my screen is freeze, please help - P3300, MDA Compact III ROM Development

hi i am newb here, i just installed the wm6 rom to my phone dopod m700, after it has complete installed, a white screen say error device start up failed due to sudden loss of power. please click yes to continue and note do not remove battery before di=evice has been completely shutdown. i did clicked yes to continue, but the screen came back the same, please some one help, thank you

I'm having the same problem with WM6...any ideas? Sometimes it boots normally, sometimes it is just stucked ony the HTC Logo (i'm running Touch Full Version of meschle's)
And there are times that the 128MB Flash doesn't seem to be detected...

Related

P3300 rom doesn't install

Hello, i have a new P3300. The first time i opened it it started installing some basic stuff/programs and then worked quite good. Then i turned it off and when i turned it on again it shows the first splash screen with the htc logo, shows IPL and SPL versions on the left top side (like it should do) and then it instantly turns off. I have tried installing the official WM6 ROM again and again but after the installation finishes the problem remains. Also, when in confirmation dialog for the ROM to be installed or not when it shows the old and the new version, the old is completely blanc.
P.S.: Something else, when i connect it to charger (or USB cable) the orange light keeps going on and off about every 30 seconds.
Any help would be highly appreciated guys.
Send it back to your vendor for warranty...
Cheers
After many tries i managed to install some older official ROM but again after the initial screen calibration and the other stuff some customizations started installing and when PDA rebooted the problem appeared again. But tomorrow I'm getting it to service (and getting my Qtek 8310 back which by the way got a repair although unlocked ).

Miphone M88 problems,Help !!

Hello,
I have Miphone M88 (WM6.1 Eng)
i flash it whit Rom WM6.0, Now my phone work but now i have a white screen the phone looks like ok but nothing shows in the screen only a white screen what i can do ??
please help me i have a big problem
Thx
I thought that I remember reading somewhere that when you flash your phone it does take quite a while before it's complete, and that the screen does stay white for quite a long time.
Mike
No, I wait until he terminate flashing, and when he reboot it came with screen white,
have you one solution now!!
Thx
I'm sorry I don't, I'm yet to flash my m88.
have you tried taking the battery out and leaving it for 10 minutes, and then entering the boot loader screen again and trying to re-flash?
Mike
I've install ROM from this topic: http://forum.xda-developers.com/showthread.php?t=452848
and now, when I try power on my MiPhone - it show only white screen - please help!
can some help with this?
i have a clone m99 same thing as an m88 i guess the original rom img worked whe i flashed it when i downloaded the new 6.5 and tried flashing that all i did was stay at "downloading image please wait" and thats it. went to lift the phone up and the battery fell out not nothing works at all even with a fuly charged battery i cant even turn this stupid thing on. so im hoping anyone has any insight on what i could try and to to fix this.
p.s. i have left the beatery of for 30 mins and still nothing .....
help i got white screen too ;[ m88 after rom update only white screen and i cant do nothink ;[

i-mate jasjam stuck on tri-color screen

Hi,
P.S: I have read almost every post and thered and wiki and what ever, nothing worked for me, need advice.
My ppc is i-mate jasjam herm100
ipl-1.00
spl-1.04
it was running just fine, then out of the blue, it hang i reset the phone with the styles as I was unable to shut it down due to the hang, once restarted it is stuck on the tri-color screen.
tried to restore defaults, using the front 2 softkeys and the reset with the styles, then i confirmed the restore pressing the 'R' button it took 1 sec and told me it is restored, tried to restart the phone same tri-color screen, so I have been every where forums wiki post to solve this issue but was unable, I don't need to be WM6 or any thing I just need my phone working even if running WM3 "kidding" all what I want is the phone life and kicking again, if any one can help me here, it is appriciated alot.
Thank you.

[Q] i can't load bootloader on my HTC diamond

dear all,
please some help. i have already try to update ROM to WM6.5 on my HTC DIamond. But something happen during updating, the screen didn't show progress and anything. and suddently the screen on the computer said that updating ROM Fail. and my device cannot weak up since then.
Please help me weak up it.
Thanks, and i tried to effort to go inside bootloader by pressing volume down and red reset but nothing happen.

[Q] Cavalier got stuck

hey, i have been using htc s630 from last year.
few days later when i was making a call, the phone got stuck and hang in the incall position, when i removed battery and restarted it again, the phone got stuck welcome screen.
i have done the steps to flash it from pc but it doesn't work,
please help me ot to get my phone back..
umer92 said:
hey, i have been using htc s630 from last year.
few days later when i was making a call, the phone got stuck and hang in the incall position, when i removed battery and restarted it again, the phone got stuck welcome screen.
i have done the steps to flash it from pc but it doesn't work,
please help me ot to get my phone back..
Click to expand...
Click to collapse
use the method MTTY to fix it, after that reflas with official rom
hey, i have tried every thing for couple of weeks, but its not working for me, as when my cell phone restarts it stucks on the welcome screen, is there any way to delelete the operating system and install it again?
Sequence for recovery is (don't execute the next step if one gets your device back to life):
Soft Reset (Reboot) - this did not help obviously as you wrote.
Hard-Reset - mind that first boot will take much longer than usual, some minutes (up to 10 - depending on the device) will pass until the device is ready again. This is because all operator and init-specific things must be executed on the device with first boot. Be patient and do not interrupt - it must finish by itself. -You may just be stuck here!
Re-Flash the right shipped ROM - mind that the device can only receive the CID matching original ROM, not just any ROM (yet). You must do that while the device is waiting in bootloader mode, otherwise the RUU may not be able to access the device.
Gold-Card Flash a close-matching ROM (so one with same languages and the right device).
Please describe in detail what you did already and what were the results of your actions.
hey thankz, but i tried everything, all the steps you written above i them them all, nothing happened,, please help me,, my fon is stuck for couple of months.. it just shows the welcome screen, nothing else.. is there is a way that i can flash the operating system and reinstall it??
waiting..
bring the device to go into bootloader mode by Hold the camera button on the right side, press the power button. The phone will enter the " bootloader " mode and you 'll see the tricolor boot screen. after that reflash the device with shipped rom can you get at ftp://xda:[email protected]/Uploads/Smartphone/Cavalier/Shipped_Complete_Updates/Dopod/

Categories

Resources