Hello, I have a hyundai tucson and the screen that has wifi and gps but is not activated and the
SW version. TLFL.GEN.SOP.V095.180416.DAU_A
VERS:FIRMWARE TLFL.GEN.284.180402.MICOM.DL
Do you know if I can update it for another firmware and how?
Related
Hi gentlemen,
I have a QTEK 2020 and have a very annoying problem: Every few days my phone loses its connection to the cellular network. When it happens - nothing is seen; everything looks perfectly normal (even shows GSM reception), however no-one can call me. When this happens, I can't initiate outgoing calls either. Only a soft-reset fixes the problem.
I'm using ROM version 1.72.00WWE and Radio 1.17.00.
I saw in this forum that there's a newer Radio version - 1.17 and I was thinking maybe it will solve the problem I have.
However I'm seeing updates to MDA II and XDA II.
Can anyone advise me what to do? Is there an upgrade to QTEK as well? If not - can perhaps someone "compile" a neutral version (no branding)?
And another question - is it possible to upgrade just the Radio?
Any help would be very much appreciated!
Thanks,
Ariel Cattan
Hi - I have put Tomtom on my IIi and have been using a bluetooth GPS receiver. This works OK for a while and then the screen locks up and I have to do a soft reset. Having reset it with the route again it will go for a while - maybe 30 - 40 miles (varies) then it locks up again. Any advice would be welcome. TIA Doogan.
Have you recently upgraded your rom? or update you OS to correct the communication problem with usb? if not try todo that.
Upgrade ROM
How do I upgrade the ROM and the OS. I have purchased the unit in USA from T-Mobil
Al
Hello,
I have a pumpkin for over a year RK3066 (C1009). Unfortunately, never has the radio tuner worked. I was times a firmware link sent, but also brought nothing. Wanted to send the radio back but Pumpkin has crossed there.
Where can I get the original firmware together with MCU? Have the internet looked up and down.
Data from the board: KD-HCT-MB 2015/03/10 REV-1.61
Data from the Board: MTC_RK3066_REV0.3a 2014.03.27
Maybe someone has also a tip for me, how to successfully turn on WLAN and important and the radio tuner work? He gets a transmitter at all and the other not at all.
I strongly assume that I must take KLD1.
If I use the original radio, then it works immediately.
I have already checked whether the antenna amplifier gets voltage at the pumpkin, which was the case.
Greeting Marco
Sorry for my bad english.
Hi folks. After manually updating my Bluetooth 46mm watch to BSA4 manually via NetOdin, my security status is showing as "unknown". Does anyone know what this means, why and how this can be fixed? It doesn't impact me being able to use things like Samsung Pay as the software is still considered in Official status, but not sure if this will affect being able to get OTA updates. Cheers
Mine is showing the same, "unknown" and I did nothing. Any ideas what it means?
I just bought my watch yesterday and it also says "unknown" for security status.
Same here. Something to be worried about? I do have unknown sources checked off and developer mode enabled.
Guys, I have this problem after last OTA update a few weeks ago in Turkey and I did nothing manuel. Then seeing it, I took it to the service center, they have reinstalled the software and given it back to me. But I have insisted and got in touch with Samsung Turkey saying this device is now a faulty product because it will most likely have security problems with Samsung Pay and similar; therefore I want it replaced; not semi repaired like this. They know the problem well, called me a few times and requested all software and hardware information both in phone and the watch. As I can see the update somehow damaged the security status of our watches; we are not alone, they will try to find a way to correct it if possible with a software update. We will wait and see, I will inform here. Please you also reach to your country's technical support for consumer pressure.
What was the code you used to check it?
With new update I can't find the status.
I was told by the customer relations that related menu would be discarded with the update; it seems that way; I am still waiting for the update though.
Can you tell me which is the code to check it? Or menu?
cgentil said:
Can you tell me which is the code to check it? Or menu?
Click to expand...
Click to collapse
There is no way to check it after the latest OneUI update. It's completely gone from the menus.
Hi all,
I recently purchased a CarExc PX6 from AE Everything works great besides the unit did not have a CarPlay/AutoKit APK/Module installed.
I've tried searching for a couple of different options but no luck with one that connects to my phone. I either get a "Product not authorized" message or once updating the unit crashes or freeze's each time opening. Without the module the USB transmitts power to my phone so its strictly a software issue.
Has anyone had any luck with a good .APK/Module for these CarExc headunits?
Many Thanks
Cant you just download an autokit apk from the internet? Some where on reddit there is a february version of the autokit i advise you to use that one and dont update it.
I bought a official carlinkit wireless version from amazon (the global online store of carlinkit) i installed the apk from there site at first every thing worked fine but after that i tought i need to update the software as i had a weird graphical glitch with volume up/down. So i updated it with in the app to the latest version. Should have never done that, i also get the same issues you have, and i bought it at there offical store at amazon. Any way its still very buggy the carlinkit i have for CarPlay. Its not reliable, and doesnt work flawlessly..
Not an MTCB, what is the unit? Posting in the right forum might yield better results/replies