So i used odin to flash a stock rom but im pretty sure i made a huge mistake because i accidently put it in the phone section in odin! is that the reason why its stuck i tried again with odin and put it in the pda section instead but same results stuck on the samsung logo. Please help im a huge noob.
Hello Guys,
Need your help.
I have flashed hundreds of roms on my android phones and tablets, but this time something new happened to me:
After installing a t700 Rom using twrp recovery, my tablet got stuck at boot logo, doesn't matter how many resets i try, it never goes beyond the black and whit samsung boot logo!
I have tried to reset using kies, flashed a stock firmware with Odin, etc ect ect, nothing! its still stuck at boot logo.
One curious thing happened, after flashing sock firmwares for the second or third time, the Samsung sounds stops halfway, and then it goes back to the Samsung logo.
Any ideas on how to get out of this nightmare?
Thank you!!
Hi
Thanks for writing to us at XDA Assist. Please standby while we have your thread/question moved to the appropriate sub-forum for your device.
For future reference you can find your device sub-forum here (bookmark/subscribe this):
Samsung Galaxy Tab S
Within that section you will find a dedicated q&a sub-forum (this is where your thread is going to be moved to):
Galaxy Tab S Q&A, Help & Troubleshooting
Good luck!
black_coder said:
Hello Guys,
Need your help.
I have flashed hundreds of roms on my android phones and tablets, but this time something new happened to me:
After installing a t700 Rom using twrp recovery, my tablet got stuck at boot logo, doesn't matter how many resets i try, it never goes beyond the black and whit samsung boot logo!
I have tried to reset using kies, flashed a stock firmware with Odin, etc ect ect, nothing! its still stuck at boot logo.
One curious thing happened, after flashing sock firmwares for the second or third time, the Samsung sounds stops halfway, and then it goes back to the Samsung logo.
Any ideas on how to get out of this nightmare?
Thank you!!
Click to expand...
Click to collapse
1. Load up your PC the original stock firmware, which corresponds to your Tab original Region CSC-code according to the model number and serial number of your Tab. How it may be defined, you can read in this thread:
http://forum.xda-developers.com/galaxy-tab-s/help/how-to-select-correct-firmware-tablet-t3016068/post58500430
2. Flash your Tab by Odin c original stock firmware from p.1
Regards
I have seen this before when a tablet gets stuck on the Samsung logo, what you need to do is after flashing your stock firmware using odin, you then need to get into stock recovery and wipe cache and factory reset from within stock recovery and then reboot.
Hello all, I could use some help with the note 10.1 I traded for this because it should be fixable. Right now it only boots to the note screen then reboots. I can get it to download mode but no recovery mode. I have downloaded the firmware from samfirmware so far no luck after flashing it with Odin. The model is sm-p605v I am hoping someone has another idea or someway to flash it to stock so I can just use it.
Thanks alot everyone
I normally find a way around some android issues but sort of lost this time so iI need some help please!
Tablet is (was?) rooted and running cm12 plus twarp before the issue. It was running fine other than using a lot of battery.
So after replacing a battery my Note 8 N5110 started a boot loop and sometimes TWARP starts but does not work and it gets back to the boot loop!
I tried first re-load TWARP via odin and it passed but it was still in the bootloop so I tried load the stock firmware via Odin and I am getting failed with a
I have attached a picture of Twarp right before it fails, a picture of Odin with a failed attempt to load the stock firmware and the message I get on the Note 8 custom firmware screen.
Thanks in advance!!!
For the record I found a way out, the only thing that worked on my case was initialize the Tab using Samsung KIES.
Awesome software thanks Samsung, it saved my day and now....back to root and CM13 again
Hello glad you got it working. is it hard to replace the battery in these?
Hi i need help with my tab s 10.5, the wifi and bluetooth stopped working and i seen on this site that i might need to do a update so i downloaded one and tried to install it, but around 95% complete it failed and then when i turned the tab on it said somthing about firmware update failed and recover wi kies. I then tried another update and all i get when the tab turns on is the sound it makes when coming on and see the samsung logo but thats all i get and the logo wont go away. What have i done wrong and could someone please point me in the right direction. thanks in advance.
that's what is called a bootloop.
You will need the Odin tool to re-flash your stock firmware.
Just search on this forum section for Odin and bootloop and you will get everything you need : )