CE-Star wm2003 version installed on Touch HD ended in screen lockout ! - Touch HD Themes and Apps

Hi Guyz, Just bought a Touch HD and 1st thing i did was configure a 4 digit password. Since i live in china and Chinese for texting, i went on to try to install a old version of CE-Star (wm2003) on it, installation went fine, finally was prompted to do soft-reset, i did so, and then things went haywire, after coming out of reset the device diasplayed the initial password screen came up, realized that i cannot type in screen (totally un-responsive) and nor clicking on below 4 hardware butons causes any effect. I cannot enter into my device and hence cant do anything, stuck. Both Soft-reset nor even the Hard-reset surprisingly does not work (at wits end to get out of this dilemma, pls help). Pls help to resolve. Thanks.

if hard reset didn't work i think that this means that you have a faulty touch screen!
but i think you have not done Hard reset right,
do the following,
turn off the device
hold down vol up & vol down
press and release (only single click) the power button and wait for the instructions on the screen.
follow the instructions on screen untill the phone reboots.
i hope this will help

Related

Problem with BB 4.1 on my dopod M700!

After installing BB4.1 to my M700,it stop after the boot screen. Here is
the problem text: .....device started up failure due to sudden loss of power.......
Power : 100%
Anyone can help me?
I had that a long time ago with another rom so the memory is a little hazy.
The touch screen will be disabled, click the soft key under 'continue' or 'yes' (can't remember)
It should then boot up. You may then want to try and re-flash.
i had been try 4 times! when i press "yes" on that screen, it reboots and that screen appears again.
i am so unlucky . what a wonderful rom but i feel it!
reset holding the top left button. You'll go into the boot loader screen. Then Reflash
But the same rom the same problem. I have return to BB 4.0 and keeping waiting for an answer!

Help - Artemis doesn't boot / turns on

Since this morning I've got a serious problem:
My last flash was on February (Artemis touch 4.01). Everything worked fine till this morning. I turned the device off to change the sd card. After that I couldn't turn on the device (black screen).
I removed the battery for one hour - no luck.
After a hard reset it begins to boot, but on the first screen I only see 2 Version (IPL and SPL). After a while, for a millisecond I can see the version of GSM, than immediately the screen turns black. After a while the Charge LED turns on for a short while (without connected cable!). Then nothing.
I can get into bootloader and successfully flash the original shipped O2 GER rom, but after flashing the same.
Has anybody any ideas or do I have to send the phone for repair?
Regards
Andre
There are some posibilities:
1) The device has a serious damage. Could be flash memory or boot section of flash memory. In this case, repair could be useless or only done by service.
2) flash was not that successful you finally thought. To Access Bootloader you have to press Powerbutton and Voicebutton (other side) at the same time and press simultaneously the reset button. When Device is rebooting, press power an voice buttons at same time, several times until bootloader opens. See wiki, it worked for me.
3) flash WM6 image from HTC. This one accesses bootloader by itself and is easy. I don't know if this will work for you.
4) battery could have a damage. The battery of artemis is very damageable. maybe try to change against a new one, maybe with more capacity.

unknown problem

dear friends ,
my phone has shut down and only when you take out the battery and put it back in after which you press any button on the phone it comes on and shows the htc logo after which it displays the following
ipl 3.07.001
spl 3.07.000
gsm 02.69.90
os 3.7.0.0
remains on for about 5-6 seconds and goes off
have tried to enter the boot loader mode by pressing the record button and reset button but it continous to behave in the same manner as mentioned above .
also when i try to charge the phone it shows only a red light
hoping someone can offer a solution to my problem
thanks and regards
I'd also be interested to know about this as my MDA Compact III has just done exactly the same thing.
have you guys tried flashing...that could kill it if not done propertly....but i doubt,the led is on,splash screen appears...info appears...what were last few things you did
according to spl os and ipl you flashed artemis touch 4.02 if i'm not wrong...or maybe tom's v5...try reflashing the same rom or just try a hardreset
Interesting...I've recently flashed the same ROM (v4.02)
I am certain I followed all the instructions about USPL and its been working fine for about a week...then it just went blank!
Will try re-flashing and/or a hard reset.
Thanks for the advice.
mrd5477 said:
Interesting...I've recently flashed the same ROM (v4.02)
I am certain I followed all the instructions about USPL and its been working fine for about a week...then it just went blank!
Will try re-flashing and/or a hard reset.
Thanks for the advice.
Click to expand...
Click to collapse
well...if it worked i'm sure you installed some app or deleted some files...so the system doesn't work...
if so hr will help
dear friends,
took the device in for repairs the fault was with the power circuit board which had to be changed as`informed to me by the technician
i now remember a few months ago the power button stopped working and a few days before the phone went bad it would work intermittently but there was no spring in the button hence it would have to be pressed quite hard for it to work i feel that this loose power button caused the power circuit to fail also my sd card was spoilt and the same had to be replaced
cast me appx in usd 30 for the repairs
thanks

Help with HTC Touch Diamond, won't boot

Hello, this is my first post here. I tried to install Windows Mobile 6.5 as indicated in Gizmodo http://gizmodo.com/5281397/how-to-install-windows-mobile-65-right-now but it didn't work and now my phone won't boot.
The phone is an HTC Touch Diamond from Sprint. I followed all the steps indicated and everything look fine, but after installing the OS the phone displays the screen TOUCH DIAMOND, and then restarts and displays the same thing. I'm able to get into the boot loader (Tri color screen) and says:
DIAM500
SPL-0.57.CMONEX
MicroP-Diam (LED) vB
PSOC-Diam STAGE_EVT v20.
I don't know what to do now
Thanks
try to load back to default setting by pressing the power on button at the top of the phone, before the "Touch Diamond" logo come up, press and hold volume down button and the center button until the three color screen come out, then release the two button you are pressing..
if the problem still happen, that mean the rom you are using should have risk on it..
give it up and try other rom or flash it again..
hope my suggestion can help you solve the problem..
dont worry.
if bootloader is possible as you write
than you can flash all time orig. rom back.
Flash from Olinex 1.40 screen?
okokur said:
dont worry.
if bootloader is possible as you write
than you can flash all time orig. rom back.
Click to expand...
Click to collapse
Hi I have the same issue on my HTC Diamond. I flashed wm 6.5 and it was working fine, then it hanged on titanum weather. I reset and it stayed on the HTC Diamond page, I did hard reset and got the Olinex 1.40 3 color page. It does respond from serial to usb when I plug/unplug. Can I reflash without active sync?
Turns out I was able to flash, but both roms I tried work well on 1st install, but stay stuck on the Touch Diamond screen everytime I restart de device. Is it a problem with the radio not compatible , or is there a specific Hspl for each ROM???
I found solution for this problem. If your diamond won't boot go to bootloader mode and upgrade your radio http://modmydiamond.info/index.php?option=com_content&task=view&id=15&Itemid=26 and after that your dimond worked fine without loosing data.
try to hard reset the phone by pressing vol down key + the center button + reset button.
if the problem is still like dat..
try to install another rom..
davidwong007 said:
try to load back to default setting by pressing the power on button at the top of the phone, before the "Touch Diamond" logo come up, press and hold volume down button and the center button until the three color screen come out, then release the two button you are pressing..
if the problem still happen, that mean the rom you are using should have risk on it..
give it up and try other rom or flash it again..
hope my suggestion can help you solve the problem..
Click to expand...
Click to collapse
Thanks davidwong007 for your help, I was experiencing the same issue as op and your method did the trick. For a minute there I thought I had bricked my HTC Touch. I did step by step what you suggested and ended up in the rainbox screen, once I was able to do that, I knew there was a hope. i did a full factory reset of the phone and voila the phone fully booted, the pain in the butt touchflow loaded. Very important thing I forgot to do in the past is to back up my phone, after the restore you will lose everything on phone, except what is in the internal storage. Thanks again.

HELP....cannot turn on my mobile after flashed a new rom (Energy Rom) into my Diamond

I flashed a new rom (Energy Rom) into my Diamond before.
After power on.......
just "TOUCH DIAMOND" on the screen
and after few seconds....
"R 1.08.25.20
G 52.44.25.24U
D 2nergy ROM" (in red colour)
appear on the right bottom screen
then stop...
It cannot run window mobile6.5 now.........how can I do???
I cannot connect to PC .......
Have you tried to manually open the bootloader, connect it to PC and than flash another rom ? (maybe the original one will help)
i had the same problem with my pro. but my pro somehow fixed itself, i just kept pulling the battery out and wait a minute then put the battery back in and turn it on then like the 12th time it loaded up very slowly so i ran to my computer and loaded another rom. but i'm sure you tried that.
have you tried a hard reset, it's differnt from each carrier i think but it's something like hold the phone upside down and press the volume down button and then put your stylus in the reset button, idk if it will work but what can it hurt. but just rememebr there is a couple differnt ways of doing it and i think it's by the carrier.
Sorry to hear that..
I would recommend a hard reset first. Do that by reseting your phone using your stylus then immediately hold the volume down button and the enter button (the round center button on your dpad).
Keep holding them until you are prompted to hard reset. Follow the instructions. After the hard reset, if your phone still doesn't boot enter bootloader manually by reseting uing the stylus and hold down the volume down and the button with the backward arrow on your dpad. Keep holding until the phone enters bootloader. Connect your phone using USB to your computer and flash a new ROM. If no ROM works, the original should work.
Hope this helps. Good Luck.
I have same problem and hard reset helps to fix that...I recomend after that to change energy rom because it can happens again...

Categories

Resources