problems with bt headset - JASJAR, XDA Exec, MDA Pro Software Upgrading

when i use my jasjar as a phone without headset (handfree) the sound is clear.
when i use it with any bt headset.....the sound is lower on my side and not clear on the other side(echo+noise).
how can i solve the problem?
ROM version:1.30.76 wwe
radio version:1.09.00
protocol version:42.42.p8
Exrom version:1.30.164 wwe

Got the same problem here, you have to use the official headset

Related

Quite BT headset(s)

I have two BT headsets. A Jabra 200 and a Motorola HS850. In both cases, people who I call are reporting that they both sound quite and distant.
Has anyone else noticed this and if so, what was the cure.
I am running 3900 BT stack and the microphone AGC is turned on.
Sorry if this has been asked before, I did a search and couldn't see anything.
Regards
whats your radio version?
1.02 seems to suffer quite bad ..
should upgrade radio to 1.12
The Radio is 1.06.00 - does this also have problems??
Have a look here:
http://forum.xda-developers.com/viewtopic.php?t=22453
I have the HS850 working perfectly.
Check my .sig for my config.

Jasjar- BT Jabra 500 sound Problem

--------------------------------------------------------------------------------
Hi!
I have i mate JasJar, but there are some problems which are a bit annoying and I will ask you if you can help
Does anybody have problems using BT Jabra 500 working with Jasjar?
I cant hear any of my incoming/outgoing calls nor can I hear a ringing in BT.
Jasjar discover BT and pairing is OK ( just in case I did couple times -no luck)
when I use answer/end button on BT is dialing out but no sound on BT
on other side that I call they can hear my voice but I can't hear anything
Do I need any software to instal in jasjar ???
ROM version 1.13.53 WWE
ROM date 09\23\05
Radio version 1.03.01
Protocol version 42.36.P8
ExRom version 1.13.137 WWE
Please help me out
Thanx
I have BT 500 and have no problems, it sounds like the headset has a problem not the phone.
Also have my own and a client's Jabra 500 working successfully with o2 Xda Execs.
Stupid question I know, but you have tried increasing the volume on the headset buttons?
I did try everything , volume etc , contact jabra and try there sugestion
such as :
could be a pairing issue, or a bad speaker on the BT500. Please try a reset and re-pair of the phone and headset first:
Turn the headset off.
Plug the headset charging cord into a wall outlet.
Connect the headset to the charging cord for 5 seconds.
Disconnect the headset.
Remove the headset from the phone Bluetooth menu.
Turn the phone off.
Remove the battery (and sim card, if removable), and hold out for 5 seconds.
Re-install the battery (and sim card, if applicable) and turn the phone on, but do not touch any settings.
Turn the headset on.
Put the headset into pairing mode by pressing and holding the pairing button until you see a steady blue light. Release the button.
Perform the pairing procedure for the phone.
SIMPLY IS NOT WORKING
try with friend V3 razor and same thing
I also have the BT 500 + jasjar
It just works better than the BT 250 which was my past one.
To be honest, what I have on my jasjar is the new O2 rom upgrade (and that should not do any difference) I think there is something wrong with your jasjar
Maybe you will be forced to try the bad solution HARDREST try the headset with other phones before doing that
i beleive it's the headset that has the problem, since you tried it with another phone.
i have the bt500 with the imate jasjar and also the kjam and it's more than perfect for me, the sound is cristal clear on all the phones i tried on.
maybe you should replace it with a new one.
What I mean is not a factory mistake in the headset
I think the phoen is getting complex and some data have been lost (possible)
By the way, I haven't installed the BT headset fix, yet it works fine.

exec doesnt work with motorola bluetooth handsfree

hi.
i just bought a motorola bluetooth handsfree for my car HB830. i paired it to my exec and it started working. now the problem is that sometimes the pairing fails and the phone doesnt transfer the call to the handsfree i.e the call remains in the phone. when this happens the exec shows that bluetooth is turned off which i switch back on but the problem comes back after the next call. i.e the phone doesnt seem to be able to transfer the call to the handsfree.i have upgrade my ROM to Rom:1.30.107 WWE
Radio: 1.09.00
Ext ROM: 1.30.162 WWE
is this a problem with the new radio ? should i downgrade to the older radio? if yes then which one and how do i? please help me guys.. thanx
My Uni does the same with my parrot CK3100 car kit...
Its a major pain in the ass....
Seems to work fine with my Jabra JX10 tho..
:roll:
Same problem here with a medion bluetooth car radio.
Most of the times my universal thinks it's paired (icon in the calling screen), but when making or receiving a call it disappears.
After a succesfull bluetooth call, it isn't posible anymore to call handsfree.
Bluetooth also regulary turns itself off. Tricks found in another topic are not the solution for me
if you enable the device lock start\settings\personal\lock
Prompt if device is unused for 16.7 hours
set simple pin
the phone and the parrot device keep there pairing with no problem at all i have been testing it for the last 48 hours
if you disable the above it loses the paring straght the way.
strange is they anyone else who can try this
Thanks
Paul
bluetooth headest problem
hi.
1st thing how do u set it for 16.7 hrs.... it just gives me options of rounded off hours.
i tried setting it for 12 hrs.. it works better but still a problem
Maybe this is a clue:
I use the newest Qtek German Rom, which is from April or May. This should be same version like WWE version.
Since I upgraded to this Rom, all my problems with Bluetooth disappeared. It works fine with my Logitech mobile pro 2 headset. I assume, the problems are only because of the rom.
try upgrading and see, how it works.

poor A2DP quality

I have Moto HT820 and JasJar with latest _official_ i-mate ROM. I applied the Tornado patch to get the Stereo Profile.
The sound works OK, except there is a lot of noise and distortion.
I've applied BitPool and SampleRate reg hacks but they dont seem to make any difference.
Anything else i can try?
Same here
I have a Motorola HT820 with my Qtek 9000 and the sound is really bad.
My friend has a Sony Ericson K800i and it works perfectly, the sound is great but with my Universal, the sound is very bad!!
Anyone has a trick or patch for A2DP?
Regards
try updating the firmware of your ht820 headset...the update is there in the forum..also, try using helmi's broadcomm stack http://forum.xda-developers.com/showthread.php?t=291639..works perfect with my uni+jabra bt620s
rhn said:
try updating the firmware of your ht820 headset...the update is there in the forum..
Click to expand...
Click to collapse
the update (which is at http://forum.xda-developers.com/showthread.php?t=276406 ; I've also linked in from my related article at http://forum.xda-developers.com/showthread.php?t=296770 ) will "only" fix the skipping problem; NOT the bad compatibility with the MS BT stack.
That is, the only way to fix the problem is 1, getting a compatible pair of headphones 2, changing the BT stack to Widcomm
see my post at
http://forum.xda-developers.com/showpost.php?p=1215382&postcount=133
in short, Widcomm is a bad choice for jasjar/HT820 headset.
At this point I think i fixed the quality (or got used to it), because i dont hear much difference when streaming music from PC vs jasjar.
The only BIG annoyance is the skips/pauses. Must be the damn phone doing something in the background!

XDA IIs Stereo audio problem

Has anyone ever had anything like this problem?
I can not get my device (O2 XDA IIs) to output both channels of stereo audio.
I have upgraded the rom to what i thought was the latest (june 2005)
http://www.seeo2.com/user/XdaIIs/template/XdaIIs_ROMUpgrade_Jun2005.vm
Code:
English ROM
ROM: 1.40.00 WWE
Date: 03/10/05
Radio: 1.12.00
Protocol: 1337.42
ExtROM: 1.40.923 WWE
MMS: 2.0.0.21
BT: 1.0.0 Build 3900
I have tried several different media players, from windows media player 10, sompy media, and a few others, with no change.
I have tried several different stereo headphone/earbud combinations, which have worked on other 2.5mm socketed devices, no luck.
I am dreading the possibility its a hardware issue, so asking around before i start looking for service centers.
Can anyone shed some light? or have a similar issue?
Thanks.
It's a problem.
Your device cann't output anything by earphone?
It can output only a single channel.
The right channel is fine. good volume/frequency etc.
Handsfree kits are fine, mic and earbud works no problem.
It's just when i connect a stereo headset to it, no left channel audio.
I've more or less resigned myself to buy an overly expensive pair of bluetooth headphones to get around this issue, but i wish i didn't have to.
Especially considering the mediocre bluetooth radio performance i have been reading so much about.
And what if it is a software issue of some sort that i haven't seen?
200 bucko's more down the drain.
sad panda.
if the stereo headset it came with dont do stereo
and hardreset dont have any effect
then i'd say it's an hardware issue
if the org headset works then i'd say it's the headsets you try and or the 2.5mm -> 3.5mm converters which are the issue
I have same problem, My XDA IIs has been upgraded to WM6 CE OS 5.2.1933 by Xplode. I lost my left audio also while right audio working fine at my XDA IIs Stereo Headset.
Is it the hardware problem or software problem?
I actually gave up trying to make it work.
I eventually went with a bluetooth stereo headset from sony as a work around.
Does the job.

Categories

Resources