I have a LG 240L & its recovery is currupted, when I try to update recovery with B2C Tool it says battery is low. But battery is enough to do so, Please help me urgent to solve this problem
the device is stucked on lg logo it goes to download mode but can't download kdz file it always says recovery currupted.
Related
Hi, this is my mini guide to recovery in original lg e975... If any method does not work then use this!!
I have test it on my lg e975 bricked thanks twp recovery e970 !!! kdz not working ... error!!!
1- buy this cable to set usb 910k or similar cable important is "mode 910k"(http://www.ebay.com/itm/4in1-Micro-...999-P990-P970-flash-unlock-MORE-/261019033382)
2- download LG MOBILE SUPPORT TOOL from http://www.lg.com/sg/support-mobile/lg-Optimus-G-LG-E975
3- shutdown phone
4- connect cable to 910k at phone
5- start lg support tool and install driver
6- you will see that lg support tool has found your phone
7- go in support > Emergency & recovery mode> write your imei and press check (wait 1 minute after "OK" to start upgrade tool) upgrade process is 10-15 minutes
7-after upgrade is finished it restart phone automatically
If you have change partition after update could stuck on logo lg ... how to fix it:
- shutdown phone and press hold key volume- and power for 15s and it reset software-
Sorry my bad english!!!!!!!
I have done these steps with the regular cable that came with my phone lol. No special cable needed.
you can get into the flash mode by holding down vol up and vol down while connecting it to USB.
If you can enter download mode, you can use KDZ updater,without any problems. LG mobile tool will work only on stock rom.If you are on custom rom,no luck with it.
Besides, with kdz updater you don't have to wait everytime to download the KDZ from lg server, you can use local image.
But if you can't enter download mode, the only way is the JTAG.
But if I have problems to flash with kdz and yet also "LG support tool", but I can get into download mode, how can I fix it?
I have the animated LG logo bootloop after trying to flash via kdz with CM11 installed ...
G support tool gets stuck at 15, but unplugging the USB cable from e975 and reattaching it, the procedure is completed, but say me: Battery level low even though I have 100%. Why?
Bye, Thanks
KDZ updater not working
I had TWRP 3.0.0 then i tried to flash lower version i think it is TWRP2.5.6, after i flashed it i restarted and went to recovery mode, but there was no recovery mode, only black screen... I tried with KDZ updater to flash stock rom V10H but after KDZ extracts files, connect to phone, says that its starting to s/w upgrade and my phone restarts and goes to fastboot mode, and KDZ updater stays like that, doesn't do anything, I tried it on two different computers, Win 10 and Win XP.. I still have my software on (ubuntu touch by mordesku) but i want to go back to CWM. Can somebody help me?
hello All
i did something very very very bad
i was upon to downgrade my D855 from 5.0 to Kitkat but it stop on 17% in pc and 0% on the phone
it still like that for 40 min so i unplug USB and i restart the phone i just get message says (secure booting error) in the up left side of phone and after that black screen and LED (BLUE & RED) i can not get in to download mode but when i try i get this :
Qualcomm HS-USB QDLoader 9008 (COM41)
and when i try to enter to recovery mode i get had to do factory reset and same problem !
so anyone can help me with this ?
Thanks ..
any help plz
Hello.
Move your battery, then replace it.
Flash an official kdz from lg.com with LGflashTool and your phone will restart
Your device is Brick!!
Try to enter Download mode
Flash your device again with LG FLash tools(tot File) or KDZ
i found it holllllaaa
for everyone have this problem, on this link you can fix it
http://forum.xda-developers.com/sprint-lg-g3/general/guide-fix-hard-brick-recovery-guide-t3132359
i used KIZ file by the way
and i wish frm supervisor to close this subject and write solved on it
thanks.
I've Tried to solve this problem but its always fail
so i'm writing this thread hopefully some one can help me out.
I've LG G3 D855 and i'm stuck on LG logo.
When press volume + and connect the phone to PC it goes to fastboot mode, see the attached image "01.jpg"
if i disconnect it and connect again to PC it gives me this messages, see the attached image "02.jpg"
i tried to follow up with this thread http://forum.xda-developers.com/lg-g3/help/tutorial-fixing-fastboot-mode-started-t2995854/page7
and this one http://open-freax.fr/guide-unbrick-your-lg-g3/
but that didn't solve the problem , when i did every step and all steps ends without errors , my phone restarts with the same issue
Please .. i Really need Help
]hello my lg g3 European (D855) won't turnning on and not entered to download mode . i can see only black screen
It's strange to me that the computer sees the connection of the device.. (download mode .) but the lgup detecting phone ..
It happened to me that you tried to do flashing through FASTBOOT BOOT.IMG and now my phone got bricked ineed your help
thanks ! <3
Please See The Picture In URL IMG https://imgur.com/a/eVFc8[/IMG
Hi ,
My Lg-g3 d855 just turned off when i'm on the menu and now , it stucks on everything . When I try to open it I got LG logo screen stuck , tried to hard reset but stucked on android screen and did nothing for 8 hours ( Yes, I waited..) , when I plugged it to pc it stucks on battery picture on screen , when I open it with download mode , stucked %0 firmware update screen . I searched a lot and tried to recover it with lg flash tool ;
Downloaded kdz file and tried to import it with lg flash tool 2014 ver. // Got stucked at %2
Downloaded .tot file and tried to import it from com41 with updated lg flash tool // Got connection error with phone
Tried to update recovery from flash tool with IMEI // Got stucked at %2
I literally cant do anything on this phone and I'm about to freak out . I dont care about my files , please just help me to open this
@marksm4nn: what happens, if you connect switched-off to wallcharger?
rp158 said:
@marksm4nn: what happens, if you connect switched-off to wallcharger?
Click to expand...
Click to collapse
It stucks on battery picture screen , nothing changes
@marksm4nn: I guess, time to say goodbye