Hey,
I don't have any charger, so I have been always charging my Artemis via USB.
A couple of days ago it stopped charging. It happened after I discharged it to a very low level.
When I plug in the USB cable, the amber (or the orange) LED starts to blink. I can see the icon that says that the cable (which is ok) is plugged in, but the battery level is dropping instead of increasing.
I've tried even hard reset.
I haven't tried with another battery, but I've tried to charge the battery with a charger made by myself. It was OK - PDA is working, but I can't still charge it normal way.
Any ideas?
Blinking amber
I have the same problem on my htc p3300, and when i used batti 2.4 i saw that the battery temperature is 432675.5 etc something fake temerature. This is the reason, why my pda unable to charge my battery. If you set your pda in bootloader mode, it will charge your battery!. After 3 or more times i charged it in bootloader mode somethimes the battery temp sensor works normally, and the charge is working as well. Sometimes not.
Bat you can charge your battery allways in bootloader mode.
Sorry for my English.
Try it!
Good luck!
So it's a temp sensor problem? I've had the same problem with my SPV 650 a few times. Hopefully it was never permanent!
hey
Do you know how fix this problem ? Is there problem with battery or with mainboard ? I change rom, radio, battery, charger.If bootloader mode is the best solution?
I wait for answer and your ideas
Hi.
I have Prophet with the same problem. It doesn't charge batt, doesn't turn on - clouds then white screen. And it has happened after deep discharge.
Trying "bootloader mode"
i have the same problem with my dopod p800w. the device work only when it pluged, even when the battery is full (in another device) the notification message appear and it turn off ! Anyone can help me ? Sorry for my English !
im suffering from this problem
any solution?
i am about to purchase a new battery however.. i dont think that would solve the problem..
how do you enter bootloader menu?
I'm hoping some of you wise heads on here might be able to help me out with a problem that has got me totally and utterly stumped!
Last week I was using my One X and noticed the battery was down to aorund 14%. I plugged it into a charger and nothing happened...no light...nothing. I tried various different chargers and cables to pc etc and nothing seemed to do anything.
After leaving the phone plugged into the mains for a few hours, I noticed that a very slow/long flashing red/amber light appeared. It kind of stays on for 5 seconds and then off for the same amount of time. I left the phone in this state for about 14 hours and when turning on it would say battery was somewhere between 0%, 1% and 2% and would promptly switch itself off.
I messed about for hours on end trying many different button combinations, sim in/out and came to this bizarre conclusion.........If I plug the phone into the mains for a few minutes, then press power and volume down to get to the HBOOT menu then hold power in again to reboot, the phone reboots into the OS and is functional. It still reads as having 0% or 1% battery and shows as not charging, but it must be getting some juice for it to be working. If I leave the phone in this state for a while I can then unhook it from the charger and use it as normal, even though battery is displaying as 0%. I can use the phone like this for some time, although the battery does not appear to last as long.
Also, the phone is not recognised at all by the PC when plug in via usb when in android os - nothing at all shows in device manager, but it is recognised from the fastboot menu and tries to install device drivers.
Has anybody got any clue if I can save my HOX or am I without a paddle?? Many thanks in advance
Hi,
it just stop and hang this morning, the screen hold at the moment it hang .... i tried hold the power key for >15 sec but not respond .... bluetooth no respond too ....
so what can i do? other then wait for the battery die out?
please help!
thanks!
Joseph
Josephzhu said:
Hi,
it just stop and hang this morning, the screen hold at the moment it hang .... i tried hold the power key for >15 sec but not respond .... bluetooth no respond too ....
so what can i do? other then wait for the battery die out?
please help!
thanks!
Joseph
Click to expand...
Click to collapse
I'm having the exact same issue, screen isn't responding and won't switch off, despite how long I hold in the power button.
Anyone got any suggestions?
Same here. Someone can help?
Ok, mine eventually died.
Whatever happened was draining the battery as the watch was warm the whole time (instead of my normal 2-3 days, it died in around 4-5 hours).
Plus point is that after plugging it in to charge, it switched back on and is currently working fine, it's sitting on my desk charging now. However am more than a little concerned about this happening again.
I've had same issue twice - first time when installing TWRP recovery (understandable ) and today having a lot of saves to watch creating a watch face. Both times reacting like,
st0nec01d said:
Whatever happened was draining the battery as the watch was warm the whole time (instead of my normal 2-3 days, it died in around 4-5 hours).
Plus point is that after plugging it in to charge, it switched back on and is currently working fine, it's sitting on my desk charging now. However am more than a little concerned about this happening again.
Click to expand...
Click to collapse
I think there is a memory leak in software.
I've had a major issue where the watch turns off local Bluetooth after getting hot. The only way to turn Bluetooth on again is to turn the watch off and then charge to 100%, last turn on again and then reconnect.
This started after the 5.0.1 Update.
Sent from my D5803 using XDA Free mobile app
The same issue
Hi!
I have the same issue. Sony SW 3 is connected to Sony Xperia Z Ultra. This issue is the second one, the first time I managed to reset SSW 3 by long pressing (about 10-20 seconds) the button on the watch.
I've got the same problem but screen is off. I cannot wake it (or turn it ON). I was charging it, it was turned off, after 30 mins of changing it vibrate, I unplugged it and now it seems dead. What can I do? t
Try long press the power button?
Powright said:
I've got the same problem but screen is off. I cannot wake it (or turn it ON). I was charging it, it was turned off, after 30 mins of changing it vibrate, I unplugged it and now it seems dead. What can I do? t
Click to expand...
Click to collapse
Calvin Gross said:
Try long press the power button?
Click to expand...
Click to collapse
yes i do. Probably solved the problem. I don't know why but, also if in charge, my watch reached 0% on battery, so it wasn't unable to load up. This morning tried to turn it on (yesterday it woke up for 2 sec, after it died, plugging in into charge was a waste of time) , and in the few second it turned on (in the bootlogo), i put it into charge. Now seems to work but that's quite strange because yesterday i put it on charge when it was about 10%
My SW3 hanged again this morning, i charge it overnight and when i unplugged the charger, it hanged.
as usually, nothing can reset the watch until it burn out the battery. it really annoying and i hope google or sony will fix this soon.
I had it happen once to me too, I wonder if there is some sort of memory leak or some other issue.
I have not been in the habit of powering off my watch but maybe a good idea?
I had the exact same issue was skipping through song then it froze waited 4hrs for battery to drainn
drain turned it back on and it said 0% battery so I reset it and it said 2% battery but every now and then it freezes and I have to reset it holding power for 15 sec also I notice more lag in lollipop and it did freeze on me not too long ago
The 5.0.1 Lollipop Wear update is a piece of sh!t. My Smartwatch3 was rock solid until it came along.
- Currently waiting for the battery to drain so it can come to life again...
Hi,
I have a OnePlus 3 with LineageOS 17.1 and TWRP installed for a few months now.
The power button stopped working some time ago but that wasn't a problem because I could start the device with volume down + power cable.
Today it powered itself off because the battery went low.
I put it on the charger and it charged.
After the battery was more than half full (little battery indicator on display) i disconnected the device, hold volume down and repluged the cable.
Nothing happend.
I put the device without pressing a button on the charger, nothing happend.
I know the usb port works, because my pc makes a sound when I connect the smarphone with the pc but nothing more happens.
Do you have any idea what else I can try?
Should I just charge it for 2 hours until the battery must be full or do I wait until the battery is empty?
I hope someone can help me,
Thiemo
I solved the problem with deconnecting the battery and connect it again.
Ok, so I think that my zuk has completely gone under.
This is what happened, My phone started to get random restarts and battery swelled, so naturally, I went to the service center & got a new og battery for zuk z2. After charging the new battery for around 2 hrs, I went on to wipe the phone since, I wanted new battery to gel with a new ROM. After wiping off everything, my phone goes completely blank. NO REACTION whatsoever.
This is what is happening to my phone:
1) No initial vibration.
2) No LED blinks whatsoever.
I've tried the following:
1) Pressed power button (& other combinations) for prolonged period time both with & without charger.
2) Left the phone for charging for like 6-8 hrs.
3) Left the phone as is for a day.
4) Disconnected the battery and everything & let the phone(in disconnected state) sit overnight.
5) Disconnected the battery and connected the phone directly to charger for 7 sec and then connected the battery again. (https://www.ifixit.com/Answers/View/288970/Phone+won't+accept+charge-turn+on)
6) Tried the Deep Flash Cable Mod.
Nothing is working and phone doesn't show any sign of being alive. Anybody who went through the same or give some new ideas to try?
My phone also randomly turned of with no signs of life. It does response to my pc though when I connect I hear a sound