I broke and replaced the screen in my unlocked upgraded flashed-ROM wallaby and the unit now starts up and reports invalid SIM.
Is there any solution or should I re-flash the rom again and see if that works, hope for the best?
Try the SIM in a different (unlocked) phone, to make sure the SIM isn't fried. If the SIM is fried, you can get a new one from your provider. SIMs do get fried sometimes -- it happened to me a couple months back. Fortunately my provider (Cingular) has a shop just down the road from me, and they burned a new SIM in 5 minutes.
I apologise, I should have said
Sorry, I should have said, it does work in another machine and as I said, it did work immediately I used the xda flashing process to upgrade the ROM in this very unit before I dropped it.
Everything else in the new ROM seems to work which makes it infuriating that it wont recognise the SIM. I even tried calling T-Mobile and asking them if they could see the SIM on their network and they couldn't.
(I even have one of those SIM copying devices they send you free for some unknown reason when they want you to upgrade your service to some kind of higher level SIM card. I was wondering if I should try to use it again but as mine does work, this, like the whole copying device, seemed a bit academic)
Hey everybody, I´ve been having more problems than anticipated with my Dinc2. Basically what happened was this:
I had a phone that I bought new, unlocked, and used on the GSM network this past summer while abroad. (Verizon). However, I had dropped it to the point where the audio jack ceased to work and thus had to take it back in November for a replacement under the Best Buy warranty.
Now, in November I jailbroke the phone again, and I still have the code that I used to do it. Or at least I think I did it successfully, because I never checked with a real SIM card. After (possibly) getting rid of the SIM lock, I rooted, got S-off and flashed the radio following the instructions here, which had been working great for the past few months in the US (CDMA). Now I´m running MIUI on Android 2.3.5 and the baseband version is 20.27W.30.0811U_1.09.01.0622 and a kernel of 2.6.35.14.
Now I´m abroad again, working in Spain for the next several months. My first issue occured when I arrived and tried to use an SD card. Guess what! It would appear there´s a sim card lock. It doesn´t recognize sim cards when they are inserted, nor does the unlock code I got back in November unlock the phone.
It gets better.
The phone doesn´t show an IMEI number, nor is there an IMEI number on the sticker on the back of the phone-just a Serial Number and an MEID. Also, since it was a replacement phone under warranty it was probably a refurb, and I don´t have any other packaging on which the IMEI could appear. As a result I have no friggin´ clue how to get the lock off and allow me to use the 3g network as before.
Should I try flashing the stock rom and radio, or just the stock RUU, and see if I can get the unlock code to work?
Or is it hopeless and in that case should I give up and buy a ****ty candy bar phone?
Thanks in advance!
authorama said:
Hey everybody, I´ve been having more problems than anticipated with my Dinc2. Basically what happened was this:
I had a phone that I bought new, unlocked, and used on the GSM network this past summer while abroad. (Verizon). However, I had dropped it to the point where the audio jack ceased to work and thus had to take it back in November for a replacement under the Best Buy warranty.
Now, in November I jailbroke the phone again, and I still have the code that I used to do it. Or at least I think I did it successfully, because I never checked with a real SIM card. After (possibly) getting rid of the SIM lock, I rooted, got S-off and flashed the radio following the instructions here, which had been working great for the past few months in the US (CDMA). Now I´m running MIUI on Android 2.3.5 and the baseband version is 20.27W.30.0811U_1.09.01.0622 and a kernel of 2.6.35.14.
Now I´m abroad again, working in Spain for the next several months. My first issue occured when I arrived and tried to use an SD card. Guess what! It would appear there´s a sim card lock. It doesn´t recognize sim cards when they are inserted, nor does the unlock code I got back in November unlock the phone.
It gets better.
The phone doesn´t show an IMEI number, nor is there an IMEI number on the sticker on the back of the phone-just a Serial Number and an MEID. Also, since it was a replacement phone under warranty it was probably a refurb, and I don´t have any other packaging on which the IMEI could appear. As a result I have no friggin´ clue how to get the lock off and allow me to use the 3g network as before.
Should I try flashing the stock rom and radio, or just the stock RUU, and see if I can get the unlock code to work?
Or is it hopeless and in that case should I give up and buy a ****ty candy bar phone?
Thanks in advance!
Click to expand...
Click to collapse
I had a similar scenario while I went to NZ. I thought I unlocked my phone prior to leaving, but didn't. I called verizon tech support and got a new code, plugged into the settings and then I was able to insert the prepaid SIM I bought. Here is the non 1-800 number for you to call (I had to get my brother-in-law to call them and get a non 1800 number because it is not listed on their website): 1-908-559-4899.
Try that and hopefully they can get you a new code to use. Good luck.
brymaster5000 said:
I had a similar scenario while I went to NZ. I thought I unlocked my phone prior to leaving, but didn't. I called verizon tech support and got a new code, plugged into the settings and then I was able to insert the prepaid SIM I bought. Here is the non 1-800 number for you to call (I had to get my brother-in-law to call them and get a non 1800 number because it is not listed on their website): 1-908-559-4899.
Try that and hopefully they can get you a new code to use. Good luck.
Click to expand...
Click to collapse
I just talked to Tech support today and got an unlock code... it´s not working however. I´ve put in a card, and it doesn´t show up. When I go to the SIM Lock under Options>Security, it says the code I enter is incorrect. Also, the phone shows no signal. Could it be that I just flashed a bad radio that supported CDMA and not GSM? Or is it something with MIUI? I was pretty certain that both the radio and the ROM were fine for GSM networks...
Re: [Q] No GSM? I thought I unlocked it!
authorama said:
I just talked to Tech support today and got an unlock code... it´s not working however. I´ve put in a card, and it doesn´t show up. When I go to the SIM Lock under Options>Security, it says the code I enter is incorrect. Also, the phone shows no signal. Could it be that I just flashed a bad radio that supported CDMA and not GSM? Or is it something with MIUI? I was pretty certain that both the radio and the ROM were fine for GSM networks...
Click to expand...
Click to collapse
Try bonestock. That's what I ran.
Sent from my ViperDinc
brymaster5000 said:
Try bonestock. That's what I ran.
Sent from my ViperDinc
Click to expand...
Click to collapse
I got that to work. Thank you! I later installed CM7 to try it out and surprisingly enough that didn´t work.
AOKP did for me-although they are both confirmed to be working with GSM? Anyway, I realized I never flashed gapps with the AOKP, so I tried to flash with the latest version (no coffee, late night) and ended up tweaking the install. Anyway, I re-flashed and I have to say that this setup (AOKP with Nova) is the slickest setup I´ve ever used! It´s been an intense couple days flashing ROM´s, reading about all the stuff that kept popping up, but then end result is so worth it!
Anyway, I´m off to go caress my telephone...oh yes.
authorama said:
I got that to work. Thank you! I later installed CM7 to try it out and surprisingly enough that didn´t work.
AOKP did for me-although they are both confirmed to be working with GSM? Anyway, I realized I never flashed gapps with the AOKP, so I tried to flash with the latest version (no coffee, late night) and ended up tweaking the install. Anyway, I re-flashed and I have to say that this setup (AOKP with Nova) is the slickest setup I´ve ever used! It´s been an intense couple days flashing ROM´s, reading about all the stuff that kept popping up, but then end result is so worth it!
Anyway, I´m off to go caress my telephone...oh yes.
Click to expand...
Click to collapse
Cool. Glad to help.
Sent from my ADR6350 using xda app-developers app
Hi everyone, yesterday evening I decided to attempt to unlock and root my phone but during the process I had to go, so, I interrupted everything just after sending the token ID to HTC Dev, but I didn't flash anything on my phone. (I didn't disconnect the phone without having shouted it down from bootloader)
After that my Hox can't lock the signal and so I can't send/receive sms, nor phone calls, plus, my gps stopped working. I already hard resetted the phone but nothing changed,
I'm thinking about returning it back to HTC for the warranty because I doubt that I did something that could have damaged the phone without flash anything on it, do you thing I messed something and I can solve it by myself or should I claim for wharranty beleving it's all a mere coincidence?
thanks!
If you didn't unlock the bootloader, your warranty should be intact. You'll get it fixed for free.
Sent from my One X
TToivanen said:
If you didn't unlock the bootloader, your warranty should be intact. You'll get it fixed for free.
Sent from my One X
Click to expand...
Click to collapse
I hope so, tomorrow in the moarning I'm going to call HTC obviously omitting the unlock attempt part that's quite a coincidence however!
After some calls it seems the old owner of my phone stopped paying for it and now my imei is blocked here in Italy...
My options now is to use it as a media player or to sell it abroad...
I recently bought another glide on ebay (my old one met with a...rough end) in supposed "Manufacturer Refurbished" condition. The phone looks great, and I quickly rooted and installed a custom rom on it (without ever plugging in my SIM / SD card first) and finally was ready to put my SIM card in. However, the phone seemed to have signal only for a few seconds and then ceased to have ANY signal.
Regardless of ROM, fumbling with the SIM card, doing the "tape trick" to get better contact, the phone doesn't seem to want to work.
I noticed that with the SIM in, the phone claims to have a signal (something like -111) and Mobile Network Type will say things like "HSPA", which implies that something is at least part way working. Service State says "Out of Service" or something though.
My IMEI is fine by the way. I'm flashing back to stock EVERYTHING at the moment to see if it'll help.
Any ideas guys?
UPDATE: Stock ROM flashed through ODIN is still broken. And I think the "signal" I saw for a few seconds was actually wifi...so, I'm going to open a case on ebay I suppose after talking to the seller.
Hi XDA users.
My problem is just same as this thread's title.
A few months ago,
suddenly I had an idea which try to disassemble my Xperia Play.
So I did that and consequently one part of touch screen couldnt work normally.
So I decided to repair it and it has been repaired.
But another problem was happened...
First, the speakers didnt work.
At that time I flashed Gin2Kitkat.
Though I flashed any other ROM, they havent worked still now,
I think the reason of this problem isnt software but hardware,
The only solution seems to replacing this part.
Moreover it cant connect network.
In my country there are two carriers which I can connect with my Xperia Play.
But though I selected one my SIM card support, it couldnt get any network.
However SIM card itself isnt wrong.
Because it worked normally when I put it another device.
I want to repair it.
But I dont know what should I replace component.
It is main board?
Also I wonder whether there is a way I can buy it.
For reference if there is any item in eBay, I can purchase it.
Thanks.