connection lost during flashing :( - P3300, MDA Compact III ROM Development

EDIT: I fixed it!!
I ran into a very old thread here....
I entered the bootloader and I flashed an official rom, after I downloaded it
I will keep this rom as a security from now on!
----------------------------------------------------------------------------------------------------------------------------------------------------
Hi everyone,
I have been enjoying all the roms you all gave to use many many years now.
Also I have been able to flash them without any problems....However this morning.... I was flasing a new version and during the flashing I knocked my phone of my usb-cable..... OUCH....
I am now trying to find a way to rectify this again, because now it will not boot, not recover, no nothing.
When I am in bootloader I cannot flash any roms (I have tried 7 different roms)
My Artemis P3300 is fully unlocked, but I cannot connect to active sync, nothing.
Will someone please guide me in how I can recover my phone and flash a rom again?
Can't do anything anymore, other then enter the bootloader, but flashing any rom will abort after 3%
Please be so kind as to help me out.
Thank you very much
Gianna xxx
--------------------------------------------------------------------------------------------------------------------------------------------------

repair frozen wm/ppc & flash rom again
just press the voice command & power button together[/B] and keeping the two button pressed together press the reset button together and then leave the reset button but continue keep pressing the voice dial & power button until the 4 band / 3 band colour mode appears.
( the reset button is found in a very small hole / but be careful , donot get confused with the microphone hole ).
when this 4 band / 3 band colour appears connect the active sync wire an connect to the computer.
you can find that in the mobile screen it will appear as usb.
i have really recovered my frozen htc p3300/ dopod p800 w
really thanks to xda developers... they are really genious/marvellous..
they can really do any thing ... three cheers to them.
hats off to them.

Related

O2 Atom does not start, Please Help

Hello Friends,
I have an O2 Atom device, which I recently picked up not even a month. I have tried to change the SIM card.When I switched it on again, Windows Mobile 5.0 startup screen came up and a white line dividing the screen into two and everything becomes white and goes into hang. I reset restart my device, and now it does not start all all.
Tried hard resetting the device by pressing on/off button + reset + call receive(green) + call end (red) button as suggested by O2 technical support, still nothing happens.
I have downloaed the latest patch, do not know how to install. Could you please help. Is it possible to flash the device without connecting to ActiveSync.
Please help, i am in a big problem , as I have lost all my contacts.
Please ..please..help.
Thanks in advance
Virtuoso[/b]
you can boot to bootloader (MN1) mode. if can'nt go to http://wiki.xda-developers.com/index.php?pagename=DeadBoot
goodluck.

Big problem with frozen screen and posible solution dont work, please help me.

First thank's for four help and read this thread.
The problem is:
My exca100 the last week work fine but the monday the exca reboot and frezeeng in green WM screen, i leaves it all night but it does not continue.
I try reflashing but the problem is, the image is corrupted (I cant unlock the exca, so that it does not initiate windows)
Can any one help me.
ONLB 1.30.0000
SPL 1.30.0000
Brightstar shiped 1.30.514.2
labtelcel said:
First thank's for four help and read this thread.
The problem is:
My exca100 the last week work fine but the monday the exca reboot and frezeeng in green WM screen, i leaves it all night but it does not continue.
I try reflashing but the problem is, the image is corrupted (I cant unlock the exca, so that it does not initiate windows)
Can any one help me.
ONLB 1.30.0000
SPL 1.30.0000
Brightstar shiped 1.30.514.2
Click to expand...
Click to collapse
what do you mean by( I can't unlock the exca)?
Hard Reset
Hard Reset will most likely solve the problem. I had the same problem.
TO HARD RESET:
-Turn off the phone
-Hold 2 soft keys
-press the power button for 3-5 seconds(still holding two soft keys)
-black screen will show up saying that pressing send key(green) will restore your settings to original settings.
-press send(still holding two soft keys)
-the end.
NB: YOU'LL LOSE YOUR PHONE'S DATA.
For Hard-Reset see sticky "a picture tells a million words"
The hard reset dont work, frezz in HTC screen I wait 2 hrs.
I dont want unlock, I want normal funcions.
labtelcel said:
The hard reset dont work, frezz in HTC screen I wait 2 hrs.
I dont want unlock, I want normal funcions.
Click to expand...
Click to collapse
Don't understand bolded?
You have tryed Hard-Reset not work, remove battery for about 5 mins and replace, try again "Normal boot then if not work try Hard-Reset"
Sorry for my poor english, Im from mexico.
I try the master reset many times it does not work, of several ways, extracting the battery for 5 minutes, 1 hr, 3 days, and it does not complete the reset, freeze in the htc screen, or another times in windows mobile logo screen.
When attempt to change the flash (for solving the problem) the process does not continue of 3%, this happens so I cant execute the jump USPL aplication.
In summary:
reset hard not work (hold 2 soft keys / turn on / black screen / send key)
Change the Rom for repair de damage not work (I cant load the aplication for jump USPL)
Write Rom direct in the bootloader (3 color screen) not work (hold camera button and tur on)
Any idea?
Change bootloader?
Another powerfull rom?
Special software?
Special combination to delete all in the internal memory without entering Romupdateutility locks or windows?
Please helpme to recover my excalibur.
this is so easy to fix,
your old rom now crashed, hardreset can't help you,
to repair,just download a new rom then open bootloader mode.
boss_of_any_phone said:
this is so easy to fix,
your old rom now crashed, hardreset can't help you,
to repair,just download a new rom then open bootloader mode.
Click to expand...
Click to collapse
Just shows sometimes can miss the obvious, bootloader in sticky & flash original ROM in stickys too..
Dont work the reflash in bootloader (try 10 times), I flash the rom and the phone frezz in the same screen (WM logo screen).
Help.

HELP....cannot turn on my mobile after flashed a new rom (Energy Rom) into my Diamond

I flashed a new rom (Energy Rom) into my Diamond before.
After power on.......
just "TOUCH DIAMOND" on the screen
and after few seconds....
"R 1.08.25.20
G 52.44.25.24U
D 2nergy ROM" (in red colour)
appear on the right bottom screen
then stop...
It cannot run window mobile6.5 now.........how can I do???
I cannot connect to PC .......
Have you tried to manually open the bootloader, connect it to PC and than flash another rom ? (maybe the original one will help)
i had the same problem with my pro. but my pro somehow fixed itself, i just kept pulling the battery out and wait a minute then put the battery back in and turn it on then like the 12th time it loaded up very slowly so i ran to my computer and loaded another rom. but i'm sure you tried that.
have you tried a hard reset, it's differnt from each carrier i think but it's something like hold the phone upside down and press the volume down button and then put your stylus in the reset button, idk if it will work but what can it hurt. but just rememebr there is a couple differnt ways of doing it and i think it's by the carrier.
Sorry to hear that..
I would recommend a hard reset first. Do that by reseting your phone using your stylus then immediately hold the volume down button and the enter button (the round center button on your dpad).
Keep holding them until you are prompted to hard reset. Follow the instructions. After the hard reset, if your phone still doesn't boot enter bootloader manually by reseting uing the stylus and hold down the volume down and the button with the backward arrow on your dpad. Keep holding until the phone enters bootloader. Connect your phone using USB to your computer and flash a new ROM. If no ROM works, the original should work.
Hope this helps. Good Luck.
I have same problem and hard reset helps to fix that...I recomend after that to change energy rom because it can happens again...

my first topic here i hope you reply soon

i don't own that device but i just installed the arabiezer for my friend's HTC S630 Cavalier and it worked but then the mobile restarted and i can't switch it on
i found that i installed the vox version which is not for this device :'(
so what to do how to install a stock rom or any rom to fix this hope you reply
samo_gf said:
i don't own that device but i just installed the arabiezer for my friend's HTC S630 Cavalier and it worked but then the mobile restarted and i can't switch it on
i found that i installed the vox version which is not for this device :'(
so what to do how to install a stock rom or any rom to fix this hope you reply
Click to expand...
Click to collapse
take the device to bootloader mode by the way while holding the camera button on the right side, press the power button. The phone will go into a mode "bootloader" and you'll see tricolor bootscreen. then connect usb to pc and reflash with stock rom ftp://ftp.xda-developers.com/Uploads/Smartphone/Cavalier/Shipped_Complete_Updates/Dopod/
Before re-flashing, a hard-reset will have the same effect. It removes any installed SW (but also all your personal data).
- Press left+right softkey and keep holding them
- switch on and keep above keys pressed
- wait until query appears (a few seconds)
- confirm (usually the green key)
Then you get a clean device as out of the box, however all contacts and data are lost.
Before doing such drastic thing, could you describe what happens exactly if you say "can't switch on"?!

[q] htc one m8: Very very urgent assistance needed please!!!

Hi there
I've been writing about my problem for days now and I still haven't sorted it out. I'm just making the problem worse everytime I read all these forums. I messed up. I rooted when I shouldn't have. I get that. Please, I beg one of you to help me.
I tried to load software this morning and it just died. Screen went back. It seeemed to have been hard bricked. But then on the XDA forum I read how to keep playing with the up down volume buttons and the power buttons and it sometimes goes on.
Mine came on and it seems to have gone to recovery / install / etc screen (big buttons). Whatever I select, it always shows restarting and then the screen dies again and I have to play with it again. Obviously the software is messed up.
What software do I load here at this screen? What do I select? Recover or install or what? Please guys, the phone is on sufficiently enough that HTC will be able to see the phone was rooted. So I won't be able to get them to help. I need your help. Please???
Shydzz said:
Hi there
I've been writing about my problem for days now and I still haven't sorted it out. I'm just making the problem worse everytime I read all these forums. I messed up. I rooted when I shouldn't have. I get that. Please, I beg one of you to help me.
I tried to load software this morning and it just died. Screen went back. It seeemed to have been hard bricked. But then on the XDA forum I read how to keep playing with the up down volume buttons and the power buttons and it sometimes goes on.
Mine came on and it seems to have gone to recovery / install / etc screen (big buttons). Whatever I select, it always shows restarting and then the screen dies again and I have to play with it again. Obviously the software is messed up.
What software do I load here at this screen? What do I select? Recover or install or what? Please guys, the phone is on sufficiently enough that HTC will be able to see the phone was rooted. So I won't be able to get them to help. I need your help. Please???
Click to expand...
Click to collapse
Can't you go to bootloader > fastboot and use RUU?
i had almost same problem and managed to do this .
connect phone to charger or to pc via usb , keep pressing power and volume up bottons , unless phone starts charging (with charging battery logo),it will take 1 minute or so , after that remove cable and push Volume down and Power button together, keep pressing for a few second and phone should boot in bootloader , then you can choose fastboot mode and do RUU method , or if you have custom recovery , you can install some rom with it or restore backup (if you have one)
1. Put your device in bootloader/fastboot mode and run command fastboot getvar all and post result here (minus serial no. & imei no.)
2. Which recovery is that (you mentioned big button), TWRP ?
Hey guys
Thanks for the responses. It was just too daunting for me, so I took it to a repair centre. They will load the stock htc software on it.
Thanks anyway
OK ... no problem ...that's what we're going to suggest to you too. We have almost all the files needed on XDA

Categories

Resources