i was using cm11 with nebula kernal,,,i have even incresed internal memory...now i wanted to go back to stock firmware like bmk3,,,i flashed it via odin but it doesnt auto reboot even it was marked in odin,,,,,i showed some errors see attachement...
when i clicked on reboot it got stuck on logo....pls help...
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
1) Dont put "fast" word lol... people will view and move... hehe...
2) i was having different problem, when i ticked re-boot it rebooted and than after reboot my mobile was not rooted... and after 5 mins of switching on ODIN was showing PASS...!
so it is not about re-boot, try like this... Un-tick reboot and as the process is done.. remove battery and than switch on your mobile yourself..( i mean after placing battery again )/// if this dont help.. let c any other has answer for this:angel:
datasai7755 said:
i was using cm11 with nebula kernal,,,i have even incresed internal memory...now i wanted to go back to stock firmware like bmk3,,,i flashed it via odin but it doesnt auto reboot even it was marked in odin,,,,,i showed some errors see attachement...
when i clicked on reboot it got stuck on logo....pls help...
Click to expand...
Click to collapse
As u have changed partition sizes now u have to supply PIT file in ODIN. Get the PIT and ODIN from this Post. Once the ODIN shows pass, remove battery, enter recovery, wipe data/factory reset and wipe cache.
Related
Hi guys,
Looks like my phone's in deep sh*t right now. Here's the story.
I'm coming from Criskelo rom JB 4.1.2
I wanted to try another rom and found this [ROM][4.3][NA1][9/2/14]►Xperia-Z-ized™ and i thought, this looks cool and wanted to try it out.
Managed to install the ROM perfectly, Phone works and everything but then the Wifi isn't working so i did what was told, to use the bootloader patch by Dr.Ketan. This was in the FAQ's 2-3 post below the Rom screenshots.
Extracted the file, put my phone in Download mode and connected in Odin. according to Ketan, use the PDA tab so i used that to locate the bootloader patch. started Odin, i think i was waiting for a good 5 minutes but the process still hasn't completed. still waited for 10-15 minutes more to find out that my pc is actually frozen. so i disconnected my device and restarted my pc.
F*ck now my phone is showing this. Please Help, what should i do? It's not going to Philz recovery mode but i can go to Download mode (Vol down + Home + Power). I'm definitely not downloading Kies as i know it disrupts Odin in someway.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Thanks in advance, I hope i can still use my Phone
Flash stock firmware and start again once up and running
pearlpassat said:
Flash stock firmware and start again once up and running
Click to expand...
Click to collapse
thanks for replying! how do i do that though, through Odin i suppose.
Yes matey, download the correct firmware from Sammobile and you are good to go.
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
verapakill said:
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
View attachment 3062723
Click to expand...
Click to collapse
Is the phone still turning on? If so maybe try booting into recovery first and wiping all data before flashing stock rom again with odin?
I tried that. I have been able to get the phone to boot but as soon as it restarts it goes right back into a bootloop. Try wiping again and restarting with the same results. Stuck in a boot loop on the first Samsung screen.
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Did you try using Odin 3.07? Not sure if it will make a difference but I have always had good luck with Odin 3.07.
Try flashing again but do not check auto reboot, only check F.reset time. Flash the ROM. When you see Reset in the status window, disconnect the USB cable, pull the battery, wait about 10 seconds, replace the battery, boot into recovery, do a factory wipe, and reboot.
verapakill said:
Like my title says I have a i317 Note II on AT&T. It was bricked a while back I tried factory reset which sent it into a boot loop until the battery drained now it is just a brick and wont start but past the Samsung logo.
I ran Odin v3.09 with a Pass but the phone is still doing the same thing. Not sure where to go after this. Do I need to run a new bootloader file? Any help would be great.
These are the files I ran with it:
i317.pit
I317-UCUBMK6.tar.md5
View attachment 3062724
Click to expand...
Click to collapse
Are you working ??
This should help. You already did part #1
http://forum.xda-developers.com/show....php?t=2618447
Flash recovery if phone won't boot to recovery
Tapatalked from my PACMAN 4.4.4 Note II
hello I don't speak English very well , but I 'll make it short ! I made a bad flash of the rom on my phone with command -line ADB , because my "HOME" button is out of order ! my phone start on the logo galaxy note 2 N7100 (see picture) , and don't stop to boottloop over and over again !
How can I fix this and make another correct flash to make my phone work again .?? i will appreciate any help to get me out of it
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
turn it off and get your self a USB JIG, try searching on google on how to make one and on how to use it. flash it back to stock rom, once u are done and u want to either flash using CWM, install terminal app and type SU, then reboot recovery if you want to get to bootloader, then type reboot bootloader
[email protected] said:
turn it off and get your self a USB JIG, try searching on google on how to make one and on how to use it. flash it back to stock rom, once u are done and u want to either flash using CWM, install terminal app and type SU, then reboot recovery if you want to get to bootloader, then type reboot bootloader
Click to expand...
Click to collapse
i've already used a jig usb , 5 or 6 years ago
it will solve my problem without my "HOME" button .?
So, I really wanted to get the phone rooted, and I couldn't do it without a recovery, because I can't find the firmware for it no matter what, there is only firmware for 5059d, so when I flashed TWRP for 5059d, it was asking for a password, but I didn't have one. I made one, but TWRP didn't let me mount internal storage. I tried factory reset and it made it even worse, it showed me this image
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I tried factory reset but didn't help, then I tried to flash 5059d stock recovery, it worked, but now it does not even want to boot into system, I have tried Wipe data/Factory reset, didn't help. I am stuck now. I did try to flash stock firmware for 5059d, but I can't do it for some reason, SP flashtool throws me some ERROR : STATUS_BROM_CMD_FAIL /0xC0060005) error. I really don't know what to do now, if someone knows to help me, it would be preety cool . This is not my main phone, but I really want to get it fixed. Screw rooting now.
Where did you get the ROM?
DerivativeOfLog7 said:
Where did you get the ROM?
Click to expand...
Click to collapse
First Google search, phone is completely gone though so not worth investigating
BokeeXD said:
First Google search, phone is completely gone though so not worth investigating
Click to expand...
Click to collapse
Look at this: https://forum.xda-developers.com/t/...rom-a-5059d-to-unbrick.4598953/#post-88676529
May be worth a shot. If I were you I'd first try normally just plugging the usb cable in while the phone is off, and if it doesn't work, take it apart, unplug the battery, and then plug it in