Hi
I unplugged the bootloader zl and after installing it, I closed it
It will be installed when the official ROM is flashed but the phone will not boot after powering on and a dark screen will appear.
I tried it with different versions and versions as well
Thanks for the help and guidance.
Related
Note: I have a sony xperia pro mk16, there was no phone selection for it, so i chose to post on arc forum; however, solutions should be same or similar
Note2: i am a bit noob at rooting and cmw and all that
Story: I had ics and finally decide to try to upgrade to jb with custom cm10 rom. i first rooted the device and installed cmw with x-part. I attempted to install the firmware but it quickly gave me a status 7 error. so i just rebooted and it loaded to a reset ics firmware perfectly fine. after an attempt to download another version of cm10 jb, i tried installing that firmware. after a long wait on installing:..., the log finally gave me another status 7 error. so i rebooted again HOWEVER, it is STUCK ON the SONY logo.
i tried pulling out battery and repowering but nothing changes. holding power with repeated volume down or hold volume up button doesnt do anything. i can connect to sony pc companion but it says i need to fully turn on my phone to update/repair.
i can get it to flashmode using flashtool, but when in flashmode it just leaves a blank screen that wont do anything, i would have to pull out the battery and repower it, which would lead me back to the SONY logo.
PLEASE HELP
ilikecloud said:
Note: I have a sony xperia pro mk16, there was no phone selection for it, so i chose to post on arc forum; however, solutions should be same or similar
Note2: i am a bit noob at rooting and cmw and all that
Story: I had ics and finally decide to try to upgrade to jb with custom cm10 rom. i first rooted the device and installed cmw with x-part. I attempted to install the firmware but it quickly gave me a status 7 error. so i just rebooted and it loaded to a reset ics firmware perfectly fine. after an attempt to download another version of cm10 jb, i tried installing that firmware. after a long wait on installing:..., the log finally gave me another status 7 error. so i rebooted again HOWEVER, it is STUCK ON the SONY logo.
i tried pulling out battery and repowering but nothing changes. holding power with repeated volume down or hold volume up button doesnt do anything. i can connect to sony pc companion but it says i need to fully turn on my phone to update/repair.
i can get it to flashmode using flashtool, but when in flashmode it just leaves a blank screen that wont do anything, i would have to pull out the battery and repower it, which would lead me back to the SONY logo.
PLEASE HELP
Click to expand...
Click to collapse
My guess is that you tried to flash a JB rom without flashing the custom kernel because your bootloader is locked. Not every rom is working with stock kernel. CM10 and AOKP as far as i know need custom kernels like Lupus and fxp139. To flash a kernel you must have unlocked bootloader. So until you decide if you will unlock your bootloder or not, you can allways use flashtool to flash stock Sony firmwares found here:
stock firmware: http://forum.xda-developers.com/showthread.php?t=1642480
here
download the original ICS firmware (somewhere in this forum)
add to flashtool and wait till the pop up asks you to attach your phone in flashmode
attach in flash mode and let flashtool do its magic
now... unlock your bootloader using official or s1 tool method
download CM10 again
inside there will be a boot.img
power off your phone, hold down settings button and attach usb cable..
now you should see a blue LED light
FASTBOOT flash the boot.img and the flash the ROM
press thanks if i helped!!
Ok
i updated the firmware with odin last version to this OFW T210XXANC2_T210OXXANC2_T210XXANC2_HOME.tar.md5
All worked fine and the tablet kept the data, etc.
Now i installed the cwm and the 'android-armeabi-universal-root-signed.zip' from it.
For some reasson the tablet now is bricked for unknown reassons and its screen doesnt respond to finger touchs.
The tablet buttons and sound and booting works, but because the screen doesnt detect touchings, i cant do anything.
I have tried to install other cwm versions etc, and to reinstall the firware, and also that pre-rooted firmware on this forums, reset factory from cwm, etc. No success unfortunatelly.
Please help
anybody ?
i have installed kitkat firmware, the screen doesnt respond touchs
i have installed last jelly bean firmware, the screen doesnt respond
i have installed stock firmware, stucked in the samsung logo
help !
rotation sensor works, buttons works.
same problem ....
arfgh said:
anybody ?
i have installed kitkat firmware, the screen doesnt respond touchs
i have installed last jelly bean firmware, the screen doesnt respond
i have installed stock firmware, stucked in the samsung logo
help !
rotation sensor works, buttons works.
Click to expand...
Click to collapse
You have installed a rom for ROmanian Tab 3 7' Wifi, if you rezolved the problem please let me know how you did it becouse i have the same proplem and i tried everything , i try to install - uninstall a lot of ROM'S Kernel but no response the TAB3 is suck in Samsung logo or TAB 3 Logo . Please Help with a working rom or kernel ...
I had this when playing around with stock kit kats italy to france holland then back to stock jely bean then nole kat rom
Flash the stock firware for yhe tab with odincheck auto restRt and ftime is only on
Right after its near the end off flashing its gonna reboot keepp cable connect still
And hold home button and volume up when it turns off from downloading screen
get in stock recovery mode wipe cache and factory wipe
And reboot system
As its reboot hold home and volume down to get downloading screen
check at top thats its both offical if yes power off and start up
If no reflash again and do the same then it work to setup
Most off the time 2 flashes off stock does the job
As the title says. As soon as I try to install a custom ROM phone doesn't even reach the LG Logo. Just boots to a log screen, with the last line mentioning fastboot mode (however its not in download mode).
Tried going back to stock and trying to reroot and installing twrp agiain, but no luck. Think there may be a problem with my phone.
Last time I had a custom ROM installed a couple of days, it kept crashing giving me a green screen log.
Any ideas?
Hello guys,
I just got my oem unlock permission and flashed the latest recovery. After backing up i tried to install a rom like AICP. After instaling I hit "reboot". The first boot screen comes up and after this a the sreen turned black with a long vibation and the LED tuned blue. No booting.
Can someone help me? I've read something in a closed DEV Thread but there was no suggestion.
Thanks for any help.
press and hold your power button. A simple reboot is what you need.
roli0201 said:
Hello guys,
I just got my oem unlock permission and flashed the latest recovery. After backing up i tried to install a rom like AICP. After instaling I hit "reboot". The first boot screen comes up and after this a the sreen turned black with a long vibation and the LED tuned blue. No booting.
Can someone help me? I've read something in a closed DEV Thread but there was no suggestion.
Thanks for any help.
Click to expand...
Click to collapse
If only unlock permission without unlock bootloader then install custom rom or custom recovery you are in big trouble
If you already unlocked bootloader, i think you need to flash twrp 3.1.0 instead of 3.0.3.
Don't know why, but after switching tu TWRP 3.1 the issue was gone. Thank you titou!
Solved
Hi,
i was recently playing with my Xperia, trying to run 4.4 android.
I flashed legacyXperia CM11, with corresponding kernel (included in zip with rom).
It was working fine, i tried to run newer versions, HyperGamer kernel, but with no luck.
I settled with CM11, installed gapps. Play store was crushing, so i rebooted the phone.
After that, Xperia was dead. It vibrates after pressing power, but screen is black (at first, i light up a little, slightly brighter than typical black).
I tried flashing with flashtool stock GB and ICS and reFlash. I flashed different kernels with fastboot. Everything is going ok, but i still get only black screen.
Any suggestion? I really, really like my Xperia Play and i don't want to lose it :/
kiriki-kun said:
Hi,
i was recently playing with my Xperia, trying to run 4.4 android.
I flashed legacyXperia CM11, with corresponding kernel (included in zip with rom).
It was working fine, i tried to run newer versions, HyperGamer kernel, but with no luck.
I settled with CM11, installed gapps. Play store was crushing, so i rebooted the phone.
After that, Xperia was dead. It vibrates after pressing power, but screen is black (at first, i light up a little, slightly brighter than typical black).
I tried flashing with flashtool stock GB and ICS and reFlash. I flashed different kernels with fastboot. Everything is going ok, but i still get only black screen.
Any suggestion? I really, really like my Xperia Play and i don't want to lose it :/
Click to expand...
Click to collapse
Try to flash stock GB FTF with flashtool....
Try with different (unpartitioned) sdcard...
Try flashing lupus kernel and see will it enter recovery when you boot (keep pressing vol- or vol+ while booting)...
kiriki-kun said:
Hi,
i was recently playing with my Xperia, trying to run 4.4 android.
I flashed legacyXperia CM11, with corresponding kernel (included in zip with rom).
It was working fine, i tried to run newer versions, HyperGamer kernel, but with no luck.
I settled with CM11, installed gapps. Play store was crushing, so i rebooted the phone.
After that, Xperia was dead. It vibrates after pressing power, but screen is black (at first, i light up a little, slightly brighter than typical black).
I tried flashing with flashtool stock GB and ICS and reFlash. I flashed different kernels with fastboot. Everything is going ok, but i still get only black screen.
Any suggestion? I really, really like my Xperia Play and i don't want to lose it :/
Click to expand...
Click to collapse
if you tried flashing with other roms it may be related to your flex cable. when i bought my first xplay it was in a state as you described, black screen only. the guy i bought from told me he flashed a rom and device was bricked in the process. but he also told me before he flashed, the touchscreen was not quite responsive and he had issues with cameras.
so first i tried to flash the phone with stock rom but there was only blackscreen. i thought the problem was software related only after changing flex cable phone started booting and running normally.
it may be a bad coincidence in your case but if you haven't changed your flex cable in a while it may be the cause.