Develop Bugs

Ace 2x hard bricked

I have a ace 2x i used this metod: http://forum.xda-developers.com/showthread.php?t=2483143 to port a ace 2 rom to ace 2x.
First what i did whas making a nandroid backup,then in twrp 7.0 i go to wipe advanced and slected cache system dalvik and data.
It give me a failed error, then i restored my nandroid backup it give me no errors and i rebooted then i only see galaxy trend screen and then it turns of. I can't enter recovery or download mode, is there anyway to fix?
Im on cm11 last build of jonypx09.
other thing is i don't have a triangle so if no one can (help me ) fix it i revert it back to samsung.
Sorry for my bad english

IjazCI said:
Hi
I encountered the same situation in my s duos, while i tried to port asop. Even Usb jig failed to put the phone to download mode.
Samsung service center replaced my board as there is no yellow triangle. You can do the same.
Click to expand...
Click to collapse
Thanks but i already bring it to samsung service center.
But again thanks for reply.

Didn't they specifically say that the method gives bootloops so often?

[Q] unable to flash stock,install rom,and struck at recovery loop

anyone pls.i need a help seriously..i installed blisspop 1.8 in my lg f240L.everythng worked fine.but i found that my call voice quality was very low and thought of going back to my old rom VUPMP.so aas i read in some sections for gng back frm cm12,shuld go from philz recovery,i did that.but unfortunately after installation of that rom my phn is showing only lg logo.i did hard reset by holding power down+home button+lock button.after that im getting a recovery loop.then i decided to flash a stock rom using lg flash tool.but in download mode its showing error in connection between cellphone and pc even though the usb cable was good.so now i got struck.please anyone solve my problem,with a detail procedure.ill be very thankful to u..please help me...

If you loop back to the recovery once again, try flash philz recovery, go into advance, and boot back into the recovery. Now do a clean installation of the Rom you're using. let me know if this works out for you.

Bricked Samsung Galaxy Tab 3 8.0 Please help!!

Hi all !
So two days ago i wanted to update my Sm-t310 to 4.4.2 from the tab itsself, but it wasn't possible, because i had rooted it before. So i tried to remove my root and then something happened and my tab got stuck in firmware upgrade encountered an issue. please select recovery mode in kies & try again charging battery screen.. i looked for solutions with both kies and odin, but they get stuck at 7% while flashing????? Nothing seems to work, i tried it even through the philz recovery mode after wiping cache and deleting cache partition, but it only gets stuck at the boot loop and then when i try to flash it with odin it gets stuck on system.img at about 7%... I really don't know what to do :crying: Please help me, I am desperate !

Hi,
This thread is being moved to your own dedicated forum, where the experts may be able to help you better.
Good luck!

benzomarie said:
Hi all !
So two days ago i wanted to update my Sm-t310 to 4.4.2 from the tab itsself, but it wasn't possible, because i had rooted it before. So i tried to remove my root and then something happened and my tab got stuck in firmware upgrade encountered an issue. please select recovery mode in kies & try again charging battery screen.. i looked for solutions with both kies and odin, but they get stuck at 7% while flashing????? Nothing seems to work, i tried it even through the philz recovery mode after wiping cache and deleting cache partition, but it only gets stuck at the boot loop and then when i try to flash it with odin it gets stuck on system.img at about 7%... I really don't know what to do :crying: Please help me, I am desperate !
Click to expand...
Click to collapse
Since you mentioned that you still have your Philz custom recovery, have you tried flashing a rom. It may or may not work, but it is worth a shot.

Most Software broken Gt-N7100 , Can you help?

Let me get straight into this , first of all , I was running stock 4.3, then rooted it , then decided to change to 4.1.1 stock rom , the device started to act like a complete idiot , it shuts automatically , and sometimes it doesn't start up , also sometimes it gets stuck at boot screen "Galaxy Note II - GT-N7100" screen . Then decided to try prerooted Wanamlite 4.3 JB , it had the same problems as the 4.1.1 . I tried looking up the forum a lot , the links for knox-free roms were down so was I .
+ Some times when the device boots up , it says "Firmware upgrade encountered an issue , select revory mode in kies" or sth like that .
+Knox warranty void : 1
+ (I dont remember) : A2
I tried flashing official 4.4.2 , but odin gets stuck on odin "complete(write) operation failed" .
Plz help .

Ahedfares said:
Let me get straight into this , first of all , I was running stock 4.3, then rooted it , then decided to change to 4.1.1 stock rom , the device started to act like a complete idiot , it shuts automatically , and sometimes it doesn't start up , also sometimes it gets stuck at boot screen "Galaxy Note II - GT-N7100" screen . Then decided to try prerooted Wanamlite 4.3 JB , it had the same problems as the 4.1.1 . I tried looking up the forum a lot , the links for knox-free roms were down so was I .
+ Some times when the device boots up , it says "Firmware upgrade encountered an issue , select revory mode in kies" or sth like that .
+Knox warranty void : 1
+ (I dont remember) : A2
I tried flashing official 4.4.2 , but odin gets stuck on odin "complete(write) operation failed" .
Plz help .
Click to expand...
Click to collapse
Install TWRP with ODin Then DIsconnect From PC And Remove the battery from phone
Now Go TO REcovery
Do Alll Wipe Then Go TO DownloAd Mode
Than Install Stock Rom With ODin
Hope It Works GDluck

Chaudhary Abdul said:
Install TWRP with ODin Then DIsconnect From PC And Remove the battery from phone
Now Go TO REcovery
Do Alll Wipe Then Go TO DownloAd Mode
Than Install Stock Rom With ODin
Hope It Works GDluck
Click to expand...
Click to collapse
Ok , I installed Official 4.4.2 successfully , but the phone keeps on shutting down by it self.

Ahedfares said:
Ok , I installed Official 4.4.2 successfully , but the phone keeps on shutting down by it self.
Click to expand...
Click to collapse
If Ota Update IS Available Install It
If Shut Down Problem Is Still Persist Than Root And Try WIth Custom Rom
Gdluck

Ahedfares said:
Ok , I installed Official 4.4.2 successfully , but the phone keeps on shutting down by it self.
Click to expand...
Click to collapse
do you chrged it until it's full ? please check it's not a battery issue

michaelliem said:
do you chrged it until it's full ? please check it's not a battery issue
Click to expand...
Click to collapse
it is not a battery issue , it is charged and sometimes it turns off when it is charging , so diffenetly it is not a battery issue

yu yureka plus in boot loop after flashing any rom

i flash [UNOFFICIAL][7.1]CyanogenMod 14.1[TOMATO][VOLTE] in my yureka plus.....then it goes in boot loop.after i Wipe cache / dalvik cache / data / system...... using twrp and try other rom like..... MIFavor V3.5 with Full VoLTE axis for yureka ,then cm-12.1-YOG4PAS3JM-tomato-signed but every time it goes to boot loop.....so i change my twrp and format my all data include my phone memory and try flash rom but not solve the problem.
plzzz help me.....what i do because my phone not working.

Just flash cm12.1 by fastboot method.

Same problem here
i tried flashing cm12.1 also but doesn't stop looping
please help if anyone has solved this problem

Use charger while booting. It seems strange but still it works for me.

First factory reset your phone by going into recovery,then wipe cache/partition,then try flashing cm 12.1 by fastboot method.Download the ROM at
https://drive.google.com/file/d/0B_aCRdb2PZn7ajl1N25WZjV5LTg/view?pli=1 and connect your phone with PC in fastboot mode.Then run flash file in the given files.(extract all files in one folder).Hope this works.Thanks

chinmay888 said:
Just flash cm12.1 by fastboot method.
Click to expand...
Click to collapse
i also stuck in the same problem please provide solution if there

girish8193 said:
i also stuck in the same problem please provide solution if there
Click to expand...
Click to collapse
Flash cm 12.1 by fastboot

i had a friend's yureka with bootloop on YU logo,i flashed it using adb fastboot,the phone started vibrating and dint even turned on,only goes to fastboot mode after long pressing volume up and shows red light on connection.I also tried emmc image burning on sd card method but still in same condition.Please help

iamtj said:
i had a friend's yureka with bootloop on YU logo,i flashed it using adb fastboot,the phone started vibrating and dint even turned on,only goes to fastboot mode after long pressing volume up and shows red light on connection.I also tried emmc image burning on sd card method but still in same condition.Please help
Click to expand...
Click to collapse
Its easy to recover just download telegram and search me my username is @chinmay888.I will tell u step by step to recover.Because its more convenient on it.

chinmay888 said:
Its easy to recover just download telegram and search me my username is @chinmay888.I will tell u step by step to recover.Because its more convenient on it.
Click to expand...
Click to collapse
ok i'll contact u

Ok so here is what happened. I tried installing a custom recovery on my yureka plus and I flashed the file using an android app called rashr. By mistake I chose flash as recovery and then whenever I would switch on my phone it would boot up into fastboot mode. I watched a YouTube video o how to fix my phone stuck in a bootloop and followed all instructions. After that when I tried to turn on my phone it actually went into a bootloop and as if that wasn't enough it also does not display the logo properly. Instead I am seeing coloured bars on my phone even when I boot it into recovery or fastboot mode. How do I fix this?

If you have Yureka Plus COS variant than flash COS12.1 factory image from fastboot.

saurav007 said:
If you have Yureka Plus COS variant than flash COS12.1 factory image from fastboot.
Click to expand...
Click to collapse
If the phone is in warrenty, show it to customer care
Rooting doesn't woid Yureka's warranty
My phone was also showing blue lines and orange colour bars, random reboots, heating issues
Service center swapped my phone!

me too
chinmay888 said:
Its easy to recover just download telegram and search me my username is @chinmay888.I will tell u step by step to recover.Because its more convenient on it.
Click to expand...
Click to collapse
;

Want to sell Dead You Yureka ?
Guys if anyone want to sell your dead Yu Yureka.. I will buy even if it is hardbricked and its getting detected as HSUSB-BULK or Qualcomm QDLoader in the computer..:good:

this repair will fix the loop permanently
https://www.youtube.com/watch?v=Q60ZkevoESc

https://www.youtube.com/watch?v=Q60ZkevoESc&t=39s
This video will help in fixing the bootloop without changing a battery
help me sharing this video