As title, touch screen is only resposive down centre (vertically) - left and right no response. So, I can't enter PIN to start android.
Volume Up + Power doesn't get into Recovery... just android symbol and 'No command'
Volume Down + Power gets into Fastboot, but no device seen with adb
I'd quite like to send the phone for possible repair at some point but want to factory reset it before I do... any ideas..?
Turned back from checking emails on PC and the phone was in recovery..!!!
No idea how..?!!
But I got to Factory Reset
Related
I just received my O2 Exec, and upgraded the ROM to the latest off the O2 Site. When prompted, I disconnected the device from the computer and did the reset. (Two soft keys plus reset button). The screen comes up and prompts to press "0" to load factory defaults. I press "0", and a message briefly appears...."clearing". Screen then goes blank.
I then tried to put it into bootloader mode, with no luck.
What can I do?
check
check to see if there is a faint "serial" written on the to of the blank screen (very faint can barely see it)
if so .... you are in bootloader mode
dhob187 said:
check to see if there is a faint "serial" written on the to of the blank screen (very faint can barely see it)
if so .... you are in bootloader mode
Click to expand...
Click to collapse
I checked a few times in very good light. The screen is blank.
Is there nobody that can help me? Please my new phone is dead. What can I try?
What I have already tried:
1. Will not go into boodloader mode.
2. When I do a hard reset, the screen show up, but does not continue to splash screen.
If it is going into a hard reset it should go into bootloader mode no problems. Hold down the power, backlight key and the reset button for about 3 seconds. Sometimes it doesn't enter bootloader with just a quick press.
When you have done this try re-flashing with a freshly downloaded copy off the FTP or somewhere else.
edit: I got it. I was stuck right after the unlock and could not get menu after going into the stock recovery. It appears that you have to push the power button just a fraction of a second before the Vol up/down. Or at least in my case that is what worked.
Trying to root this manually with an Ubuntu Linux box, adb and fastboot setup I got stuck. Not sure what is wrong. Any help is appreciated. This is what I did so far:
adb devices recognizes the phone
1- downloaded fastboot and cd to it in terminal (but don't really need it since it is already setup)
2- volume up and down and power to get to inital menu with locked state
3- fastboot oem unlock, chose yes and got the unlocked state
now I can't get to the menu for recovery to wipe data and factory reset. I pressed the volume down to get the recovery mode option and then power button, it flashed an android standing up (after the google and the lock screen) but quickly goes into the laying down android with a red triangle in it's tummy. Did I miss something?
phone won't boot up (bootloop). any help is appreciated
Not entirely sure why this has happened but im getting secure boot errors when:
1. I just turn the phone on.
2. Vol up + USB
3. Vol down + power button to get to factory reset.
After that it is the usual black screen with blue and red lights.
I cant use any button shortcuts to get anywhere, is there a way I can get the pc to recognise the device from this state?
I have the same problem. Like and idiot I deleted boot.img, aboot.img and recovery.img and then I realized that I didn't have the backup done. So I disconnected my device from the PC and nothing happened. Just turned off. The weirdest thing is the pc recognize my LG as a "LG Android USB Device". And I can't enter in download/fastboot mode
Any suggestion?
Sailing in the same boat, any help will be great, have a very expensive brick with "secure boot certification" error.
wage90 said:
Not entirely sure why this has happened but im getting secure boot errors when:
1. I just turn the phone on.
2. Vol up + USB
3. Vol down + power button to get to factory reset.
After that it is the usual black screen with blue and red lights.
I cant use any button shortcuts to get anywhere, is there a way I can get the pc to recognise the device from this state?
Click to expand...
Click to collapse
Let's refer to this other thread so we don't duplicate the same scenario:
http://forum.xda-developers.com/lg-g3/help/g3-secure-booting-error-dead-recovery-t2915153
hello
i searched the whole internet but there are not much informations about this Phone so i thought i make a new Thread
about the panasonic DCM-CM1 Factory Reset.
please write here any informations and experience you have about the Panasonic DMC-CM1
i never saw someone on youtube google or any other side or anyone who can tell me how to do a Factory Reset with this phone
today i called 5 Panasonic service numbers but noone can help, i also called about 10 Phone Service points for repair no one can help.
i tryed so much with this phone and i finaly found that the CM1 have a Secret key combination to connect it with USB as a Android ADB Interface without having acces to the phone cause it is screen locked.
1 .Turn Phone off
2. press Camera + Volume-up + Power ( Hold )
3. while Holding connect USB. (Hold)
4 .the LED should go green for maybe 2 seconds release all bottons while the led is green before it turns off and then the LED must still green.
then windows found a Android ADB Interface
if im in android SDK Tools i the phone will be found in fastboot!
if i type Fastboot Devices
the other thing i know is how to start in Save mode.
but this is nothing to help with a lost pin.. it only starts the phone without apps that have been installed by the user.
maybe for deinstalling a app or a buggy app.. dont know..
start phone at the screen for the pin or at the home menu..press the power botton hold for 2-4 seconds or so it ask for Shut down Restart and so.. just press and hold Shut down. and then it ask you if you want to start in Save mode. then press yes.
2 weeks ago i wanted to make a Screen lock with a pin for more secure.. i cant remeber the pin anymore thats why i want to make a Factory reset i think im not the only one. so any information would be nice
if there is someone who made Factory Reset with this phone or was able to start in fast boot or anything.. please share the infos with us!
thank you.
Hello,
My Mi A2 Lite stopped receiving inputs from the screen, i.e no screen response.
Numerous re-boots by pressing power button, just brings up the screen to enter pin, where I cannot enter anything since screen is not responding. There is no sign of any defects with the screen, so i think its a software problem. i have also tried to wipe data/factory reset the phone a few times using power button+ volume up and getting up the "robot" and "no command" screen, then power button + volume up again gets me to the recovery screen. The recovery screen also has the selection to "Apply update from adb" or also "Apply update from SD card", but not sure if this will work.
I have then tried to install TWRP, for me being able to install a new ROM, but cannot do it since "Minimal ADB and fastboot" commands bring up FAILED (remote:unlock device to use this command)
I assume I must enter phone settings and press 7 times on correct menu, then enable developer mode. This I cannot do, since I cannot enter the phone.
What should I do here in order to go forward in trying to get the phone working again?
doennes said:
Hello,
My Mi A2 Lite stopped receiving inputs from the screen, i.e no screen response.
What should I do here in order to go forward in trying to get the phone working again?
Click to expand...
Click to collapse
USB otg cable + USB mouse works for me...