Related
Hi
I am having O2 Orbit.
The Green Send key is getting pressed automatically as soon as I switch ON the device and it auto dials the last dialed number continuesly.
I opened the case all through and tried to find any obsticles physically, but its fine.
Can any one suggest any tips.
How do I disable the SEND Button, (I can use the touch screen to access the phone).
Thanks in Advance
Regards
Laxmikanth
Hi,
I don't have a solution, but I had a similar problem - my phone would just cycle through the lower buttons randomly, and I never found out what it was.
But I might have got it wet a bit, after a week or so it went away.
Then I had the phone replaced with another problem.
Is it still under warranty? If so, just take it back.
Good luck!
PS: I don't think your question should have been in the WM6 section..
Hi guys,
dont ask me how because I have no idea but I rebooted my phone after some minor activesync issues and my phone rebooted straight into bootloader!!, does anyone know how to get it back?
I dont mind if it has to be wiped because I can always re-synchronise my data but I'm staring at a brand new brick!!
Thanks guys
Terry
terryd1980 said:
Hi guys,
dont ask me how because I have no idea but I rebooted my phone after some minor activesync issues and my phone rebooted straight into bootloader!!, does anyone know how to get it back?
I dont mind if it has to be wiped because I can always re-synchronise my data but I'm staring at a brand new brick!!
Thanks guys
Terry
Click to expand...
Click to collapse
What shows in the bootloader?
Try connection with MTTY and issuing the "boot" command (no quotes).
Thanks
Dave
I know this is probably a daft question but what is MTTY?
My TP2 is completely stuck on a multi-coloured screen with information on it..
RHOD100 32MB SS-BC
SPL-0.79.0000
MicroP-Rhodium (LED) vA
MicroP-Rhodium (KEY) v4
TURBO HW/TURBO SW
TP MFG DATA
513,534 807,857
812,203 207,204
211, 859 Calibrated
What can I do?
Did you hit the vol down when you turned it on?
You can just pull the battery and turn on normally.
I may have accidentally hit the volume button, I didnt think I did anything different.
I've pulled the battery out, I've even left it an hour hoping it might drain any residual power and take out the memory but no joy.
if I pressed the volume down key and switched it on would it cause this?, I remember older phones needing a complicated combination of at least two or three buttons to be held before it would enter the bootloader.
is there a combination I could use to bring it back?
terryd1980 said:
I may have accidentally hit the volume button, I didnt think I did anything different.
I've pulled the battery out, I've even left it an hour hoping it might drain any residual power and take out the memory but no joy.
if I pressed the volume down key and switched it on would it cause this?, I remember older phones needing a complicated combination of at least two or three buttons to be held before it would enter the bootloader.
is there a combination I could use to bring it back?
Click to expand...
Click to collapse
Read here on how to get MTTY and you to connect it to your PC. Do not try any of the fixes (they are for the Kaiser), I'll posts suggestions here.
Dave
Thanks Dave,
I've just downloaded MTTY for Vista (although that only says test) is that ok?
terryd1980 said:
Thanks Dave,
I've just downloaded MTTY for Vista (although that only says test) is that ok?
Click to expand...
Click to collapse
Yeah, that's fine.
Dave
Ok... dont ask me how as I have no idea but it's just started working again!!
I havent installed anything or ran any software so I dont know why but I plugged in the USB connection and the charge light appeared, I switched it on expecting the bootloader screen but it's back in Windows!!
I am worried that this could happen again, has anyone heard of strange behaviour like this before?
Also Dave, would you be able to teach me how to fix it if this happens again please?, I have a horrible feeling this wont be the last time I see that screen... without me getting to it on purpose!
Thank you for all your help, it is really appreciated.
Terry
terryd1980 said:
Ok... dont ask me how as I have no idea but it's just started working again!!
I havent installed anything or ran any software so I dont know why but I plugged in the USB connection and the charge light appeared, I switched it on expecting the bootloader screen but it's back in Windows!!
I am worried that this could happen again, has anyone heard of strange behaviour like this before?
Also Dave, would you be able to teach me how to fix it if this happens again please?, I have a horrible feeling this wont be the last time I see that screen... without me getting to it on purpose!
Thank you for all your help, it is really appreciated.
Terry
Click to expand...
Click to collapse
It can happen for a number of reasons. Normally cmonex patches the Hard SPL with some fixes to stop it happening for "Random" reasons - so Hard SPL is a good way to fix it (Hard SPL has other benifits too) when it's our. There is no set fix, different causes, different solutions. If the problem becomes common on the Rhodium, I'll do you another sticky.
Thanks
Dave
Thanks Dave, you're a star.
I had this problem on my Kaiser.
Back then, I thought that it would be a problem with the device memory (like corrupted blocks in the bootloader area).
I did the FrankenKaiser to completely "format" the phone and it solved the problem for a while, but then, a month or two later, it appeared again.
I started thinking that it was a problem with the USB connector (pins shorted). Today I believe that this is the culprit. My advice: return the phone and get a new one.
just wondering if anybody here has experienced issues with the phone application and if there is a fix available...I've had my desire z for almost a month now, and for some reason once I attempt a phone call, I can't press the end call button. Also, at times, when I get a phone call, no matter how many times I press "accept", it doesn't work....I don't know if this is a bug, because sometimes it works properly and other times, it won't....It also happens while screen is in power saver mode....if I get a call, I cant unlock the screen to answer a call....please HELP!!!
Are you rooted and running a custom rom?
Sent from my CyanogenMod powered G2.
This might not help you, but I had a problem very similar to this, and it turned out to be because of my screen protector. Don't ask me why, it was fine most of the time, but when I was receiving a call I couldn't answer it most of the time. Replacing the screen protector with a different type fixed the problem for me !
It's a long shot, but if you are using a screen protector, try peeling the bottom up and seeing if you can answer by pressing on the screen itself.
Hi guys...thanks for replying....
steviewevie...that sounds weird, but I'll give it a try, although it still doesn't answer my question on why it sometimes works, and other times it does not....thanks anyway...
utorrent....I'm not sure...how do I find out? I'm using the rom that originally came with the phone....you have any suggestions on which rom I should use to fix the problems?
Thanks guys!
Hello!
Lately I've had this problem at three or four different, seemingly random times. The Vol Down button seems to activate all by itself and is being "kept" pressed down. I can raise the volume by pressing Vol Up but the moment I let it go it goes down to mute again very fast (I can see the volume slider when this happens). As a result I can't use the Power button and all I can do is either wait a bit and hope it goes away or use a program (say, xposed installer) to reboot the phone. The problem may persist after reboot, though if I manage to turn the phone off and then back on it seems to go away.
It has happened too few times to do conclusive testing, but that's all the data I have... My M8 (Int'l, rooted) is running Android Revolution. Do you guys think this might be a software or a hardware issue?
Thanks for listening...
You should try a different custom rom just in case if it is a software issue. If it happens again after that, it's a possible hardware issue. Do you have any cases on it?
No case - sometimes I use the included plastic one but this happened only when the phone was naked.
Worth saying the device is in perfect shape, has had a couple of very minor and soft (on my leg) drops but that's all.
I'll try a clean install and also another ROM - an ask in the ROM's thread if anyone else has had the symptom, though I did search before posting here and found nothing...
Thanks for your input!
Just an update; it must have been a hardware issue after all.
One day that the problem was very apparent, I knocked it lightly on its side on a piece of soft wood, and haven't had the problem ever since. Whether it was a piece of dust on the contact or the rocker itself was stuck or dislodged somehow, this seems to have fixed it and haven't had the issue again in several days now...
So hello community !
I have an OPPO Find 7 device, and I love, but happens that I have some problem with it, let me explain it best I can
It turns out that I simply cant Power ON the device, no matter what I try, no matter what combinations of key I am using or so. Let me explain better.
As I was using one day my phone standard it happened the lock/power key doesn't respond every time I press it, and it was so, sometimes the phone reacted to the button some times didn't. One day I had the device, and forgot to charge it, and it went completely off, so I can't even boot it up. Went to an mobile center, where they repair mobiles or so, it is small place, I explained them what is the problem, they told me it is the button power supply or so, and fixed it. That was nice, finally I had my OPPO again. After 2 or 3 weeks, again the same problem with the button didn't responded and I again took it with me and gave it to the person that fixed it the first time. They said the it is kinda complicated or so, I took it to other place to see if they could fixed it, they told me it is the POWER SUPPLY to the POWER/LOCK key. It is a waste this phone to throw it in garbage because one maybe small problem if you ask me .
Hopefully someone will see this and reply to me, I still have the phone just cant power it on.
P.S The battery is fine, the charger is fine, tried every combinations of key (just the power key doesn't seem to reply in any way or it cant get power supply). I have some minor knowledge in phone's I can tear it down but I need help or maybe solutions from you guys. Thanks again !
Still no-one that can help me maybe somehow
Did you buy it from oppostyle?
Yes that is correct, look forward to your reply and any others who think they can help ?
VASILEVSKI said:
Yes that is correct, look forward to your reply and any others who think they can help ?
Click to expand...
Click to collapse
Hi, do you still have this issue?
Did you just upgrade your phone before this happen?
Yes I still have this issue, I didn't upgrade my phone before this issue. I don't think it is an software error tho....
Got my phone still sitting in my shale
I was facing similar problem, but in my case I cannot charge the phone, and it turn out to be software problem during upgrade.
I went to oppo service center and they re-flash with the latest ColorOS then my phone back to normal.
I thought if you just upgrade your phone, you might face same issue like what I was. Or maybe you can try to go to oppo service center?
Try this. http://community.oppo.com/en/forum.php?mod=viewthread&tid=23067
If its software related this will fix it. If it doesnt I dont know anymore.
Hi
Does your phone vibrate ?
Snorl4x said:
Hi
Does your phone vibrate ?
Click to expand...
Click to collapse
No it doesnt vibrate... The power on off button dont respond
Send back to Oppo to repair or mobile shop to repair power button. Its not difficult if its only problem on button.
Power button problem
this site helps you in fixing that issue.. try it
https://www.ifixit.com/Guide/Oppo+X9000+Power+Button+Replacement/31581
VASILEVSKI said:
So hello community !
I have an OPPO Find 7 device, and I love, but happens that I have some problem with it, let me explain it best I can
It turns out that I simply cant Power ON the device, no matter what I try, no matter what combinations of key I am using or so. Let me explain better.
As I was using one day my phone standard it happened the lock/power key doesn't respond every time I press it, and it was so, sometimes the phone reacted to the button some times didn't. One day I had the device, and forgot to charge it, and it went completely off, so I can't even boot it up. Went to an mobile center, where they repair mobiles or so, it is small place, I explained them what is the problem, they told me it is the button power supply or so, and fixed it. That was nice, finally I had my OPPO again. After 2 or 3 weeks, again the same problem with the button didn't responded and I again took it with me and gave it to the person that fixed it the first time. They said the it is kinda complicated or so, I took it to other place to see if they could fixed it, they told me it is the POWER SUPPLY to the POWER/LOCK key. It is a waste this phone to throw it in garbage because one maybe small problem if you ask me .
Hopefully someone will see this and reply to me, I still have the phone just cant power it on.
P.S The battery is fine, the charger is fine, tried every combinations of key (just the power key doesn't seem to reply in any way or it cant get power supply). I have some minor knowledge in phone's I can tear it down but I need help or maybe solutions from you guys. Thanks again !
Click to expand...
Click to collapse
Sorry, didn't realized you replied my comment already. Since you purchased your device from Oppostyle, i would suggest you to do RMA. However, the process is going to take quite a long time.