Pressing the button power illumination from above vanishes and bodies enters into a sleeping mode? Calling on it the call passes and bodies does not react in any way though this button should translates in an economy effort of the battery and at a call or pressing any key to deduce it therefrom. When repeatedly I press on power on seconds 5 the green indicator around the speaker and any reaction joins. It is necessary to reboot it constantly. How to win this problem?
All thanks!
Can't understand smeagle/yoda talk...
Huh?!?!?!?
http://www.mobile-files.ru/forum/showthread.php?t=174553
Related
Thanks for reading the post...I am very frustrated with this device and want to see if ANYONE can help me...
First, the power button...I can turn the device on, but it will not turn the device off...it only lights on the screen backlight or turns the screen backlight off...I can't power it off, no matter how long I press it for...Therefore I have to take tha battery out to power off...which is not good for data!
Second, the backlight on battery level resets itself to 0 (thus a near black screen until I can get it into a bright light and go in and activate the backlight on battery level to 1 at least) Why is this doing this, and it only happens every 5-6 times I power the device on...
Thanks for your help everyone!!!
As far as I know, there is no way to actually power off the JasJar/Universal - it's always in a standby mode unless you pull the battery.
Not sure about your other issue though - sorry.
Cheers,
Steve.
It resets the backlight settings probably because it has "forgotten" your previous settings due to the way you "power off" your Universal. It is a phone, not a laptop, so it only goes into standby mode.
Sounds like you are pressing and holding down the power button for too long. To turn on/off the device, just tap on the power button once and don't hold it down. Hope that helps! :wink:
Hey everyone,
I have the push power button to end calls option enabled, but I have noticed bug with it.
When using the phone on spearkerphone, the screen still times out and turns black. Touching the screen or pushing the volume rockers does not wake the screen back up. So basically there is no way to add a call, bring up the dialer pad, etc. Pushing the power button obviously ends the call.
The way it should be designed: pushing the power button ends the call ONLY when the screen is up to your face (proximity sensor activated) or the screen is on.
Hi all,
does anyone sometimes have to press the power button (when phone is completely turned off) twice (2 presses to turn on) sometimes?...
so just to confirm
- handset is off
- push power button once (sometimes doesnt come on
- push for second time (and powers up)
im defiantly pushing for long enough
iv have no issues with the button at all when in the UI or when locking/unlocking display
iv done a few tests where i have turned off. then went to switch on, with the same pressure and sometimes it starts with one, sometimes it starts with two presses,
do u think this is a fault? anyone experience this? normal?
just checking...
thanks heaps!
I had the opposite on my first one. When I pressed the power button to turn screen off, the screen went black for 1 sec and jumped back on lock screen.
brodiecb said:
Hi all,
does anyone sometimes have to press the power button (when phone is completely turned off) twice (2 presses to turn on) sometimes?...
so just to confirm
- handset is off
- push power button once (sometimes doesnt come on
- push for second time (and powers up)
im defiantly pushing for long enough
iv have no issues with the button at all when in the UI or when locking/unlocking display
iv done a few tests where i have turned off. then went to switch on, with the same pressure and sometimes it starts with one, sometimes it starts with two presses,
do u think this is a fault? anyone experience this? normal?
just checking...
thanks heaps!
Click to expand...
Click to collapse
to switch on device you have to keep pressed power button for few seconds or u can keep it pressed until you see lights at the touch keys.. :good:
Hi
brodiecb said:
Hi all,
does anyone sometimes have to press the power button (when phone is completely turned off) twice (2 presses to turn on) sometimes?...
so just to confirm
- handset is off
- push power button once (sometimes doesnt come on
- push for second time (and powers up)
im defiantly pushing for long enough
iv have no issues with the button at all when in the UI or when locking/unlocking display
iv done a few tests where i have turned off. then went to switch on, with the same pressure and sometimes it starts with one, sometimes it starts with two presses,
do u think this is a fault? anyone experience this? normal?
just checking...
thanks heaps!
Click to expand...
Click to collapse
I don't think many people would turn their phone completely off so haven't found the issue.
When you power off what will be happening is the phone is off as much as it can be, but these buttons are soft off, the battery is still connected and some power must be drawn to run the power circuitry to detect the button being pressed again to signal to power back up the phone, in the same way when you turn your TV off by the remote, power is still drawn to run the remote sensor on the TV.
To keep the drain on the battery as low as possible so the battery isn't completely discharged over months of storage I suspect the power chip waiting for the on signal again is only sampling every so often to save power so it can be in super deep sleep state. This means depending on where in this cycle you are when you press the power button it might seem like it isn't responding, so typically you have to leave it depressed long enough for it to be "seen".
The better option is to just to put your phone into flight mode if you don't want to be disturbed or want the phone off. I do this overnight and lose no battery power by the morning, so it is as good as off. You can add a button to your home screen to do this quickly, widgets are included already for that.
Regards
Phil
Mine does the same thing.. Sometimes it does it with waking up from sleep also.
Sent from my HTC One X using xda app-developers app
So these problems just started today:
Power button is unresponsive
Fingerprint is slow(takes 5 sec to screen on after touching)
Phone is marginally slower
no working internet despite symbols showing wifi/data(whatsapp works!!)
Charging light led remains on even after unplugging for varying amounts of time(stays on for b/w 10 sec to 1 min)
Not sure if usb is working because adb doesnt detect it anymore (no usb selection options on phone either)
Time to take it to service i guess, haven't reset yet coz i still have whatsapp access.
Anyone know how to reboot the phone without a power button?
Keep pressing power button for long duration.
Or press and hold vol up +power button
My phone has suddenly died today. Unsure how much battery it had when it happened, no issues before.
I lookedat my phone and it appeared to be off but I noticed a notification light flashing. Power button didnt turn the screen on, no volume or softkey interaction either. green LED still flashing (I had just not long before had a message on whatsapp so maybe it was from this).
Whatsapp web shows phone as offline, google shows phone as offline.
Connect it to USB and the laptop notices a device as I get the noise, but doesnt show as a drive in the laptop
connect it to power, nothing comes on the screen.
Call it and it doesnt ring (noise wise or screen)
Cannot reset - power button feels soft (not clicky)
Light still flashes.....
Really stuck any help appreciated.
galaxys3bluetooth said:
My phone has suddenly died today. Unsure how much battery it had when it happened, no issues before.
I lookedat my phone and it appeared to be off but I noticed a notification light flashing. Power button didnt turn the screen on, no volume or softkey interaction either. green LED still flashing (I had just not long before had a message on whatsapp so maybe it was from this).
Whatsapp web shows phone as offline, google shows phone as offline.
Connect it to USB and the laptop notices a device as I get the noise, but doesnt show as a drive in the laptop
connect it to power, nothing comes on the screen.
Call it and it doesnt ring (noise wise or screen)
Cannot reset - power button feels soft (not clicky)
Light still flashes.....
Really stuck any help appreciated.
Click to expand...
Click to collapse
Could it be possible you have a power button hardware failure. Try this : keep volume down pressed. If the phone reboots the power button is pressed too without you touching it.
Mr Hofs said:
Could it be possible you have a power button hardware failure. Try this : keep volume down pressed. If the phone reboots the power button is pressed too without you touching it.
Click to expand...
Click to collapse
I did think that the power button may have failed, but noting that the notification light is on, that then suggests the phone is in a powered on state - if that is the case should it not respond to an inbound call, any of the soft buttons at the bottom etc?
Just tried holding volume down for 15 seconds, nothing.....
Was hoping to get the phone to completely power down of its own accord but I dont recall if it had 3% or 70% and dont know how long a blinking LED will keep it going for!