The problem is:
I need to have separate leads for in-call conversations (mono+mic) and general audio, like music player (stereo). Meaning that audio normally goes via one cable, but when the call is placed it's automatically diverted to a different cable. It might be possible to make an external active switch-box if only there was a way to tell that a call has been placed.
I can only think of adding a bluetooth handsfree, which would only work for phonecalls, while keeping the stereo plug connected for music. But is there any way to do it with just an audio port? Is there any communication going on via the audio port at all for some advanced accessories?
The phone is in question is HTC Android, with 4-pin audio plug.
I would like to build an Android car infotainment device to replace all my gadgets inside the car. One option would be a micro PC with USB touchscreen and a lot of devices connected via USB. The other one would be an Android gadget, either small tablet or TV box.
The biggest question I have is: what Android devices support 5.1 audio? This is a must, though I actually can use only 4 channels. What audio formats are supported for this?
The other question would be TMC - the FM kind, not online.
Are there any embedded platforms out there (except PC and Android) which support multi-channel audio?
Has anyone done this before? I might be reinventing the wheel.
No updates? Either nobody knows about Android 5.1 sound output or they are working under NDAs.
Are you planning on keeping a headunit to control volume, do you want am/fm radio, etc....
without a headunit you will need an amp where you can use the headphone to rca adapter and usually its the amp that would add front and rear to the left/right output of your android device so you would still get the 4 chan output effect. to go for the 5.1 chan you will need another device that actually controls the 5 speakers plus the subwoofer which might be tricky but I'm sure its not impossible.
the setup I was going to go with was a amp that I can mount its power controls (left right front back and volume) (or amp/eq combo) to where I can reach it and build a mount for a 7in (possibly diff size not sure depends on how it will look) and use the heaphone to rca adapter to power the audio and put the usb inside the dash possibly with a little hub if they make it (that way not only is it getting power from it, if it allows, the addition of say a thumb drive with added music/movies. some tablets/phones have fm radios built in as long as something is plugged into the headphone jack (my new phone doesn't seem to have it but thats a feature I will be looking for in a tablet)
4chan amp
eq that would allow 2 chan in and 4 chan out plus sub out (if you have a separate sub amp)
I just want to know if there are any android devices that are able to stream 5.1, I can take it from there. Same question about TMC support.
Some details:
My car is already fitted from the factory with 4 channel preamp and 12 speakers including subwoofer low-pass. It has low-level input for those channels, worst case I would buy a preamp.
FM is pretty much given on most Android devices, probably excluding some tablets, but I won't actually miss it if it's not there.
TMC would be nice since all Androids usually have a GPS sensor and sometimes compass.
Anyway, it was mostly a request for suggestions or even a rant - I'm surprised that something like this doesn't exist yet. With the exception of dedicated units going >$$$-$$$$, an alternative set-up would be a medium-range blueray player coupled with an Android tablet. Music control could be set up with DLNA, bluetooth streaming or mixing player and android audio would be a bit harder but not impossible.
hey friends
this is a nice thought and you are absolutely great.
this is wonderful thread
........................
Great Idea
Hi,
Currently I'm also thinking about installing an android tablet in my car to have music, navigation, movie player, speed camera warning, etc. But the biggest problem is the sound. I want to connect tablet with car audio using jack-jack cable. Everything is fine till the AUX source is selected in car audio device, but when I switch it to Tuner or CD - the sound from tablet is cutted off, so e.g. navigation announcement are not heard.
Any suggestions for this issue?
audio rom
its a shame that there are many many roms but none fur special purposes like this.
we need a car rom
[email protected] said:
Hi,
Currently I'm also thinking about installing an android tablet in my car to have music, navigation, movie player, speed camera warning, etc. But the biggest problem is the sound. I want to connect tablet with car audio using jack-jack cable. Everything is fine till the AUX source is selected in car audio device, but when I switch it to Tuner or CD - the sound from tablet is cutted off, so e.g. navigation announcement are not heard.
Any suggestions for this issue?
Click to expand...
Click to collapse
Only solution can see is to run the audio from the tablet alone. I.e. use the tablet to provide both radio tuner AND navigation. You will end up using the car system purely as an amplifier.
Cris123 said:
Only solution can see is to run the audio from the tablet alone. I.e. use the tablet to provide both radio tuner AND navigation. You will end up using the car system purely as an amplifier.
Click to expand...
Click to collapse
This would be what I would do in this situation. Or just unplug the audio cable from the tablet when using other radio options so the navigation will come through the tablet's speakers.
I want to do something similar but rather than purchase a new device I want to use my Note2. No head unit at all. The Note2 would likely be dedicated to this use and I'd get a different phone to use as, well, a phone.
For sound I was hoping I could use USB OTG to connect a USB sound card with 5.1 output but I'm not sure if this would work. I want to use the sound card instead of audio direct out of the headphone jack because that reduces my connected cables to just one (easier) and should provide at least 4 channel output which eliminates the need for another device to control volume, fader, and balance.
For radio I was going to use SDR for AM/FM (and more) via a cheap USB TV tuner.
http://sdrtouch.com/
Where I'm stuck now is that I'd like to be able to connect an iProduct (iPhone/iPod) like you can to most car radios and control/stream music from the iProduct, via the Android Note2 using USB OTG again. I cannot find how to do this but the Parrot Asteroid Smart runs Android and it seems to be able to do it so it must be possible.
http://www.parrot.com/usa/products/asteroid-range/parrot-asteroid-smart/
Any info anyone can provide regarding the sound card and iPod integration would be highly appreciated.
You can go wireless and use some AirPlay receiver for Android.
I don't know about wired solutions, the classic iPod connector has ~30 pins and some of them are used for audio and some of them are used for serial-like playlist control plus current track information.
brainwash123 said:
You can go wireless and use some AirPlay receiver for Android.
I don't know about wired solutions, the classic iPod connector has ~30 pins and some of them are used for audio and some of them are used for serial-like playlist control plus current track information.
Click to expand...
Click to collapse
It's just a USB to iPod cable that they use for everything else... Parrot Asteroid Smart that I linked to has it as do most modern stock head units.
Did a little more googling and it seems several companies sell android head units that support iPod.
Why don't you use a USB DAC? There are a few out there that are surround sound capable.
Out from the DAC into an eq preamp and out to your existing amplifier. The eq preamp has main volume controls as well as sub control with dedicated output.
Also there are head units out there that are just "receivers" capable of accepting a digital inputs and outputting 5.1 signal via RCA.
I installed a nexus 7 2013 in my VW, currently using Bluetooth to connect to a receiver where it the outputs to an rca input on my deck that was relocated to my glovebox. I am planning on replacing the Bluetooth adaptor with a USB DAC in order to achieve a higher quality sound.
I am currently doing a similar install in a 2010 charger, a deck will not be used however as I will be using the DAC method with an eq and output to the factory amp. I considered going the android TV box route as I have a MINIX box, but there is some work involved in getting the touchscreen to function properly as it is not set up for this out of the box.
You can purchase a double din deck from eBay (I stumbled across it a few days ago but didn't write the link down) it has a dual os system. It uses android for the car audio function and windows for the car PC function. Not sure how well it works but it got reasonable reviews.
Edit: ...and once again I answer without reading the whole thread...:silly:
Is it somehow easier to get all the various apps on the phone to output audio to a DAC than a USB sound card?
unL33T said:
Is it somehow easier to get all the various apps on the phone to output audio to a DAC than a USB sound card?
Click to expand...
Click to collapse
I believe when the device detects a DAC (must use an otg cable BTW) it automatically re routes all audio out the USB. You can disable automatic USB audio routing in developer settings.
k.s.deviate said:
I believe when the device detects a DAC (must use an otg cable BTW) it automatically re routes all audio out the USB. You can disable automatic USB audio routing in developer settings.
Click to expand...
Click to collapse
That sounds easier. Thanks for the tip.
Well I can't find any information regarding the iPod integration and I've found next to nothing for DVD video and audio CD playback and radio and backup camera functionality would also take some mucking about so it looks like I'd probably be better off buying something like this:
http://www.ebay.com/itm/7-Android-4...621?pt=LH_DefaultDomain_0&hash=item2a31320af5
Which has it all sorted out already. So much for that fun idea. No idea what apps they use for all that stuff.
Which has it all sorted out already. So much for that fun idea. No idea what apps they use for all that stuff.[/QUOTE]
That unit looks slow at only dual-core. It will probably be sluggish when multi-tasking.
The main chip probably supports several I2S devices (aux in/adc, tuner/adc, DVD) and routing plus demuxing is done via linux hardware control.
The DVD player and tuner probably support the i2c or spi protocol to control seeking and other functions. This is again controllable via the linux devices.
Usually the consumer devices don't have these easily exposed and it's probably a non-trivial task to piggyback on existing hardware, assuming the needed connections are broken out on the board. As far as I can see the only Android devices with CD or DVD are the car players like above.
Another option would be to take the sound from the HDMI signal. A DVD player/tuner can be wired in parallel with an HDMI switcher. However controlling the tracks would not be easy, it would require emulating the remote with an IR transmitter.
Hi All,
I have lately ventured into th Androi dheadunits world and have been really happy the functionality they bring with them.
I am using a USB dac hifimediy to get audio out from the HU. The HU is a HA version and is on 5.1.1
I dont get the generic Android sounds via the DAC. When the DAC is connected i don't get any sounds from HU. I only get any sound play from UAPP. Rest all the apps which play music doesnt output to USB dac even if i am playing low bitrate MP3
Is this behavior expected or there is something that can be done? Thanks in advance
P.S:Thread is already in MTCB general
P.S2: i have the "Prevent audio rout to USB" disabled in Developer options
Hi!
I'm trying to hook up my shield to an old set of T7900 Inspire speakers. I don't have an AV receiver and would like to get surround sound via these speakers. I'm using a USB sound card that works fine with these speakers using a windows laptop, but when I tried to use the same card with the Shield, I'm only getting normal stereo. I've gone into settings and enabled 5.1 surround (auto and always on), used sources that I know are 5.1-enabled, but to no avail.
I suspect the USB sound card (which is a crappy one I'll admit) doesn't play well with Android. However, I can't find a single sound card that is guaranteed to play well with Android. So...
Do you know of any usb sound cards that work well with Android and support (at least) 5.1 surround, ideally 7.1? Has anyone done something like this with their Shields?
Thanks!
I have a asus xonar u7 USB sound card, but with the shield only stereo is possible. I think for 5.1 vor 7.1 sound we need some special USB driver's for android
Androilala said:
I have a asus xonar u7 USB sound card, but with the shield only stereo is possible. I think for 5.1 vor 7.1 sound we need some special USB driver's for android
Click to expand...
Click to collapse
It has to be the USB thing specifically though, because there's already a setting for 5.1 sound :/
Androilala said:
I have a asus xonar u7 USB sound card, but with the shield only stereo is possible. I think for 5.1 vor 7.1 sound we need some special USB driver's for android
Click to expand...
Click to collapse
Here the same. I try 2 different usb 2 analog mutlichannel audio converter, no success. Only stereo.
nvidia or android need to react to this problem.
Greetings by Idijt
Hi,
I use "Turtle beach Audio Advantage Micro II", that can passthrough 5.1 audio:
With the last Nougat update and Kodi 17 is giving some problems, but Kodi 16 and modified Kodi 17 versions (known as ****ty) it still works fine.
Not sure if it's a glitch or what. I read the possibility of re-routing your C-USB audio through your Bluetooth output was improbable because more than likely C-USB audio routing through the speaker settings when using viper4android was due to hardware.
That doesn't seem to be the case with the March update. If I'm listening to music on my Bluetooth headphones and make the switch to my aux cable using the C-USB adapter, while my Bluetooth settings are still enabled my audio routes through Bluetooth.
Anyone aware if this is a glitch or not? It's pretty amazing. As routing audio through your aux using viper4android speaker settings are trash.