Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Did you try using Odin 3.07? Not sure if it will make a difference but I have always had good luck with Odin 3.07.
Try flashing again but do not check auto reboot, only check F.reset time. Flash the ROM. When you see Reset in the status window, disconnect the USB cable, pull the battery, wait about 10 seconds, replace the battery, boot into recovery, do a factory wipe, and reboot.
verapakill said:
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
View attachment 3062724
Click to expand...
Click to collapse
Are you working ??
This should help. You already did part #1
http://forum.xda-developers.com/show....php?t=2618447
Flash recovery if phone won't boot to recovery
Tapatalked from my PACMAN 4.4.4 Note II
Related
When I tried to root the phone earlier, it quit the odin transfer in the middle of the Cache write, and then rebooted to the soft-brick screen
of "Firmware Upgrade encountered an error, please select recovery mode in Kies"
At the bottom, in bright yellow letters on that screen it said "Set warranty bit: Cache"
Basically, the phone was soft-bricked, so I used Kies to put stock 4.3 back on the phone, but now that stock is on it again, whenever the
screen times out, I have to reboot to get the screen to turn on. And on top of it all, Knox wasn't triggered, neither was the Device status,
but it says that the binary status is modified. I'm honestly stumped as to what to do, guys.
That screen will still work in Odin
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Download the .tar use a different sub cable and Sun port
sent from my ??????? note 3?
deeznutz1977 said:
That screen will still work in Odin
Download the .tar use a different sub cable and Sun port
sent from my ??????? note 3?
Click to expand...
Click to collapse
Will it trip Knox if I use Odin? And it's on stock currently via Kies, it just doesn't turn the screen back on if it's been locked for a few minutes
THANK YOU SO MUCH FOR THE PROMPT REPLY! I really do appreciate your help!
Daltonyx said:
Will it trip Knox if I use Odin? And it's on stock currently via Kies, it just doesn't turn the screen back on if it's been locked for a few minutes
THANK YOU SO MUCH FOR THE PROMPT REPLY! I really do appreciate your help!
Click to expand...
Click to collapse
No it won't trip knox
sent from my ??????? note 3?
Hi guys,
Looks like my phone's in deep sh*t right now. Here's the story.
I'm coming from Criskelo rom JB 4.1.2
I wanted to try another rom and found this [ROM][4.3][NA1][9/2/14]►Xperia-Z-ized™ and i thought, this looks cool and wanted to try it out.
Managed to install the ROM perfectly, Phone works and everything but then the Wifi isn't working so i did what was told, to use the bootloader patch by Dr.Ketan. This was in the FAQ's 2-3 post below the Rom screenshots.
Extracted the file, put my phone in Download mode and connected in Odin. according to Ketan, use the PDA tab so i used that to locate the bootloader patch. started Odin, i think i was waiting for a good 5 minutes but the process still hasn't completed. still waited for 10-15 minutes more to find out that my pc is actually frozen. so i disconnected my device and restarted my pc.
F*ck now my phone is showing this. Please Help, what should i do? It's not going to Philz recovery mode but i can go to Download mode (Vol down + Home + Power). I'm definitely not downloading Kies as i know it disrupts Odin in someway.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Thanks in advance, I hope i can still use my Phone
Flash stock firmware and start again once up and running
pearlpassat said:
Flash stock firmware and start again once up and running
Click to expand...
Click to collapse
thanks for replying! how do i do that though, through Odin i suppose.
Yes matey, download the correct firmware from Sammobile and you are good to go.
i was using cm11 with nebula kernal,,,i have even incresed internal memory...now i wanted to go back to stock firmware like bmk3,,,i flashed it via odin but it doesnt auto reboot even it was marked in odin,,,,,i showed some errors see attachement...
when i clicked on reboot it got stuck on logo....pls help...
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
1) Dont put "fast" word lol... people will view and move... hehe...
2) i was having different problem, when i ticked re-boot it rebooted and than after reboot my mobile was not rooted... and after 5 mins of switching on ODIN was showing PASS...!
so it is not about re-boot, try like this... Un-tick reboot and as the process is done.. remove battery and than switch on your mobile yourself..( i mean after placing battery again )/// if this dont help.. let c any other has answer for this:angel:
datasai7755 said:
i was using cm11 with nebula kernal,,,i have even incresed internal memory...now i wanted to go back to stock firmware like bmk3,,,i flashed it via odin but it doesnt auto reboot even it was marked in odin,,,,,i showed some errors see attachement...
when i clicked on reboot it got stuck on logo....pls help...
Click to expand...
Click to collapse
As u have changed partition sizes now u have to supply PIT file in ODIN. Get the PIT and ODIN from this Post. Once the ODIN shows pass, remove battery, enter recovery, wipe data/factory reset and wipe cache.
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
verapakill said:
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
View attachment 3062723
Click to expand...
Click to collapse
Is the phone still turning on? If so maybe try booting into recovery first and wiping all data before flashing stock rom again with odin?
I tried that. I have been able to get the phone to boot but as soon as it restarts it goes right back into a bootloop. Try wiping again and restarting with the same results. Stuck in a boot loop on the first Samsung screen.
I have my cousin's phone right here - just yesterday he tried to update to Lollipop. He was on stock TouchWiz, no root or anything of the sort and installed the update.
Now, if I try to turn on the phone, all I get is this screen and it just stays there forever:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
If I try to boot into the bootloader, all I get is this: https://goo.gl/photos/WBSAcHhALQ9Jmz2n9
I really don't know what I would do here - can you do anything once your bootloader is f*ed up?
If it helps, the phone's model is SM-N7505
Yes, the same issue happened with me today on Note3 Neo. I rebooted the phone and it stuck on the same place. Checked in local phone repairing shop unable to make hard reset. They are suspecting of hardware issue. What could be the coz of this?
vadsvads said:
I have my cousin's phone right here - just yesterday he tried to update to Lollipop. He was on stock TouchWiz, no root or anything of the sort and installed the update.
Now, if I try to turn on the phone, all I get is this screen and it just stays there forever:
If I try to boot into the bootloader, all I get is this: https://goo.gl/photos/WBSAcHhALQ9Jmz2n9
I really don't know what I would do here - can you do anything once your bootloader is f*ed up?
If it helps, the phone's model is SM-N7505
Click to expand...
Click to collapse
Try flashing the rom using odin
ismaadu78 said:
Try flashing the rom using odin
Click to expand...
Click to collapse
How would I do that without being able to access the bootloader? I haven't done much with Samsung devices yet, only with my HTC phones. I've heard of the name ODIN though... Are there any tutorials you can recommend?
You don't need bootloader to flash stock rom via Odin, you only need to access Download mode (vol. down+home+lock). You can look up tutorials on YT. Just type "How to flash stock Samsung rom using Odin". Hope that helps somehow