Dear All.
My F180K brick becase I try to flash freegee. I unbrick it using flashing E975 KDZ files (E975K10D_00.kdz),
I cannot use F180K KDZ it show unpack error.
Now my F180K can boot into android but not found internal storage.
in storage menu it show only internal storage about 400Mb.
I try to factory reset via vol up + power menu same result.
any one can help me
Thanks a lot.
I successful recovery my phone.
flash E97120C_00.kdz then factory reset.
all my storage show
extrct erro
[Help] F180K KDZ brush 20i following situations occur:
Is how else ah? I drive installed. KDZ download is complete and correct, and how it has been said Compression error? Help ~ ~ ~ ~ ~ ~ ~ ~
[R & D Test Tools Log File]
22:31:16: Launching SW update
22:31:16: Unpacking KDZ
22:32:57: KDZ file extraced
22:32:57: Extract file error
22:32:59: === FINISHED ===
i cannot update via lg mobile support tool,becose phone says battry is low but i fully chaged the battrey
brick my lg f180k help me plz
[R&D Test Tools Log File]
20:04:42 : Launching SW update
20:04:42 : Unpacking KDZ
20:05:41 : KDZ file extraced
20:05:42 : Extract file error
20:05:44 : ===FINISHED===
i updated F180K20N_00.kdz via kdz updater but it cannot successes
then i tried lg support tool then it said lack off battery power ,but i fully charged
plz help me how to unbrick my phone
chamaraaa said:
[R&D Test Tools Log File]
20:04:42 : Launching SW update
20:04:42 : Unpacking KDZ
20:05:41 : KDZ file extraced
20:05:42 : Extract file error
20:05:44 : ===FINISHED===
i updated F180K20N_00.kdz via kdz updater but it cannot successes
then i tried lg support tool then it said lack off battery power ,but i fully charged
plz help me how to unbrick my phone
Click to expand...
Click to collapse
Did you try new flash tool in http://forum.xda-developers.com/showthread.php?t=2498102
Guide To Flash kitkat on Refurbed F180 and convert it into International Model E975.
Note: Use this method if you are facing issues like TOUCH not working after updating to KITKAT.
1. Flash F180 20T (JELLY BEAN) KDZ or any working KDZ
Skip Step 1 if u have working cell phone.
2. Now Root your Phone
Root Tool
3. Backup Modem of phone
Modem Backup Restore
4. Flash the following KDZ's Files according to your Phone model
F180S
F180K
F180L
5. Now restore Modem
Insert Sim and CHECK SET IS GETTING SIGNALS
Now
6. Flash with E975 V20A stock
7. Root Again
8. BACKUP IMEI using the following tool
IMEI TOOL
9. In Backup_IMEI folder replace modem files backed up in step 3
Copy back folder "Backup_Imei" to phone memory
10. Rum "Restore_Imei.bat"
Restore IMEI and modem files
11. Install "SQLite editer" from Google play to open "settings.db" in location "Data\data\com.android.providers.settings\database s" select "global" -> find "subscription_mode" change value "1" to "0" then save and exit.
Reboot Phone and Signal will back with any F180S/L/K with E975 Kitkat Rom
Thank hoangnova.
Thanks VTD to most tool I've use
Thanks to nnhlinh
Few last steps were from his guide
Note: use KDZ Flasher to flash KDZ
I found LG Flash Tool 2014 is not working any more for flash KDZ file go back to stock or downgrade/upgrade. LGUP is working better for go back to stock flash KDZ file. I bought G3 it came with Marshallow I looked everywhere but did not find any method working except use LGUP tool to downgrade or upgrade:
Download from this Vietnamese tread, it's working I flashed KDZ to downgraded from MM to Kitkat (D85010C firmware). It should work with other firmware LP 5.0 or MM 6.0.
http://lgviet.com/forum/threads/tut-...ng-lgup.52437/
For install the tool you just need to run the two Msi files, comport should be under port 41 under device manager I think. LG Mobile driver (LGMobileDriver_WHQL_Ver_4.2.0_001.exe ) should also install before LGUP tool.
Simple instruction include in readme text file with the LGUP zip file. For KDZ fine when first open LGUP you might not able to browse for it, close LGUP and copy/move KDZ file you want to flash to the same directory as LGUP tool (C:\Program Files (x86)\LG Electronics\LGUP\model\8974). Open LGUP again it should show KDZ file, for downgrade just choose refurbish it should work it take 2-3 minutes to flash it. Once the phone reset and start setup you can unplug the phone from the computer.
Note my computer is Windows 7, someone can try on Windows 10 and confirm it's working, cheers
Correction the Kitkat firmware I flashed was: D85110C_00.kdz for Kitkat on G3 D851
Hi, I've been trying to fix my H818N from the past couple of days.
Here is what I did to brick it, unfortunately
1. Downloaded Nougat 7.0 TOT file (H818P v29a TOT) from this website: androidsage lg g4 android 7 0 nougat firmware
2. Started my G4 into download mode and tried to load this TOT file using LG UP, however, LG UP stopped me by displaying an error message: Invalid TOT file
3. Then I used WinHex to change H818P to H818N in the TOT file and saved it
4. Now I was able to upload this file to my G4 in Refurbished mode using LG UP, the upload completed, phone rebooted and displayed: Erasing
5. After that it is stuck in download mode (If I restart it, it displays LG logo and starts download mode automatically)
6. In Download mode, my phone displays this at the bottom of screen:
U 633A s12. 0 AS10. 5 B100 UHS
S U LG-H818N 07.0 Hrev_10 .CPU4
H81529a
Here is what I did till now without any success:
1. installed the latest LG drivers, LG UP, and LG Flash tools on my PC
2. Tried to Flash the following firmwares using LG UP/ LG Flash Tool (I also extracted the dll file from each firmware one by one and placed in the model folder for LG UP while trying)
H815 V20o Modded.kdz
H818N10l_00_0113.kdz
H818N20f_00_0818.kdz
H818N20h_00_1019.kdz
H81520p_00_0403.kdz
H81820p_00_0314.kdz
Hong Kong H818N10b.kdz
H81520p_00_0314.kdz
H815TR20g_00_0428.kdz
F500K20C_00.kdz
All the firmwares get stuck at Internal command failed 9%, 11%, 24%
3) I have scoured the internet but wasn't able to find a solution yet
4) I even tried using the fastboot mode but unfortunately the bootloader is locked and I cannot erase the recovery or image
Now I'm not sure what else can be done to bring my phone back to life. I might try to get it into Qualcomm 9008 mode and try to unbrick it by following this guide: pakfones unbrick lg g4 hard bricked
Any help on this will be much appreciated
tgunn said:
Hi, I've been trying to fix my H818N from the past couple of days.
Here is what I did to brick it, unfortunately
1. Downloaded Nougat 7.0 TOT file (H818P v29a TOT) from this website: androidsage lg g4 android 7 0 nougat firmware
2. Started my G4 into download mode and tried to load this TOT file using LG UP, however, LG UP stopped me by displaying an error message: Invalid TOT file
3. Then I used WinHex to change H818P to H818N in the TOT file and saved it
4. Now I was able to upload this file to my G4 in Refurbished mode using LG UP, the upload completed, phone rebooted and displayed: Erasing
5. After that it is stuck in download mode (If I restart it, it displays LG logo and starts download mode automatically)
6. In Download mode, my phone displays this at the bottom of screen:
U 633A s12. 0 AS10. 5 B100 UHS
S U LG-H818N 07.0 Hrev_10 .CPU4
H81529a
Here is what I did till now without any success:
1. installed the latest LG drivers, LG UP, and LG Flash tools on my PC
2. Tried to Flash the following firmwares using LG UP/ LG Flash Tool (I also extracted the dll file from each firmware one by one and placed in the model folder for LG UP while trying)
H815 V20o Modded.kdz
H818N10l_00_0113.kdz
H818N20f_00_0818.kdz
H818N20h_00_1019.kdz
H81520p_00_0403.kdz
H81820p_00_0314.kdz
Hong Kong H818N10b.kdz
H81520p_00_0314.kdz
H815TR20g_00_0428.kdz
F500K20C_00.kdz
All the firmwares get stuck at Internal command failed 9%, 11%, 24%
3) I have scoured the internet but wasn't able to find a solution yet
4) I even tried using the fastboot mode but unfortunately the bootloader is locked and I cannot erase the recovery or image
Now I'm not sure what else can be done to bring my phone back to life. I might try to get it into Qualcomm 9008 mode and try to unbrick it by following this guide: pakfones unbrick lg g4 hard bricked
Any help on this will be much appreciated
Click to expand...
Click to collapse
Hi.. any help on this please
tgunn said:
Hi.. any help on this please
Click to expand...
Click to collapse
I had similar. LG Bridge helped me.
tgunn said:
Hi, I've been trying to fix my H818N from the past couple of days.
Here is what I did to brick it, unfortunately
1. Downloaded Nougat 7.0 TOT file (H818P v29a TOT) from this website: androidsage lg g4 android 7 0 nougat firmware
2. Started my G4 into download mode and tried to load this TOT file using LG UP, however, LG UP stopped me by displaying an error message: Invalid TOT file
3. Then I used WinHex to change H818P to H818N in the TOT file and saved it
4. Now I was able to upload this file to my G4 in Refurbished mode using LG UP, the upload completed, phone rebooted and displayed: Erasing
5. After that it is stuck in download mode (If I restart it, it displays LG logo and starts download mode automatically)
6. In Download mode, my phone displays this at the bottom of screen:
U 633A s12. 0 AS10. 5 B100 UHS
S U LG-H818N 07.0 Hrev_10 .CPU4
H81529a
Here is what I did till now without any success:
1. installed the latest LG drivers, LG UP, and LG Flash tools on my PC
2. Tried to Flash the following firmwares using LG UP/ LG Flash Tool (I also extracted the dll file from each firmware one by one and placed in the model folder for LG UP while trying)
H815 V20o Modded.kdz
H818N10l_00_0113.kdz
H818N20f_00_0818.kdz
H818N20h_00_1019.kdz
H81520p_00_0403.kdz
H81820p_00_0314.kdz
Hong Kong H818N10b.kdz
H81520p_00_0314.kdz
H815TR20g_00_0428.kdz
F500K20C_00.kdz
All the firmwares get stuck at Internal command failed 9%, 11%, 24%
3) I have scoured the internet but wasn't able to find a solution yet
4) I even tried using the fastboot mode but unfortunately the bootloader is locked and I cannot erase the recovery or image
Now I'm not sure what else can be done to bring my phone back to life. I might try to get it into Qualcomm 9008 mode and try to unbrick it by following this guide: pakfones unbrick lg g4 hard bricked
Any help on this will be much appreciated
Click to expand...
Click to collapse
Hi friend,
No issues, even I faced the same problem. Now everything ok, just click this link https://forum.xda-developers.com/g4/general/update-lg-g4-h818p-to-android-7-lg-h815-t3677485/page5
and go to that page, you may find the post by esco_448
Modified KDZ link to downgrade from nougat to Marshmallow
https://mega.nz/#!BKRnDLIZ!K46qoXNhW...XJDd9MhuNdb-WA
Also please use this dll with LGUP.
https://mega.nz/#!lShUlbgK!ZjNfIbPSv...ZDThw7HQ7ZZkKU
In addition edit the downloaded file, with winhex, then do the normal procedure as you do before, thats all.
Good luck
Sangames
How do I extract a kdz file? When I unlocked my bootloader I forgot to backup my system and now I wanted to mess with the default boot.img but it's trapped in a kdz file that I found online. Usual methods for extracting kdz file failed and also LGUP gives me an error that it doesn't support my phone. Does anyone have any way of extracting one or at least system + image file of "710em" model (preferably 10f but anything will do).
you do not need to extract it you can use the kdz with LGUP directly if you want to recover the phone
https://37s2gw.db.files.1drv.com/y4...S9mPl9F70w?width=677&height=464&cropmode=none