I have a lenovo p2 the doesn't boot the phone's screen is fried but when i plug it in it shows a blinking red light but when i hold the power button it doesn't boot not, when i plug it in with the qualcomm drivers it doesnt show in the device manger i dont know what to do
Related
hi ppl
usb not recognize, not even the "unknow device" just like nothing conected. only logo "sonyericson" show. if use hot keys to flash mode or fastboot mode, the phone stay stuck in a blackscreen and a green light or blue light in the power button, depending what condition u start.
used flashtools, and pc companion tryin to fix, but not work if no usb is detected.
Is there any possibility to recover a dead Lenovo Vibe K5 Plus A6020a46? . It shows only red led when connected to a power source. Can't turn the power on, none of the key combinations works, no boot screen, no images nothing. It is totally dead except for the red LED. :crying:
Hello, help me pls
My LG H818P can't boot
I tried to enter download mode but i can't
After i pulled the battery, i pressed volume up and i connected usb cable, it appears a battery icon with a flashing red question mark
I also tried with the battery and usb cable and i get some red led blinks for few seconds
Soo I think I was high and accidentally flashed a kernel which I would say not recommended for this device and boom its hard bricked just the led blinks and turns off and starts charging,now I think the wrong kernel flash has burnt my motherboard a little with wrong voltages/clocks, the zip corrupted the device partition layout by flashing the kernel on the wrong partition maybe? then the phone cant boot so wherever I go for service nearby they open the device probably and see its burnt a little and return it back stating the same, I can connect my device to PC and its recognises it as either 900e or QBULK maybe nobody have an idea about edl flashing as its not popular yet so my question now is I'm planning to buy an edl cable from alixpress since everyone's saying the motherboards burnt but it shows completely fine on my PC and also perfectly charges up the device but just doesn't turn on so should I buy it and will edl save my ass or has my motherboard been damaged beyond repair.....?
This helped me,
1) Inititial state is: The phone is powered on and the white LED is on. The phone is not plugged into USB.
2) Hold power button for about ~7-10s until the LED turns off and keep holding power
3) The device will turn on again and shows ZUK Logo for a short time, keep holding the power button
4) You will see the white LED again and the display is black,
5) After ~5s (less time than in 2.), the white LED turns off again. As soon as this happens, release the power button and press and hold Volume Up for 5s
Your phone is now being turned off
I ) Press and hold Volume Up and Volume Down button
II ) Connect your phone to the computer with a type-c usb cable
III) Your Phone is now in fastboot mode (release the keys)
IV) Open terminal (cmd) and type : fastboot -i 0x2b4c oem reboot-edl
V) Now you can qpst firmware.
there are other solution posted, take a look at this
Ugh I think I mentioned my phone is hard bricked I can't access fastboot ,just the led blinks for a milisec and goes off display never turns on not even the logo.
I know about edl and stuff but my question is should I buy an edl cable its like 5$ on alixpress but people say my phone's motherboard is damaged and stuff yet it gets detected by PC, charges so should I buy it?
First of all I'm sorry if I posted in the wrong section
The problem of my phone is that it is apparently death. I don't know why, because I was using it normally and then after few minute, like 5, when I tried to use the phone it seems to be death. It won't turn on, even when a charger was plugged in. The phone just shows a white led blinking. I tried to turn it on and nothing happened. So I tried to power it whit the volume down button pressed and the fastboot mode appeared. It says battery low (charging) and if I try to choose one of the options nothing appear, just the white led blinking.
I don't know what to do, I would be happy al least I will recovery my internal data (with the app data) using the fastboot mode.
Sorry for my english, I'm begging help.
KurtCobain said:
First of all I'm sorry if I posted in the wrong section
The problem of my phone is that it is apparently death. I don't know why, because I was using it normally and then after few minute, like 5, when I tried to use the phone it seems to be death. It won't turn on, even when a charger was plugged in. The phone just shows a white led blinking. I tried to turn it on and nothing happened. So I tried to power it whit the volume down button pressed and the fastboot mode appeared. It says battery low (charging) and if I try to choose one of the options nothing appear, just the white led blinking.
I don't know what to do, I would be happy al least I will recovery my internal data (with the app data) using the fastboot mode.
Sorry for my english, I'm begging help.
Click to expand...
Click to collapse
Download this files in your computer https://mirrors.lolinet.com/firmwar...76-12-22-10/blankflash_OPNS27.76-12-22-10.zip
connect your cell phone and look for these Qualcomm HS-USB QDLoader 9008 drivers when your cell phone is recognized run the .bat file and with that revive
MirandaEduardo said:
[/url]
connect your cell phone and look for these Qualcomm HS-USB QDLoader 9008 drivers when your cell phone is recognized run the .bat file and with that revive
Click to expand...
Click to collapse
Just this morning I replaced the battery and the phone is back alive.
Btw thank you for the help!