xda2 rom upgrade - Upgrading, Modifying and Unlocking

hi,
i tried to upgrademy xda2ver 172187 as per Xda_II_Upgrade.pdf, during installation got to a section where I got a message saying that the current rom is being erased a task bar was displayed which increase's in percentage as the job goes through. i got a error message that upgrade could not be performed and asked to disconnect the sync and perform reset on xda 2 and try again. On the xda2 bar showed 19% upgrade completed. after doing the reset the xda 2 does not boot .
i redocked the xda 2 and ran the upgrade.exe program again but it shows connection error as it does not get connected via active sync.
please help me out of this

dear satishjain77
this is what i did & it worked:
open the attachment & follow instructions

xda upgrade
thanks for the help .
i have tried this and it worked for me . i entered my xda into bootloader mode and then the laptop detected the xda and it did the upgrade for me

Related

GSM ERROR !!

:roll:
i reaaly feel depressed .. & that is coz when i was tring to upgrade my T_Mobile Radio to RU 6.24.00
that i downLoaded from http://www.romanweb.com/yorch/
my mobile gave me the messge of that the upgrade failed ...
keeping repeating restarting ..upgrading process progress for several times ...then i ting i did restart or something like that after that I think my device Died no longer working all what i could see is T)mobile start screen with the ROM vervion RT Lower Courner U above it & some letter above them without vervions #s!!! !!!.
I did reset+ON/OFF Botton pressing ... got into the WALLBAY Bootloader V5.15. then .............................. WAIT...
then i resseved the messege GSM ERROR.
I restarted same as before +on/off .
Recieved same message then Pressed RT Upper Botton got into FLASH TOOLS selected GSM ROM TO SD got the messege
SD Backup
==============
Please
connect rs232
and run PC Monitor
Now
in your sitle this messege is followed by
SD BACKUP
=============
Please
connect rs232
and run
PC Monitor
Now
We're not yet sure how to use this to dump the GSM ROM.
..... End.
Now ,,, what sould i do to recover my T-Mobile ....
GSM Error, 1% failed, and battery not charge
That was what happen on my XDA too. I've been upgrade, downgrade both OS and RS roms with my XDA for about 9 mos without any trouble until last week when I tried to upgrade RS from ATT A20.10 to TMO 6.24.01, the upgrade failed and now I am stuck with 1% failed problem. Worse, the battery is not charged any more causes any further upgrade fail. I still can upgrade/downgrade the OS rom but do not know how to fix the Radio stack.
I have tried virtually all suggestion on this forum: the 4 RS files upgrade, SD nb1, nbf upgrade, repair.zip, Programme A, programme B, different OS and RS roms upgrade/downgrade. None worked.
I even opened the XDA and connected wires. Still not working.

Failed to Upgrade ! XDA 2 doesn't boot anymore :(

hi all ! im very new in this domain ! first here is what i DID : i have this XDA with ver 1.6x (something like that) and i wanted to upgrade to the new version from www.microsoft.com/etc etc...! so i dld it and started to write the new version.The program deleted my old version of windows and started to write the new ver after doing all the checks.But my laptop suddenly got into stand by when the program was writing the new soft at 7%.He said i should unplug then reset and re plug the poket pc! i reset it with my stilus and try to reconnect but now my setup program for upgrading doesn't FIND my XDA II at all....he tells me to connect the poket pc to cable.When the device want's to start i get the screen with O2 and the version down in the right corner but it wont get passt that...that is why probably the soft from my laptop says that i should connect the pda...my pda doesn't BOOT ! right ?...so...now my big question...is there a program that i can use to WRITE windows mobile to my XDA II ?..so that he don't checks the version...he just overwites all data so my xda will work again! hopefully somebody can help me...or maybe is there a program that can delete all from my xda so i can start to write the new version to it ! pls ..smb help me with that ...i need to fix this very quick..if not im a dead person..PS :i forgot to mention,,,..my PDA doesn't belong to me ..so this is why im dead..if i don't get soon a new ver of win to it !...i'll wait for your answer...! so the final question would be...where to find a TOOL that can WRITE my ROM without DETECTING (without active sync-cause this prg doesn't recognize anymore my XDA2) my PDA !...IF someone can help pls write me quick..you can also write me on yahoo: [email protected] ! thx alot guys
you get the upgrade files from www.my-xda.com not from microsoft....
re-do the upgrade dude.... goodluck... check out DCS's thread about upgrading
i upgraded (and switched languages in the process) my girlfriend's iMate 2k2 ( a.k.a. XDA2/MDA2) by flashing with an upgrade from my cellular provider.
the first time, things went wrong and I saw USB and some weird junk on the screen.
panicking, i decide to try it again.
this time it erased everything, and crashed when it came to 15 percent of the writing part.
REALLY spooked, i tried it a third time, and sat in front of the laptop to prevent a screensaver or hard-drive-spindle-down from happening, and the upgrade went smoothly.
it was a boring 45 minutes, occasionally jiggling the mouse to keep the computer alive, but it worked.
so try and try again
Thx All For Help
i've read a post by DCS a after that all went smooths for my noob knowledge ...the 3 button reset hlp me alot cu guys ..and HF!

XDA2 172181_final.exe update problems Help Required

Dear Fellow Forum Members,
Followed instructions as per Xda_II_Upgrade.pdf, during installation got to a section where I got a message saying that the current rom is being erased a task bar was displayed which increase's in percentage as the job goes through. However the job was still at 0% completion when an error message was displayed saying the job had failed and the device needed to be undocked and a soft reset performed and then re-docked and to restart the process again. After performing the undocking of the device and software reset I get a message on the screen serial V1.0.1 when connected to the cradle the message changes to USB 1.01 and I cannot do anything else the unit does not boot into pocketpc, as you can imagine this is very frustrating as I depend on my xda2 to receive and make phone calls I would be very grateful any members know of any way to get around this problem. I must say I am a bit concerned a try and tested xda2 update has led to this problem.
Just run the update .exe file again with the XDA docked and it should just install the update again. It happened to my mate on Saturday with his XDA II and he just ran the program again.
Dave,
done as you said and all went thru fine you are a star thanks mate.
No problems it's good as a newbie to be able to actually help people.
upgrade xda2 rom ver 172187 dead os--connection error
i was trying to upgrde the rom from o2 website when error occured at stage 19% completed asking me to reset the xda2 . when i am trying to reset the xda 2 it does not boot it just shows the o2 screen with red letters of the version and does not even charge. my laptop cannot connect to xda2 and as a result i am unable to upgrade when i tried to run the 172187 .exe again it gives error 101: connection error
please help me out of this? thanks

MY XDA IS DEAD!!! PLEASE HELP ME !!!

I'm trying to upgrade my O2 XDA with original O2 Radio stack 4.21:
1. connect with PC via ActiveSync 3.8
2. launch Setup.exe
3. tranferring on XDA (WM2003)
4. on XDA starts Radio stack upgrade
BUT:
shows an error message like this
"Radio Stack upgrade fails. please click on OK to restart"
I click, XDA restart, bat shows errore message too.
I do an hard reset an then....
shows O2 boot screen with
G
R
4.01.16
and does not proceed anywhere!!!!
IS DEAD DEAD DEAD!!!!
how can i do to restart it?
Marco Molinari
ITALY
How to fix GSM Error Problem ....
Download the XDA-Developers ROM Version 1.1.
Install the ROM on your Device via SD-Card and bootloader.
The phone should start up and give you the screen allignment and the whole menu!
Download an Upgrade for your device. This depends ont the model you are using. Check the sticker at the back of your device.
If it is a PW10A-Model download RSU Version 4.16.
If it is a PW10B-Model download RSU Version 6.24.20.
Extract the downloaded ZIP-File and copy all files to the /Windows directory of your device.
Copy the RSUpgrade.exe additional to the /windows/startup directory.
Make an soft reset of your device.
Maybe the upgrade will stop again at 1%, this may occur when you have an empty battery.
Place your device in the cradle. Run Active Sync on your device.
The RSU Upgrade will run in the background.
Wait for about 10 Minutes. The upgrade should complete in the background....
Afterwards all should work again...
Good luck....
Click to expand...
Click to collapse
after ah hard reset and a long long long time, my XDA starts with no phone service (in boot screen shows:
G
R
4.01.16)
My XDA is PW10A-Model
I found RSU 4.21 (not found 4.16)
if i run PROGRAMME B
it shows FLASH FAILED! message and OK to restart.
if i click OK its restart, an so looping ...
you wrote:
Copy the RSUpgrade.exe additional to the /windows/startup directory.
Make an soft reset of your device.
Maybe the upgrade will stop again at 1%, this may occur when you have an empty battery.
Place your device in the cradle. Run Active Sync on your device.
The RSU Upgrade will run in the background.
Wait for about 10 Minutes. The upgrade should complete in the background....
Afterwards all should work again...
Click to expand...
Click to collapse
where can i found RSU 4.16?
where can i find RSUpgrade.exe ?
I must wait 10 minutes without click on OK, restart the device?
thanks
Take a look at:
http://lumpistefan.dyndns.org/tools/
HTH
Stefan

update help xda orbit

i have a xda orbit and i am trying to flash it with o2 premium full rom. i have done things like removing the microsd and sim and have ran the cid unlocking utility which came in the package. it goes to 100 and the phone goes black and with a linux cartoon and goes white then. afterwards the update utility runs after accepting everthing it looks for the settings and give me an error saying check the cradle the error is 270. if i enable the active sync manually it installs and goes to 3% giving me an error 260 image corrupt pls help!
Have you tried flashing any other ROMs and have they worked OK?
yup all of them are doing the samething. but i noticed 2 files in the root of the phone memory and i found similar files in the rom package so i copied those two in the root. and then the romupdate utility dected my phone in the bootloader and it worked. i am not sure this way the reason i could be something else not sure.

Categories

Resources