday and Saturday, my phone would occasionally freeze up forcing a soft reset. When I reset the phone, it forced me back through the initial setup (tap screen to configure, setup time zone and email, etc.), essentially forcing a hard reset. Now my phone is stuck at the 1st splash screen and won't finish booting up. The green LED on the right side is lit (the GSM light) and it just hangs there. A soft reset sends it back to the same spot. A hard reset has done the same.
I tried to flash a new rom using the bootloader but the HERMIMG.nbh won't take - it says "Loading..." across the top of the screen then flashes 00068002, then goes back to the red, green, blue and white bootloader screen. Does anyone have any ideas for rescuing my poor phone? I'm up for anything now!
Flash your carrier original ROM, or VP3G or AT&T ROM and see if that helps!
I've tried to flash my original ROM (both the first one that came on the phone and the WM6 release from ATT) but I can't run them from my PC since I can't get an activesync connection. I tried to download the nbhextract file from the forums here and it says that the file is corrupt. I've tried flashing other roms to my device (using my SD card and the .nbh image) and keep getting the same result.
If it helps, here's my info from bootloader: HERM100, IPL-1.04, SPL-2.03.
By the way, I just moved back to my old Ericsson P800 and am dying to get back to my HTC!
So I downloaded the update from HTC's website (the original 6.0 ROM from AT&T) and am pushing that over now. I had to turn off the USB on activesync to get it to connect but everything seems to be going just fine now. Thank you all for all of your help. Hopefully this will be the last post on this thread.

Device unresponsive no matter what rom?

HI all,
I'm having some fun and games with my Orbit today.
I previously had an old version of black & Blue on there. SO today decided to update to have a go with some manilla based ROMS.
First I Tried YuE_v11.3_3.15.20755_Lite_M2D_WWE
Which seemed to work ok but after a while applications were being very slow.
So then I tried to reflash oop, but that seemed to fail.
I Tried to flash love, but it wasn't ever getting to the progress indicator on flashing, so did an SD flash of YuE which worked.
So then tried to flash Love from that minimal YUE and the device is being really slow, like gets to the calibration and takes about 5 mins to swap between screens.
What's the best way to totally clear down the rom and start again on this?
Thanks
I've now flashed the Official UK O2 WM6 ROM and still having problems. Flashed succesfully, but when it boots up, it just sits on the "Windows Mobile" screen and beeps a bit
Current State after O2 flash :
IPL : 3.04.0001
SPL : 3.04.0000
GSM : 03.06.90
OS 3.4.0.0
Any help gratefully appreciated.
Thanks
Hard reset the device, and while you're in the config wizard, plug in your device and flash to new rom. That way it's completely formatted and you'll have a fresh new install... hope it works mate
I did a hard reset, still no joy, hangs on the welcome to windows screen
I can access the Bootloader, but can't find a way to flash a rom from there, all seem to want it done once you've made an activesync connetion
flash YUE back via SD card flashing
I already tried that, flashes fine, but becomes unresponsive soon after
have tried flashing O2 WM5 + WM6 from SD, but still no joy.
It just flashes, loads up WM(5/6) then hangs there, beeping sometimes. Pressing the green button brings up the calibration screen. I sometimes see bits of apps, today screen, but that's about it, it's generally unresponsive.
Any suggestions?
ta
A little update incase someone can help?
I left the battery out of the phone all night last night, and this morning the phone worked great.. for about 2 hours, then it froze. I hard reset, and it's back to freezing after OS loading now
What's up if you remove your MicroSD card ?
That makes no diff, i've tried flashing with + without the SD card (it's currently out), flashing from windows + flashing from microSD, all ends up the same way, with an unresponsive device once the OS boots.

P525 - Upgraded to WM6.1 and BRICKED?!

Dear all,
I need help in repairing my Asus p525. I was trying to flash it to WM 6.1, but suddenly update failed. After that i started getting asus Blue Screen, and nothing more. I cannot hard reset, neither turn on the PDA. When I take out the battery, I can, by pressing CAM REC JOY and SOFT RESET button to get to USB loader.
I used USB loader and reinstalled my ROM and Boot Loader to Official Release of Asus. But this didnt help and I still get only Blue Screen, and after that nothing - unless I take out my battery for a while and return it.
Can anyone help me with this problem ?!
Greetings
New thing
Last night I took my battery out of the phone. Today I dont even have ASUS BLue Screen, but still i can, while holding the buttons, on reset (inserting the battery) to go into FORCE MODE.
Anyone know what to do ??
Today I reflashed with new roms, but it just dont work.
Greetings
I realised now, that when I charge the battery FULL, the phone starts working ?! First i have problem to calibrate the screen, and later on the OS start to work, and everything seems fine ?! But it resets, block..... hardware thing ?

Load issue

FIXED NOW!
Need help.
I burned the new Kavana ROM. everything was working ok.
placed my microSD and the device didn't recognize it, so i rebooted.
upon reboot the device got stuck on the white HTC screen.
pulled battery
tried again, rebooted, past the HTC screen to the Windows Mobile welcome screen but freeze again. hard reboot didn't respond.
pulled battery, then turned back on. device didn't even turn on!
tried several times with/without battery hooked up to power , and with/without SIM and/or microSD (all possible combinations) and nothing.
had lunch
went back to it and the device magically booted it but after the white HTC screen i got a blue screen asking about error from last reboot. said yes to correct. rebooted went past white HTC and into Windows mobile welcome screen and froze again.
repeated the process several times and finally got to the blue screen again asking about error from last boot, this time said 'no' and device continued boot in a white screen without HTC logo and froze.
all hard reset attempts were unsuccessful (if i'm doing it right: hold two soft keys and then power button).
now the device boots to the white HTC screen and then is stuck.
what to do?
edit: got the hard reset to work and reconfigured my phone. i only noticed the black screen for a split second because my Dash has issue that it thinks that the green send button is being pressed all the time (anyone know how to fix that?).
Thanks
Find your original rom in sticky, go into bootloader and flash original rom, then flash to wm6.1.
have the same issue!!... did you fixed? the main problem is activesync is not running so how do i install another ROM?
Active sync doesnt have to be working aslong as u got ur s621 pluged in and u wait for a few seconds before starting the ROM it will work.

Device strange issue will not stop giving problems!

This is a list of events that I have gone through today. I received a new charger because the old one I had became defective & was charging my phone up & then it would go back down to 0% & then shut off & it would end up in a problem where the phone would not turn on unless I pulled out the battery while the AC was in & then it was able to charge but still it would turn on, on its own to drain the battery when off & this was very frustrating. The charger I have now works but the device acts strange over the last few months doing a task29 & flashing the first ROM after would make that ROM not work & then I had to flash a totally different ROM to make it work. I was using Android & it had died a few times & also I experienced the same thing I did when it would charge up & go back down to 0%. please read below:
I got my new charger today & at 62% of charge I decided to flash to a custom ROM via mem card again well the ROM was a success but when pulling battery out to restart it didnt want to work. So I went to flash again in bootloader by memory card it shut off on me in the middle & restarted into bootloader again & shut off again right away. I did a task29 it worked got it out of bootloader & now the orange led flashes off & on when its off & now ive gotten that to stop. What exactly is wrong with this device?
it was @ 73% and finally setup a ROM NRGY however it ended up shutting off on its self & going into a power boot loop constantly restarting until that ROM can no longer start & now its stuck on the boot screen w/ its info.
I flashed the stock SPL on USB now im going to try to flash the carriers ROM back.
Stock SPL = Successful!
2nd Touch Pro 2 ROM Version Flash = Successful!
Its working for now. Battery is @ 80%
AHH! After charging to 100% idk what it did but when I went into the other room to check out its all possessed.
I have a black screen w/ white text that says:
The device is unable to boot because either you have turned off the device incorrectly or tried to install an application from untrusted source.
Press Volume Up to reset your device or press any other button to cancel.
This operation will delete all your personal data and restore the device to its factory default settings.
IDK how this happened.
When I hit any key it didnt do anything it was stuck until I did a battery pull. Then I restarted the device it was stuck at the boot screen w/ its red info. It erased the entire ROM. Then I tried to do recover mode & it did nothing. I tried to flash the stock ROM again & no results & then again & still no results. I think its now not accepting the ROM at all since from: in the ROM update utility is blank.
Now it decides to get past the boot screen but then it malfunctions again & restarts itself & it tries to setup a 2nd time then after it does & its on sense home for a couple of mins it reboots twice & now its stuck on the boot screen again.
Things that I can think of.
- Isn't your batterie just broken? You will break your batteries when you deplete them completely. Maybe try a new batterie, because you said that you let it die for a few times. It could be that this is causing your problems.
- Did you flash true usb when you were in the bootloader? Give that a try, because I believe that the customruu performs some sort of checks. Maybe this is nonsens, but you can try it.
The battery was fully charged & it was working better than before.
I reflashed the Stock SPL to flash the carriers ROM back & that worked but at anytime it just rebooted for whatever reason to make it so the ROM was unusable at any time I would reboot it would decide to actually go past it seldom. I experienced that at one point oddly it went into setup n it did it again after a while its just acting strange.
If you're back to stock SPL and stock ROM, can't you just send it back for a warranty replacement ?
IDK how old it is. I bought it brand new from ebay.
Viper Matrix Wireless said:
IDK how old it is. I bought it brand new from ebay.
Click to expand...
Click to collapse
No warranty bro...
You can try but no warranty 9/10 times.
What ROM are you using? I used to have that issue with my betas.
It wld destroy itself after softreset and I would have to reflash.
Try to flash, turn off right after it boots, turn on and see how that works for ya.
Rep had told me I could get it replaced & they know I bought from ebay. But I havent called them on this yet.
It doesnt work. It usually doesnt go past the boot screen. Flashing does nothing to help it. Whenever it feels like it it may have to stay on for a few mins to go into setup but most of the time it will stay there & reboot, reboot, reboot, reboot each time its a different # of times & it will reset itself at anytime. Ive even had bootloader shut off on me & restart itself during flashing its a pain. I had another issue I didnt mention my device on any custom ROM when I had 0.85 olinex SPL the device would just freeze & not respond every time. Now this is a different situation. I am back of SPL 0.87 which is the default. I flashed the entire carrier ROM which 0.79 was rewritten w/ 0.87 & that was successful but its still rebooting & causing fatal problems including the black screen w/ white text.
UPDATE: I just walked into the kitchen. Somehow the device turned on by itself & now its sitting on the sense home screen. I know its not fixed but idk why it would turn itself on.
Moved as not ROM Development.
Try flashing task 29 1st... Might be because when you flash remnants of the older OS are still there causing trouble. Remember though, you need to have Hard SPLed it 1st....
I got so frustrated I just got done calling T-Mobile Tech Support & they are going to ship me a replacement.
ultramag69 said:
Try flashing task 29 1st... Might be because when you flash remnants of the older OS are still there causing trouble. Remember though, you need to have Hard SPLed it 1st....
Click to expand...
Click to collapse
I thought I would reply to you.
This is what started my problems is when I did a task 29 my device was acting funny afterwards. I did it again about a month later cuz I flashed way too much & it kept getting worse. But Task29 didnt help this time its what caused me to have to flash 2 different ROMs cuz the first one I flash after doesnt work.
I received the battery & it didnt do anything.
I'm still waiting on the replacement to come.

Categories

Resources