Hi ,
My Lg-g3 d855 just turned off when i'm on the menu and now , it stucks on everything . When I try to open it I got LG logo screen stuck , tried to hard reset but stucked on android screen and did nothing for 8 hours ( Yes, I waited..) , when I plugged it to pc it stucks on battery picture on screen , when I open it with download mode , stucked %0 firmware update screen . I searched a lot and tried to recover it with lg flash tool ;
Downloaded kdz file and tried to import it with lg flash tool 2014 ver. // Got stucked at %2
Downloaded .tot file and tried to import it from com41 with updated lg flash tool // Got connection error with phone
Tried to update recovery from flash tool with IMEI // Got stucked at %2
I literally cant do anything on this phone and I'm about to freak out . I dont care about my files , please just help me to open this
@marksm4nn: what happens, if you connect switched-off to wallcharger?
rp158 said:
@marksm4nn: what happens, if you connect switched-off to wallcharger?
Click to expand...
Click to collapse
It stucks on battery picture screen , nothing changes
@marksm4nn: I guess, time to say goodbye
Related
Hi, this is my mini guide to recovery in original lg e975... If any method does not work then use this!!
I have test it on my lg e975 bricked thanks twp recovery e970 !!! kdz not working ... error!!!
1- buy this cable to set usb 910k or similar cable important is "mode 910k"(http://www.ebay.com/itm/4in1-Micro-...999-P990-P970-flash-unlock-MORE-/261019033382)
2- download LG MOBILE SUPPORT TOOL from http://www.lg.com/sg/support-mobile/lg-Optimus-G-LG-E975
3- shutdown phone
4- connect cable to 910k at phone
5- start lg support tool and install driver
6- you will see that lg support tool has found your phone
7- go in support > Emergency & recovery mode> write your imei and press check (wait 1 minute after "OK" to start upgrade tool) upgrade process is 10-15 minutes
7-after upgrade is finished it restart phone automatically
If you have change partition after update could stuck on logo lg ... how to fix it:
- shutdown phone and press hold key volume- and power for 15s and it reset software-
Sorry my bad english!!!!!!!
I have done these steps with the regular cable that came with my phone lol. No special cable needed.
you can get into the flash mode by holding down vol up and vol down while connecting it to USB.
If you can enter download mode, you can use KDZ updater,without any problems. LG mobile tool will work only on stock rom.If you are on custom rom,no luck with it.
Besides, with kdz updater you don't have to wait everytime to download the KDZ from lg server, you can use local image.
But if you can't enter download mode, the only way is the JTAG.
But if I have problems to flash with kdz and yet also "LG support tool", but I can get into download mode, how can I fix it?
I have the animated LG logo bootloop after trying to flash via kdz with CM11 installed ...
G support tool gets stuck at 15, but unplugging the USB cable from e975 and reattaching it, the procedure is completed, but say me: Battery level low even though I have 100%. Why?
Bye, Thanks
KDZ updater not working
I had TWRP 3.0.0 then i tried to flash lower version i think it is TWRP2.5.6, after i flashed it i restarted and went to recovery mode, but there was no recovery mode, only black screen... I tried with KDZ updater to flash stock rom V10H but after KDZ extracts files, connect to phone, says that its starting to s/w upgrade and my phone restarts and goes to fastboot mode, and KDZ updater stays like that, doesn't do anything, I tried it on two different computers, Win 10 and Win XP.. I still have my software on (ubuntu touch by mordesku) but i want to go back to CWM. Can somebody help me?
hello All
i did something very very very bad
i was upon to downgrade my D855 from 5.0 to Kitkat but it stop on 17% in pc and 0% on the phone
it still like that for 40 min so i unplug USB and i restart the phone i just get message says (secure booting error) in the up left side of phone and after that black screen and LED (BLUE & RED) i can not get in to download mode but when i try i get this :
Qualcomm HS-USB QDLoader 9008 (COM41)
and when i try to enter to recovery mode i get had to do factory reset and same problem !
so anyone can help me with this ?
Thanks ..
any help plz
Hello.
Move your battery, then replace it.
Flash an official kdz from lg.com with LGflashTool and your phone will restart
Your device is Brick!!
Try to enter Download mode
Flash your device again with LG FLash tools(tot File) or KDZ
i found it holllllaaa
for everyone have this problem, on this link you can fix it
http://forum.xda-developers.com/sprint-lg-g3/general/guide-fix-hard-brick-recovery-guide-t3132359
i used KIZ file by the way
and i wish frm supervisor to close this subject and write solved on it
thanks.
I tried to install a ROM Custom on my LG G4 and it brick, and it is in the loop logo and and is loop in download mode also and when I connect my phone to pc the computer does not recognize the phone , it's like I do not estivese connected in computer already installed mobile drives 10 times old and new version , and the phone does not enter the dowload mode and not in recovery and also does not turn on and the PC can not recognize my lg g4 , I tried to change pc cable and anything,
Mobile : LG G4
Model: H815P
Made in Brazil
Error:
Code:
============
Secure Booting Error!
Error Code : 1014
============
Same problem here. When I turn my device on it says secure booting error 1003 and when I try to get it into download mode I receive secure booting error 1014. Been searching for a while but no solution as yet. I hope someone might come to rescue us.
I was able to get my g4 back to life after this sending it to a local lg repair shop (not official). The guy had a box and was able to flash the stock firmware again. Took about one hour and cost me 50 reais.
marzliak said:
I was able to get my g4 back to life after this sending it to a local lg repair shop (not official). The guy had a box and was able to flash the stock firmware again. Took about one hour and cost me 50 reais.
Click to expand...
Click to collapse
its called JTAG..
]hello my lg g3 European (D855) won't turnning on and not entered to download mode . i can see only black screen
It's strange to me that the computer sees the connection of the device.. (download mode .) but the lgup detecting phone ..
It happened to me that you tried to do flashing through FASTBOOT BOOT.IMG and now my phone got bricked ineed your help
thanks ! <3
Please See The Picture In URL IMG https://imgur.com/a/eVFc8[/IMG
Very good,I wanted to do a downgroade of marshmallow to lollipop in A G4 H815 of a friend to root it, since Usus in linux salt told me that it could not flash, I had to flash a SALT-compatible-LAF_flash-in-twrp.zip for recovery since this model is Turkish and the official method did not work either ... well to do the downgroade in LGUP while flasehaba LAF partition (which chance ..) Windows failed and restarted alone. (Windows 7 because the 10 did not recognize the usb in any way ..) Now the mvl is stuck in the logo of the Lg with this error .. when trying in download mode the error also appears .. And it restarts again to the logo so on with this error .. I have been searching online and nothing specific for this error only if you enter download mode, but it does not enter and the pc does not recognize it when I connect it ... we have screwed but well (this happens to me for wanting to do favors ...) if you have any advice u help I would really appreciate it .. I slept 3 hours and something and I look like a zombi at work and this afternoon should return your "wonderful" phone. A greeting
metadeivid said:
Very good,I wanted to do a downgroade of marshmallow to lollipop in A G4 H815 of a friend to root it, since Usus in linux salt told me that it could not flash, I had to flash a SALT-compatible-LAF_flash-in-twrp.zip for recovery since this model is Turkish and the official method did not work either ... well to do the downgroade in LGUP while flasehaba LAF partition (which chance ..) Windows failed and restarted alone. (Windows 7 because the 10 did not recognize the usb in any way ..) Now the mvl is stuck in the logo of the Lg with this error .. when trying in download mode the error also appears .. And it restarts again to the logo so on with this error .. I have been searching online and nothing specific for this error only if you enter download mode, but it does not enter and the pc does not recognize it when I connect it ... we have screwed but well (this happens to me for wanting to do favors ...) if you have any advice u help I would really appreciate it .. I slept 3 hours and something and I look like a zombi at work and this afternoon should return your "wonderful" phone. A greeting
Click to expand...
Click to collapse
Has anyone solution for this? I have same issue.
Hello,
You need to put your phone into Qualcomm Dloader mode again.
On the main board of your phone, there is a way to short-connect some two pins to enable the Qualcomm Dloader
and then you need QFIL to load the recovery files onto the phone to enable the normal android download mode.
---------- Post added at 01:50 AM ---------- Previous post was at 01:48 AM ----------
Ask someone who has a octopus box to fix your phone - They can DO it with USB-OVER-NETWORK