Know why but the ringtone volume occasionally goes to zero.
This is what I .
Related
When I have locked my device and the screen is turned off and I press the volume rocker, it puts the screen on and changes the ringer volume. Can I disable this somehow? Very annoying since the volume rocker itself is very sensitive.
Try any of these : http://www.appbrain.com/search?q=volume+lock
My volume buttons will only adjust the call volume, even when I'm not in a call.
Yesterday I was listening to music and tried to adjust the volume from the lockscreen, but when I did the phone adjusted the phone volume instead. So I went into my music player app and tried there, same result. I pressed the volume again, and this time expanded the volume panel, and was able to adjust the volume from there. I then started playing around with the volume to see what it would do. I toggled vibrate/mute and the volume panel showed no change in the phone volume. It was after this that I noticed that the label on the volume panel next to what was normally the ringtone volume read "call volume" instead. I figured it was a weird one-time glitch, so I rebooted. No change. Pulled the battery, success! But a few minutes later I had the issue again. Hard reset again, same result. So it seems my phone thinks it is always in call.
I can only adjust music volume from the panel and only adjust ringer volume from the sound settings.
Any ideas as to why it is doing this?
Problem solved!
Apparently having www.weavesilk.com open in my chrome browser was causing the problem. I closed the weavesilk tab and my volume works just fine now. Weird.
so normally you can toggle vibrate mode on/off by pressing the volume button once, when the volume slider appears in the top of the screen, pressing the bell on the left of the slider toggled between ring and vibrate.
normally when you toggle in and out of vibrate mode it will remember the ringer volume that is normally set. i.e. i normally have ringer at maximum, if i toggle on vibrate mode the slider goes all the way down, and if i toggle out of vibrate mode the slider goes right back up to maximum volume. I has been like this since kitkat i think?
problem is with the OP3 when i toggle out of vibrate mode the ringer is back on but only at a low level. Anyone have any idea why this happens?
I found the minimum volume too loud in many cases. I.e. the lowest volume is too loud in a silent room, press the volume down button once more and it goes completely silent, and there is nothing between... Is there any way to re-calibrate the volume settings?
Hi everyone.
Regarding the alert slider, the media volume is not muted in vibrate mode (middle of the switch) and remains the same volume as in ring mode (power button side).
* Silent mode (top) mutes everything.
I would like the media volume not to be muted in ring mode and muted in vibrate mode. Is it possible to customize this?