I buyed two L900. Both replace the original sim slot with I605 sim slot. One work well with gsm sim card,can do everythig. Another does not show GSM signal. but it can regonize the sim card. And i odin ljc store rom,still does not work.
Can somebody help me to restore the phone same as the first one?
I've tried unlocking my AT&T Galaxy Note 2 using service mode. I downgraded the phones modem to the 4.1.1 version and it worked. I used my metroPCS sim card and the phone did not ask for the code but it said phone not allowed MM#6. When I try to call someone it says emergency calls only. I was wondering if it is because the phone is still under contract or because I'm supposed to use a blank sim card and not one thats already been used. Please help.
I get a used LS980 and It havn't activated with Sprint yet. No Unlocked yet. No Sprint sim card handy. Normally, it show NO Sim card on the phone, but when T-mobile or ATT sim card inseted, it still shows "NO SIM Card" I remove the sim card completely, and reboot the phone and insert Sim again. It still show No sim Card?
Don't they support to show invalid Sim Card if insert ATT or Tmobile sim card in a locked Sprint LS980 phone? I have a Sprint Samsung Galaxy locked with Sprint, If sim card inserted, it show invalid. Same with Verizon locked phone show invalid sim if ATT or Tmobile inserted.
Now, it seem likes a defective sim slot on the phone. without activated or a Sprint sim, how to verify it. Please be advice?
inserting any sim besides sprint will show no sim card message
DJ_MiX said:
inserting any sim besides sprint will show no sim card message
Click to expand...
Click to collapse
yup.. insert any sim beside sprint show No Sim Card message. is it normal for anyone?? or the sim slot defective?
I'm planing to use it on Freedompop. Order a sim from Tint.com could take awhile. While i'm wait for sim arrival, please tell is the sim slot defective or normal?
No one can help? Or test on your LS980 to find if it support to show invalid sim card on your locked LS980?
BTW, This device here still JB 4.2.2 with some of VZ8 firmware. Do I need to unlock for further test?
Tekone said:
No one can help? Or test on your LS980 to find if it support to show invalid sim card on your locked LS980?
BTW, This device here still JB 4.2.2 with some of VZ8 firmware. Do I need to unlock for further test?
Click to expand...
Click to collapse
Yeah, try unlocking using this thread:
http://forum.xda-developers.com/showthread.php?t=2729370
Then test out the sim cards..
No Sim card detect if it's not Sprint sim card install. NO matter what method I unlock it. Kind of weire..
Tekone said:
No Sim card detect if it's not Sprint sim card install. NO matter what method I unlock it. Kind of weire..
Click to expand...
Click to collapse
Try posting questions specific to your problem to the threads of the specific methods you used, someone in there will probably be best able to help you.
My Note 2 international was working well until i decided to flash a 3rd party rom.
When i flashed the rom everythong worked fine but the sim card.
The phone kept asking to insert sin card although it was already inserted.
The sim is working on other phones.
I tried flashing back the original 4.4.2 rom from sammobile and it worked and i could search for the networks and i selected my network and the phone said registered on network. But when i try to make a call it says again: not registered on network.
What should i do?
Please help.
Thank you
I have a att note 10+ that I sim unlocked it will take a Verizon sim and work 100% but it will not work with straight talk i have no service can't call text and no data every once in awhile a text will get thru but can anyone help me with this I can't root because I can't oem unlock unless there is another way any help would be appreciated
ackaite said:
I have a att note 10+ that I sim unlocked it will take a Verizon sim and work 100% but it will not work with straight talk i have no service can't call text and no data every once in awhile a text will get thru but can anyone help me with this I can't root because I can't oem unlock unless there is another way any help would be appreciated
Click to expand...
Click to collapse
Did you set the APN information correctly?
Also are you using the N975U1 firmware or the standard AT&T firmware?
Are you using the BYOD sim card from straight talk?
What have you done over the phone with Straight Talk as far as troubleshooting? - this one can be important. If the phone isn't working with straight talk only it maybe a configuration (apn setting) or provisioning issue.
Are you sure the device is compatible with the area or region your in?
What provider/tower (Verizon, AT&T, etc.) does straight talk have you going through?
More information on what you have done to setup the phone for straight talk, troubleshooting steps you have taken, what information straight talk may have provided (etc. etc.) will help others be able to help you. Providing little or no details makes it rather hard to offer any help.
The apn won't let me put dun in the type I sim unlocked it with a puk code and got strighttalk byop I tried flashing the U1 firmware to it wouldn't take it so I did a Verizon firmware thinking that might help and same thing with the striaght talk it doesn't wanna work i put a Verizon sim in it and it works just like it did on ATT so I'm confused as to why the straight talk sim won't work they can't figure it out on their end either
I factory reset the phone reset network settings did just about everything I could with the phone besides it being funny about the apn cuz it says apn cannot be changed on this device if you put dun in the apn type i dunno the only thing I notice is when the Verizon sim card is in the phone the network mode is set to global whereas with the striaght talk its LTE/CDMA and it won't let you change it to global
ackaite said:
The apn won't let me put dun in the type I sim unlocked it with a puk code and got strighttalk byop I tried flashing the U1 firmware to it wouldn't take it so I did a Verizon firmware thinking that might help and same thing with the striaght talk it doesn't wanna work i put a Verizon sim in it and it works just like it did on ATT so I'm confused as to why the straight talk sim won't work they can't figure it out on their end either
Click to expand...
Click to collapse
Straight Talk uses different mobile providers to offer service different areas.. They utilize Verizon, AT&T, Sprint and T-Mobile (Sprint and T-Mobile have merged recently, but Sprint towers are still active).
I have seen posts across the internet that indicate you should be using the U1 firmware on the phone.. I would make sure your converting the phone to the U1 firmware properly.
If I recall correctly (this is how I did it previously) when flashing the U1 firmware make sure your doing it without the sim card installed and using the non home_csc file. Factory data reset the phone after you successfully flash the U1 firmware and then insert the sim card after setting the phone back up (so it can apply the new sim/network settings).
I would strongly suggest you do not restore a backup during initial setup when you do this. If you restore a backup it may restore previous network settings/configurations that were for what you had previously.
If flashing U1 firmware doesn't help (and since this this is a Straight Talk specific issue) then it's more then likely on the end of Straight Talk. I would call them and make sure that your sim card is the correct one for the cell towers they have you going through and the phone you have. Using an incompatible sim card (or one that is faulty) can cause issues like this. You can also have them send you another sim card to try.
Also contact them to make sure the service is properly provisioned and activated on your phone. Double check the APN with them, and see if they have an alternative one to try. It is also possible that a service outage maybe (or issue with Straight Talk internally) in your area, so I would call them to make sure that neither are not the case here.
ackaite said:
I factory reset the phone reset network settings did just about everything I could with the phone besides it being funny about the apn cuz it says apn cannot be changed on this device if you put dun in the apn type i dunno the only thing I notice is when the Verizon sim card is in the phone the network mode is set to global whereas with the striaght talk its LTE/CDMA and it won't let you change it to global
Click to expand...
Click to collapse
The Global setting doesn't really matter in this case and your phone will be set to use the towers that Straight Talk has you going through.
The only thing that I can think of that would be a problem with network mode is if your sim card from straight talk is meant for a different provider then the towers they use in your area (i.e. sim card is for AT&T but the provider they have for the area is Sprint).
the straight Talk sim works in other phones no problem a s8 and a older note im thinking att has something in the software to block other apns i dunno i unlocked it with a PUK code and flashed verizon firmware on it thinking i could get passed it but the verizon sim works 100% and the att sim works 100% too but a straighttalk sim card (verizon) towers the phone tries it shows 4g and disappears and then it shows it has service but cant call it just says emergency calls only
ackaite said:
the straight Talk sim works in other phones no problem a s8 and a older note
Click to expand...
Click to collapse
I would not use older phones as a means to say the sim card is good. Besides that's irrelevant to what is going on with the Note 10+
ackaite said:
im thinking att has something in the software to block other apns
Click to expand...
Click to collapse
Then this means one of two things... Either you didn't get the phone unlocked or else you did not convert to another carrier (or the U1 firmware XAA region) correctly.
If your using the unlocked firmware (U1 XAA region) then you should be able to edit the APN. If not then you should be able to create one.
ackaite said:
i dunno i unlocked it with a PUK code and flashed verizon firmware on it thinking i could get passed it but the verizon sim works 100% and the att sim works 100% too but a straighttalk sim card (verizon) towers the phone tries it shows 4g and disappears and then it shows it has service but cant call it just says emergency calls only
Click to expand...
Click to collapse
That sounds like either the sim card isn't good, the phone was not activated/provisioned properly in there systems (call them and double check IMEI and model information), the phone is not compatible with the service they offer in your area (I suggest using the XAA region U1 firmware in this case) or else your phone is not fully unlocked.
I would also suggest google searching or else asking them for any updated or alternative APN's to try. It maybe very likely the one you have is not suitable for the phone/area... It wouldn't be the first time I have had an issue similar to this like this.
I am opt to believe the first 3 are the most likely scenarios since the phone works on Verzion with the sim card per your indication.
Yeah and the only reason I tried the older phone is to see if the sim card is activate with the number and the phone itself pulled the apn from network when I tried to flash to U1 the phone gave me a error but it took the Verizon firmware for the 975U but its still not working do you know of a good link for the firmware your talking about so I can try that
ackaite said:
Yeah and the only reason I tried the older phone is to see if the sim card is activate with the number and the phone itself pulled the apn from network
Click to expand...
Click to collapse
From personal experience I would advise in the future you don't do that. When you activate the phone you should activate the one you are using and definitely do not use an older phone to activate a newer phone. I have had many problems with this in the past as provisioning for an older phone didn't always work for my newer ones..
ackaite said:
when I tried to flash to U1 the phone gave me a error but it took the Verizon firmware for the 975U but its still not working do you know of a good link for the firmware your talking about so I can try that
Click to expand...
Click to collapse
I waited for you to give more information on the issue, but you didn't. So I am sorry, but if you don't provide the details of what is going on it makes helping you very difficult. You didn't say what error you are getting, what the firmware version(s) are of what your trying to flash and what is currently on the phone.
Here's the last piece of help I can offer now.
I can tell you that the following can be found on the forum by searching:
Links and how to obtain the firmware - Multiple threads asking the same question exist here. Also Frija, SamFirm, SamMobile are just a few examples of what can be found referenced here.
Bootloader version(s) - what will happen when you try to downgrade and what will happen (along with a important thing) when you upgrade.
Websites to find firmware - SamMobile and some others have been mentioned.
Patched Odin - In case you need the latest version it has been mentioned here already.
I can also tell you that by using Google and searching for SM-975U1 XAA on Sammobile does in fact work.
Brother give me root file for note 10 plus SM-N975U android 10 version one Ul version 2.5 plz help me