Hi, yesterday when i using my phone,it suddenly hang,then i perform a reset (hold power button) and it reboot to the OS, after receiving a call it hang again, then i using the same method to reboot and it stuck at the samsung logo...
Been searching inside the forum for the way to recover it,now i giving up and asking for help...
Before i get it rooted using exynos abuse but i unroot it due to gamevil games,situation for my phone now is:
Stock samsung firmware
CANNOT boot in recovery mode
CAN boot to download mode
HANG at samsung logo
below is the picture i take:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
At recovery mode it just show the android fella blue heart keep spinning, few minutes later then it restart...
At download mode it shows:
ODIN MODE
PRODUCT NAME: GT-N7100
CUSTOM BINARY DOWNLOAD: NO
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Custom
Since it shows the product name so i assumed that it not a SDS,methods i tried is:
ODIN FLASH N7100XXALJ1_N7100OXXALJ1_N7100XXALIH_HOME.tar.md5 - failed at modem.bin
ODIN FLASH N7100XXDMF2_N7100OLBDMD2_N7100DXDMF1_HOME.tar.md5 - failed at start
ODIN FLASH N7100XXALJ1_N7100OLBALJ1_N7100DXALIA_HOME.tar.md5 - SUCCESS
ODIN FLASH N7100XXALJ3_N7100OLBALJ3_N7100DXALJ1_HOME.tar.md5 - SUCCESS
ODIN FLASH other kernel such as philz touch,cwm6 recovery,even CFROOT - SUCCESS
ODIN FLASH with pit file (from DR.KETAN) - showing NO PIT PARTITION
Ok, i tried flash 2 ROM successfully, but still can't boot in the OS,any help would be appreciated.
Thanks.
Related
Hi guys, could use some help with my situation.
This is what happens when I boot up the N7105.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I was able to access the download mode however when I tried to flash philz recovery via Odin, it failed.
The error message is below.
As I am able to see the product name, I guess it is not the SDS issue that has been circulating.
Would appreciate any help from you guys.
Thanks a lot!
What bootloader are you on?
(What does it say whe you're in DL mode)
If you have Knox you cant just flash anything you like, you'll have to flash 4.3 stock rom with knox and follow instructions of how to disable knox and downgrade.
If not on knox bootloader DL a 4.1.2 rom and flash it through odin
(Your OS and Odin versions can sometimes cause the PIT not found issue)
Which odin should i use to flash 4.1.2? And how do I check if my friend's phone has knox?
Anywhere i can get a 4.1.2 stock? Cannot find it on Sammobile for Singapore's version.
Nope did not work. Tried flashing 4.3 stock failed. Tried with PIT, failed too. All attempts failed at unable to Repartition.
Note 2 unable to boot up
Hi, so what u did to get the phone back on service? My aunt's note 2 give the same white screen like the top pic.
bladez87 said:
Nope did not work. Tried flashing 4.3 stock failed. Tried with PIT, failed too. All attempts failed at unable to Repartition.
Click to expand...
Click to collapse
Nvm.
Silotolis said:
Hello XDA, haven't been on these forums for a while.
I have a slight issue with a Galaxy SIII I just picked up off a friend.
The S3 goes to this screen every time I try to boot it with the power button:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
And I AM able to get to the download mode screen:
I've tried to flash a Stock Rooted Firmware onto the phone using Odin 3.07, and all it does is say it failed.
Another thing to note is that I CAN'T boot into recovery, and that I do not have Clockworkmod installed.
Also, I am not sure if my device is rooted as it was given to me by someone else..
Any help on trying to solve this issue will be much appreciated!! Thank you! ��
EDIT: if you can't see the images for some reason, it is just a photo of the "Firmware Upgrade Encountered an Issue" screen and a photo of the download mode screen.
More info:
ODIN MODE
PRODUCT NAME: SGH-T999
CUSTOM BINARY DOWNLOAD: Yes (4 counts)
CURRENT BINARY: custom
SYSTEM STATUS: official
QUALCOMM SECURE BOOT ENABLE
Click to expand...
Click to collapse
well for one your s3 is from T-mobile so you can't really download Odin flashable roms from here on the Sprint S3 forum the only help i can give is go to the T-mobile s3 forum and it sounds like you might have a bad cable try with another one or a different PC
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Did you try using Odin 3.07? Not sure if it will make a difference but I have always had good luck with Odin 3.07.
Try flashing again but do not check auto reboot, only check F.reset time. Flash the ROM. When you see Reset in the status window, disconnect the USB cable, pull the battery, wait about 10 seconds, replace the battery, boot into recovery, do a factory wipe, and reboot.
verapakill said:
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
View attachment 3062724
Click to expand...
Click to collapse
Are you working ??
This should help. You already did part #1
http://forum.xda-developers.com/show....php?t=2618447
Flash recovery if phone won't boot to recovery
Tapatalked from my PACMAN 4.4.4 Note II
Hi, I tried to use Odin to root my Galaxy Tab 3 GT-P5210 (Build KOT49H.P5210UEU0CNK1), and it said "Passed" on Odin, but my tablet is now stuck on the "Samsung Galaxy Tab 3" startup screen (it won't boot). Is there a way to remedy this? Also, I can't seem to download any TWRP files, it gets blocked by the antivirus saying that a virus has been detected in the file. The only other option I can access is when I press Volume Down and Power at the same time, it goes into ODIN Mode on my tablet.
Thanks
Try to flash bootloader (BL) with Odin, CSC is not needed but it doesn't hurt to flash it with BL.
In this file, CSC (Country/Carrier Specific Code) is for US region
http://www.mediafire.com/file/c224oin6adfqisg/GT-P5210(2).rar
If it doesn't work, try to flask BL, and AP with Odin.
The stock ROM ( AP ) is here, and Cellular South is for US region
https://www.sammobile.com/firmwares/database/GT-P5210/
I rarely fail when flash Stock Rom with its bootloader ( BL )
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Hi
Is it still possible to root my Tab 3 P5210? And then flash a custom rom of android 6 upwards?
It currently runs on android 4.4.2 but im not sure if that was the version it was purchased with originally. I tried recently when i followed instructions from another thread on here but i soft bricked my device (same as OP - passed on odin, tab stuck on loading screen), although i did recover it back to its previous state eventually. I was using the latest Odin V13, but im not sure if the version of android or odin version needed to be specified for using the right apk files?
Hi Guys
Please help, i was trying to flash TWRP and to root my fone with magisk. After flashing Magisk with ordin my phone is now stuck. I cant switch it off nor boot into recovery mode to flash a new OS. It's stuck on a menu that says this:
RECOVERY IS NOT SEANDROID ENFORCING
Set Warranty Bit: recovery
ODIN MODE(HIGH SPEED)
PRODUCT NAME:SM-J610F
CURRENT BINARY:Custom
SYSTEM STATUS:Custom
FRP LOCKFF
OEM LOCKFF
WARRANTY VOIDX1(0X30C)
......
download mode !!
Please see attached
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
for what the screen looks like forgive me for the poor quality camera.
Has anyone ever encountered such a problem and how can i flash a new recovery or OS onto because currently in that mode the PC doesn't recognize it.
:crying:
micthaworm said:
Hi Guys
Please help, i was trying to flash TWRP and to root my fone with magisk. After flashing Magisk with ordin my phone is now stuck. I cant switch it off nor boot into recovery mode to flash a new OS. It's stuck on a menu that says this:
RECOVERY IS NOT SEANDROID ENFORCING
Set Warranty Bit: recovery
ODIN MODE(HIGH SPEED)
PRODUCT NAME:SM-J610F
CURRENT BINARY:Custom
SYSTEM STATUS:Custom
FRP LOCKFF
OEM LOCKFF
WARRANTY VOIDX1(0X30C)
......
download mode !!
Please see attached for what the screen looks like forgive me for the poor quality camera.
Has anyone ever encountered such a problem and how can i flash a new recovery or OS onto because currently in that mode the PC doesn't recognize it.
:crying:
Click to expand...
Click to collapse
Not really making sense, did you install TWRP or not and if you did why did you install magisk with ODIN instead of TWRP?
Also what attachment?