Dear all,
i've got 2nd hand xda stealth for 2 weeks, now my stealth cannot boot (black screen, call and End Button are light) after i flash my stealth with wrong ram with nb0 extension on miniSD. please any one can help me to recover my Stealth ?
sorry for my bad english.
xda stealth..
go to www.seeo2.com, download a rom upgrade utility from there.. then start upgrade procedure again. As xda stealth is a hybrid phone..dont try any custom roms on it..
thank's malhar for responding my thread.
i already download the upgrade rom from the o2 site (now is www.mwg.com), i put the rom to my SDCard, the problem is how can i enter the boot loader, in case my stealth always in blank screen with call and end button are light.
i already press press power + call + end button, but my stealth stuck on that condition. every method of flashing mode i already try but no response from my stealth.
Syaipul
oh yea malhar, for information i read the procedure for upgrading on o2 site that connect status is required for upgrading procedure in activecync, my stealth has disconnected status when i plug to my com. can i do the upgrade the rom in this case?
buddy, remove ur sd card from the device first..and then hard reset ur device by pressing reset button via stylus, then flag which is windows home key and then ok key..reset+flag+ok.. maintain the sequence..press reset first keep on pressing then flag and ok key.. it will format ur device.... then try to flash new rom on it
ok malhar, i'll try tomorrow. thanks.....1000x
sad-sad-sad
my stealth cannot boot (black screen, call and End Button are light) after i flash my stealth with wrong ram on miniSD. please any one can help me to recover my Stealth
Your SPL boot loader sounds like it is gone, formatted...
You may be able to patch it, using scripts & mtty if you can get into DL mode. Sounds like you're stuck in OEMSBL though.
help me !!!!
i have try pressing flat and ok botton to format . but nothing appear on the screen . is the other way to format or upgrade rom .
• The device doesn't boot, I see only O2 logo. Hard reset doesn't help and the Firmware update process stops with the first message?
1. turn off the device;
2. enter engineering mode;
3. in Main menu choose Boot Config;
4. in Configuration menu choose EBOOT-Launch Image;
5. turn off the device;
6. now hard reset or upgrade firmware.
Sometimes helps another method: leave the device without the battery for about 30 minutes, then turn your O2 XDA Stealth on.
• How to enter engeneering mode?
1. turn off your O2 XDA Stealth ;
2. hold Flag, OK and Camera + press and hold Power button;
3. use navigation buttons to select the settings.
Click to expand...
Click to collapse
follow this thread from YUC wm6
http://forum.xda-developers.com/showthread.php?t=352468
blank screen
for my case, i cant even see the o2 logo, only blank screen. is there any other way to reboot ?
cant see o2 logo
for my case, i cant even see the o2 logo, only blank screen. is there any other way to reboot ?
randysng said:
for my case, i cant even see the o2 logo, only blank screen. is there any other way to reboot ?
Click to expand...
Click to collapse
Have you tried removing the battery for few hours ??? Does the engineering mode work???
engineering mode
engineering mode ? how to set engineering mode ?
randysng said:
engineering mode ? how to set engineering mode ?
Click to expand...
Click to collapse
How to enter engeneering mode?
1. turn off your O2 XDA Stealth ;
2. hold Flag, OK and Camera + press and hold Power button;
3. use navigation buttons to select the settings
can u see..lights on keypad??what happens when u connect to pc..any sound or error
??
malhaar said:
can u see..lights on keypad??what happens when u connect to pc..any sound or error
??
Click to expand...
Click to collapse
i have a O2 tealth hanged on O2..... i tried hard reset but din work .... i downloaded new rom and software for updation .....but the problem is i cannot connect to pc.... active sync is installed...... plz help
khalifa_smart said:
i have a O2 tealth hanged on O2..... i tried hard reset but din work .... i downloaded new rom and software for updation .....but the problem is i cannot connect to pc.... active sync is installed...... plz help
Click to expand...
Click to collapse
It worked for me
Goto to your PDA setting and uncheck USB to PC.
Note: Check task before connecting to USB ensure no task including Active Sync.
FYI.
Im using VISTA Ultimate to update my XDA.
From WB 6.1 back to WM5. WM 6.1 too buggy and battery drained fast.
Cheers!
Please help me O2 stealth it dead not boot and blank screen .Are you Jtag for it please post it here.
i have the same problem --- my stealth is absolutely dead after using a cheap local charger
i have dismantled the board and taken some pics of the jtag connectors -- made the common LPT port jtag cable
how to proceed from here ?????
is the procedure similar to that of jtag recovery of a flame or an atom exec ??
how do i find the bootloader for O2 Stealth for flashing the NAND memomy Disk on Chip ??
please share your insights
I tried to update my htc universal O2 to a room. but after a long time nothing was going to work and I broke it, now my screen is black but can be seen that written on the top serial and on the bottom v2.02. When I try again with other program show me that there is no old and no new system and will not done. My English is bad, and please try to understand this!
Hi there
Put your device in bootloader mode (hold the power button and the light button and put the stylus in the reset hole at the same time),and then connect your device to your computer and then reinstall the original rom.That is it.
Welcome to forums
have a read on my signature link, you´ll find all you need
Good luck,
Hi folks, I really hope you can help with this problem with my HTC Wildfire. The phone came into contact with water and as a result is now stuck in the bootloader screen. (I am advised by the three mobile reps that the red tabs in the back of the phone indicate that water has been present and that if these are not white then the warranty is void)
I am unable to select any of the menu options that are displayed as the volume up and down key have no effect when on this screen. I do know that the keys do however work as when I press the down volume key and the on key the phone attempts to boot from the SD card (with no success as it goes through a series of messages which read image not found)
Can anyone help me get the phone working again?
I have at my disposal: a laptop, data cable, sd card and reader/writer and another working HTC Wildfire phone which was purchased at the same time so has the same 2.1 Android OS version as mine had. (if this helps)
I would be really grateful for assistance and I'm sure that others would benefit from answers to this problem too.
Cheers Ben
Here's the thing , I unlocked my bootloader and rooted my phone a while back (probably using an already outdated software , if i remembered correctly it was 2.3.3 , but i knew i followed the instructions here
http://forum.xda-developers.com/showthread.php?t=1133650)
Today, my phone asked if I wanted to update the software (like an automated software update) and i could choose to update or not and i chose yes but now , my phone won't start up for like 3 hours already . I tried turning it on but it won't turn on , i tried charging it but there isn't any lights which was supposed to be there .
So I decided to google it and i followed the instructions here
http://talk.sonyericsson.com/thread/26720
but after installing both , choosing my phone , followin the instructions on update service , it gets stuck on "it contains a modified software that cannot be updated" so decided to come back here to ask you guys what I should do .
Right now , all I want to do is for my phone to start up again , any ideas ?
edit : right now , i took out the battery , and put it back in . This time when I tried to turn it on , the vibrate is there which wasn't there initially and theres 1 flash of the green light on the side of the phone .
and also , i think its recognized by the computer because i can hear the sound notification (the same sound when you plug a USB into a computer) which wasn't there before I did the update service thingy .
edit 2 : it won't go into safemode either when i tried clicked the right and left buttons below the display (the menu and back button) and the power button after that . yes i tried reinserting the battery .
edit 3 : I'm not sure if this'll help but my phone is recognized as SEMC flash device (i checked on device manager) and theres a green colour non flashing light when i plug my phone into the pc .
http://forum.xda-developers.com/showthread.php?t=1304634
OMG
Thanks
Sorry for not searching , I tried looking for Xperia arc won't load up / start up but it didn't give me this thread .
Thanks again
edit : i thanked you too
same problem!!!
Guys, I was trying to modify my phone so that applications would be saved in memory card instead of internal storage, so I rooted it and stuff.. Now it won't turn on!!! When I switch it on, it shows the SE logo and does nothing else.. I tried to enter the safemode menu (holding left and right keys when switching on, or volume down key and home key when turning on) but nothing works!!! I'm like desperate now so any help would be really appreciated!
gadjet87 said:
Guys, I was trying to modify my phone so that applications would be saved in memory card instead of internal storage, so I rooted it and stuff.. Now it won't turn on!!! When I switch it on, it shows the SE logo and does nothing else.. I tried to enter the safemode menu (holding left and right keys when switching on, or volume down key and home key when turning on) but nothing works!!! I'm like desperate now so any help would be really appreciated!
Click to expand...
Click to collapse
Try to flash a new(er) kernel with recovery and install a new rom (your phone is ota-bricked, so if that doesn't work, search on XDA)
Sent from my LT18i using xda premium
when i swith on the phone a screen comes which aske me password. its is a new phone it this come without inserting the sim also.
does anyone know any solutions or can anyone tell me how to hard reset the phone?
and when i switch off the phone and press volume up + power key and when a menu appears and i choose recovery by pressing volume down key then a chines screen appears and after 2-3 min phone reboots.
and please don't type phone s fake Chinese. its brand new bought from amazon.in
please help
Contect amzon
So just contect amzon and tell ur problem and tell them to replace ur moblie... they will replace ur mobile... i guess so... contect them
Unlock the bootloader and flash cwm recovery. There are guides and tutorials in the development section of this forum, from recovery you can wipe data