So, yesterday I flashed my phone from lollipop to kitkat after a version for my phone was finally released due to a member of this community(thank you <3) and everything went smoothly and I had no hiccups during the process... but once I restarted my phone, I noticed I didn't have 1x, 3g, or 4g as a signal indicator but I had full service and I could make calls.... just no texts or data.
Any idea how to fix this? I should note I'm using nTelos.... and it's CDMA.
I can sometimes get it to connect to 3g using an APN edit in the hidden settings but after like 5 minutes it goes back to full bars and no data connectivity.
Related
Good evening all! Today I restarted my phone for the first time in a week and a half or so, and upon booting up it refused to connect to the mobile network. It says full service 4G, but the bars are gray and therefore no data connection can be established. I restarted my phone once more and then even pulled the battery and sim card and started it up. Nothing has worked. I got home and connected to WiFi just fine, but when I turn off WiFi I go back to no data connection.
Is anyone else using a CDMA Nexus and having a problem? I live in Cleveland, if it's a possible area issue. I haven't called yet, but I have searched all over the internet to no avail.
Currently running stock, rooted, 4.0.4. No other modifications.
No problems here, but I'm a good ways away from you.
well I'm finally able to connect to the network again (the signal bars are blue), but I'm still getting virtually no data connection. It works in sprints of a few seconds, but then doesn't work again for a minute or 2. There's either a problem with my phone or the network...but I'd lean toward the network since it works at times, but not others.
I live in Parma and have noticed spotier service then normal. Hopefully its temporary. Hasn't been too bad. Able to get 4g most of the time.
Sent from CDMA V6 SC GNexus w/Liquid & Franco.kernel
For some reason I cant post in the Dev forum in the Milestone thread...
The ROM is impressive. But I seem to be having 3G data issues.
It seems that I lose 3G service and it will not come back until I stop/start the data toggle. The status bar still shows the 3G icon, but the bars are just light grey and I do not receive email and cant browse. I can still send texts and get/make calls. I havent been able to figure out a pattern yet, but the latest occurrence happened after I came out of an area with no signal (NYC Subway). Usually service comes back automatically as Im walking up the stairs to the outside world but sometimes it never comes back until I toggle. It also happens sometimes even if I dont go into an area with no signal (at the office). After I turn off the data toggle, and turn it back on, the 3G icon comes back on the status bar and the bars turn blue again and shows up/down arrow activity.
Anyone else seeing something similar?
I'm having trouble with 3g and I have no 4g on milestone 6 as well. I went back to an older build until it the next one drops and see if it's fixed.
stonesaber said:
I'm having trouble with 3g and I have no 4g on milestone 6 as well. I went back to an older build until it the next one drops and see if it's fixed.
Click to expand...
Click to collapse
4G connects for me with no problem when I want to use it.
But I lost 3G data again this morning after coming out of the subway. Noticed I had emails in my inbox at work and checked my phone and 3G was stuck again.
I'm having connectivity problems on my copy of Milestone6 as well. Same 3G problems as OP, and can't connect 4G like 2ndP. As well, I'm unable to browse wifi signals, nor able to connect. :-/
I've got a strange problem that I cannot solve or find anyone else that has had the same problem.
I recently updated to Minco V4 and since my status bar has been showing no signal and mobile standby shows 100% without signal yet I have mobile data. I cannot make any phone calls but can browse the internet. No amount of rebooting, airplane mode on/off will work. I've also gone back to both stock ICS and JB where the problem still exists.
My network is T-Mobile and it won't let me manually connect to it but the phone will occasionally register when I select automatic although it doesn't correct the fault. Anyone have any ideas what has gone wrong with my phone?
UPDATE: It seems I can only get a phone signal when select 2g T-mobile network only or connecting to T-Mobile orange. If I untick 2g networks and it connects to t-mobile 3g I can't receive or make calls.
Does your Radio and baseband match?
I installed the linked radio from the MiNCO thread after flashing the rom and discovering this issue yet it made no difference.
I got a phone signal momentarily about 15 mins ago which allowed me to make a short phone call to test it. I then accepted the JB system update from Google and now have no phone signal, just data.
hey guys,
got a i317m from canada with the stock bell rom with root. everyone week or two, i'll notice im not getting any data (messages and other data apps wont work). the lte symbol is there, but the little arrows for upstream and downstream are clear (usually orange or blue when working).
i tried rebooting, wifi on/off, airplane on/off and still the same. i confirmed lte is selected and the apn is selected and duse data is selected. it seems to start working when i start messing with the roaming options (havent confirmed this completely as i am still trying to narrow it down).
one thing i just noticed is that when it starts working, its in hspa mode, not lte
any suggestions?
I have the opposite issue in Michigan. If I lose LTE I will lose hsdpa even though the icon shows 4G. I can see the data curves moving up and down but no data. Sometimes jumping in and out of airplane mode fixes it. Also I see the 4G Hsdpa icon and the WiFi icon active at the same time even though I'm using WiFi. Very annoying.
Sent from my SAMSUNG-SGH-I317 using Tapatalk 2
I have been running CM13 ever since I got my OP3 this summer, but today i decided to go back to oxygenos for a bit. Following a clean flash, I could text and use wifi but had no data capabilities. So I went and copied APN info from brothers phone, and I can get lte but after a few hrs and going back and forth from wifi and data, it starts to connect to H+. I have checked mobile data settings and confirmed lte preference.
Any ideas?
EDIT: I downloaded a lte network app that corrected the connection, switching from H+ to lte, but after going on wifi then back off I was back to H+...
hipporun said:
I have been running CM13 ever since I got my OP3 this summer, but today i decided to go back to oxygenos for a bit. Following a clean flash, I could text and use wifi but had no data capabilities. So I went and copied APN info from brothers phone, and I can get lte but after a few hrs and going back and forth from wifi and data, it starts to connect to H+. I have checked mobile data settings and confirmed lte preference.
Any ideas?
EDIT: I downloaded a lte network app that corrected the connection, switching from H+ to lte, but after going on wifi then back off I was back to H+...
Click to expand...
Click to collapse
Are you on T-Mobile? I have the same problem
Sent from my SM-G935T using Tapatalk