Develop Bugs

Navigation button problems... Any1 else having them?

I don't know if it's coincidence, but ever since I upgrade to WM5 and went back to WM2003SE, my navigation button has not worked the same.
For example, a lot of times I can go right, but can't go back left even after multiple presses, and then most of the time the middle or 'Enter' button doesn't do anything. Itz become extremely annoying because I have lost my 4th stylus by now, and I haven't received my new ones yet. Oh, and I can't play MorphGear right anymore.
Is it just hardware? Cuz I first went to ROM v.1.42 and then went to 1.40 to see if it was a problem with the new ROMs, but I still have the same problems. Any one else having these issues, and has any one fixed it??
UPDATE: WTF!! Now it went from bad to worse. Yesterday, when I left my BA at home, once I returned from work I noticed that PIE was constantly opening over and over again. Then some of the buttons wouldn't respond like the POWER to turn it off. The backlight pretty much stayed lit the whole time because it looked like the keys were stuck. I upgraded to WM5 derived from the Himalaya today and now the START menu comes up almost every 5-8 seconds, followed by a real quick succession of multiple "clicks", and my 'Start' button doesn't seem to be responding.
Can anyone help? Has my BA gone to the state of retardation? Is there a way to bring it back??

How did you go with this problem.
Mine is doing similar ever since a low battery problem.
DLC

I am experiencing the same kind of problem... and it happend after upgrade to WM5. But the problem likely to be caused by hardware.

I had problems with my phone opening up the start menu, opening IE, and closing programs immediately after opening them, Of course I had dropped the phone halfway in a cup of ice water, but immediately after tossing it in water (after hanging up, I simply dropped the phone into the cup-holder I have mounted below my stereo which happened to be occupied by a glass of ice-water I placed there without remembering) I shook the water out of the phone, and for about as much as i could stand the heat, I put a hair-dryer to the end of my phone which i pryed open after removing as many screws as i could. After a day of quirky behavior, and a night of having the battery seperated from the phone, my phone is back to its old self with the water-damage seal unnaffected after missing the line of water by just a few milimeters. I suggest going to Settings>Buttons and making every button perform no function at all followed by going to Settings>System>Button Lock and having all keys locked except your power button. Hope this helps!

Having somewhat the same issue. Only the "Down Navigation button" isn't working. Although, I'm still using Windows Mobile 2003 SE. Is there a DIY fix for this?

bump...
any suggestions?

Navigation Up/Down
Mine isn't working either - is this a hardware fault?

trying pressing down a bit harder. coz when i did that for mine, the "down" button works. normal applied pressure as for the rest of the buttons(left/right/up) does not seem to work with the "down" button, but a bit more force would make it work.
this happens to my IIs.. mebbe u can try.

Button problems
After no trauma or dunks in water several of my buttons have gone awry. My green phone button, red phone button and navigation buttons all open contacts. The green phone button activates voice command at the same time that it opens contacts. I've never switched from WM2003SE. I've checked the buttons settings and they are the same as always. Most bizarre of all is that my battery is quickly discharging. I suspect some software process is running hard but don't have any idea where to start to fix this. Soft resets have not helped.

buttons gone crazy
A hard reset fixed the problem but was a typical pain to get everything back going. Sprite backup works great until the first attempt to ActiveSync with your PC.

Orbit not loading

help, i was trying to install a program and it wasnt working so thought i would do a reset, so went onto the 'clear storage' bit on the phone, and got it to reset,
the phone turns off
go to start it
it comes up with O2 start up screen and it just stays like that
googled doing a hard reset, so put the styles in the small hole and press the two soft keys, took out the stylus while still holding the soft keys, its now come up with red, green and the along the screen
no matter if i restart or try to hard reset it it still either comes to the coloured screen or the o2 screen
how can i kick it back into action

did you install a dodgy rom?
cause hate to say this man but at the moment there is no fix that costs let then £40
Imei-check.com
or wait till O2 release a new rom

How do I get out of the tricolour screen, please?

My Touch Pro 2 kept reverting to the TouchFlo home screen within a couple of seconds of opening other applications (eg. click on a new email, and a second later it goes to TouchFlo. Soft resets didn't make any difference: nor did disabling TouchFlo (from the Settings/Today/Items menu) - it then just reverted to the Windows home screen instead. So I tried to hard reset the machine. I read that the way to do it is to hold send+end+power, but that didn't do anything. Some posts suggested that volume down+reset was the way to do it, so I tried that. I've now got a tricolour screen, which starts:
RHOD100 32M MI-BC
SPL-0.84.0000
A bit more searching suggests that this is the bootloader (?) screen that comes up when you want to flash a ROM, and I feel dangerously close to doing something expensive and irreversible. Any suggestions as to how to get out of this screen? Nothing obvious when I search the forums here. I was thinking of just taking out the battery. And any thoughts on how to hard reset - or how to stop deal with the original problem?
Thanks

You ain't going to mess anything up. You can flash a new rom from there though but there is no way to do it by accident. Don't you hard reset by holding down the green and red call buttons and soft reseting? I remember it being different from the Touch Pro 1.

you might head over to the rom section, read up on the "flashing your phone for the first time" thread. Answer is most likely in there.

Thanks for coming back so quickly guys. The ROM flashing thread didn't explain how to get out of the tricolour screen. Meanwhile I just took out the battery and that did the trick. I still couldn't hard reset using the send+end+power buttons as instructed here and in the manual. I was able to get to the Settings/System/Clear Storage menu and was eventually able to keep it open for long enough to enter "1234". That hasn't dealt with the original problem, though - switching back to TouchFlo after a couple of seconds in each application. It's also beeping incessantly. Any ideas?

It sounds like your device is registering a phantom End key press every couple of seconds. That would explain it popping you out to the home screen and the beeping. If your End key is indeed acting weird, that would also explain why you can't hard reset using the power+send+end key combination.
You should send it in for warranty replacement...

ohyeahar said:
...registering a phantom End key press every couple of seconds...
Click to expand...
Click to collapse
That makes a lot of sense, thanks. Now that you mention it I realise that it's the same kind of beep and the same result as the End key.
I've only had it for 2 months. I'll get on to HTC.

Uh OHHHH

After devunlocking last night, now my phone is messed up
The problem is the back,windows and search button no longer work, the portion of the screen that they take up is now like an extension of thescreen it just selects stuff as if it were at the bottom of the screen. Any help to reset all the files in root to factory, I tried to hard reset and soft reset.
Maybe I screwed up the registry or some files. Thanks for any help

try factory reset. hold camera + volume down + power. when phone vibrate release power button while holding the other 2 buttons. should prompt you to reset your phone. hope that works

Thx
I tried that but it enters USB Host mode, I also tried holding down up and down volume and power button to reset which resets it but doesn'tfixmy problem. it's acting like the part of the screen where the windows, search and back button are are now part of the regular screen and those 3 buttons no longer do anything.

This sounds rather like a hardware error. Your calibration of the touchscreen is messed up. I suggest you send it in. You still should have warranty?!
Btw. I don't think this has a connection to unlocking the phone!

If the phone hasn't been tampered with physically, it should be enough to just sync it without re-unlocking it, and it should be locked again.

Thx
I got a new one on the way. I didn't delete any files or regedit a bunch of stuff just a standard dev unlock and it started acting squirrly.

Problem with power and volume down buttons

Hi everybody,
I have sometimes a strange problem :
- the volume down button doesn't work anymore.
- I can't use the power button to turn on / off my phone, but it works as I can press it 3 times to open camera. On the contrary, I can't use it to ask for reboot, but it works for soft reset! Aaaaaarrgh! Brain pain!
When I try to soft reset, my phone enters in safety mode, as if I pressed the volume down button during restart.
In bootloader, I can't use power and volume down button. Quite annoying.
Sometimes, volume is turning down without pressing any button.
But what is weird is that my phone shifts from normal state (all buttons working) to defect state and back to normal state again without doing anything. It's unpredictable. It can work well for decades, then stops working fine for hours or days then back to normal.
Sometimes, when it works well, when I'm using it, it goes wrong without doing anything. I'm reading my favorite site and volume is suddenly going down. Without warning, without even touching a button.
I have to say one more thing. I picked up that phone from a coworker, and the volume button is a bit bent near volume up (picture needed?) but it worked fine for months before starting to mess.
I hope you'll be able to help me.
Sorry for my English, it's not my native tongue.

Seems to me like a hardware problem.
What I'd do honestly is to hit it repeatedly on a hard surface, but please, do not do that
If you can I suggest taking it apart and making sure all the ribbons are firmly set in place and undamaged. It can be an one way ticket for damaging the phone for good though, so wait for other suggestions too.

Thanks for your answer.
What is making me angry is that it also does this when left alone on the table : I let it there working perfectly and when I pick it up again, it fails.
And when it fails, once again I let it alone and suddenly the volume goes down, without even touching it. Raging.

its a hardware problem, u have to change the volumes and power flex, had the same problem with the powern button, i turn the phone off, and a few secons later it power on by himself till i change the flex

Did you take the phone apart recently? I had my battery replaced and that's when my Volume up started phantom pressing. I hit the phone repeatedly on a flat service and made sure to kind of slap it so it would impact kinda evenly as to not dent the case, it worked for about a week at a time, then I just took the phone apart and tried to align everything and made sure all the insulation tape was flat and and not bunched up and now it's fine. We'll except my USB port has got some giggle to it. Order a new USB of amazon for like $9, I'm trying to hold out for a LG V30