help me with my problem of my acro s, It suddenly turned off and now I can't open it. I tried the hard reset but no luck. I tried to charge it but no boot animation show, only the orange led light appear for just a minute when plug in w/ the charger. I CAN'T TURN ON MY PHONE.
CAN SOMEONE HELP ME, I REALLY DON'T KNOW WHAT TO DO SINCE MY PHONE CANNOT BE DETECTED WITH MY COMPUTER AND i CAN'T EVEN ENTER FLASH MODE.
*TRIED POWER + VOL UP
* POWER + VOL DOWN
Related
I've owned the DEFY for over two months, it is rooted but not flashed. Installed many apps and it had been working fine.
Today it suddenly go black when charging. Then, when pressing the power button, nothing happened. At first, when it was plugged into the PC USB port, the white LED was on. But later on, even the LED was always off.
Connected to PC via the USB cable, take the battery off and put it on again, the USB connecting and disconnecting sound was played on the PC. The Windows XP hardware manager briefly showed "Motorola USB device" and then it disappeared.
The screen is always black. Nothing seems to happen when pressing the power button, power+volume up, or power+volume down.
Please help!
I borrowed another DEFY and charged the battery to 100%. The problem persisted. The battery is good, for it can be used with the other DEFY.
Did you overclock your Defy? If yes, this might be your answer!
No. It has never been over-clocked. Just normal usage all the time.
If it can't even get to the recovery (hold volumn down) or bootloader (hold volumn up) screens, there's probably nothing can be done other than sending back for repair.
DEFY won't start after Flashing Chinese Froyo ROM
Hi,
I have the same problem: tried to flash Jboogie3 BlurlessGinger(2/16/2011).
Donwloaded the chinese rom from this thread: http://forum.xda-developers.com/showthread.php?t=895448
Flashed with RSD Lite: Result was "finished" and "PASS".
Pulled out the USB-Cable, LED light went off, but nothing happend.
Tried to reboot but no reaction from my DEFY. Even after pulling out the battery.
No Recovery Boot and no Bootloader Mode. :-(
Can anyone help please.
Thanky you in advance,
hartmuna
--------------------------
Hey guys,
luckily RSD was still able to connect to my DEFY even though it seemed dead. I reflashed the PL Froyo rom and it booted up smoothly. So be aware of the chinese rom!
Hey, so I flashed KA Xperia SSpeed kernel v7 to my phone after having successfully Installed the ROM for SSpeed Kernel. After I tried to reboot the phone it just will not turn on.
The only thing that happens is as follows:
-If I hold power and UP volume button the phone will vibrate once and then vibrate 3 times.
-If I plug the phone into my computer nothing will happen until I press the volume up and power button
-IF I do the 2nd thing, the Green LED light on my phone either stays solid green or stays green for about 10 seconds, turns off and comes back on again.
-Flashtool recognizes the phone is connecting and disconnecting but will not perform any functions because it says "13/034/2012 16:34:40 - ERROR - This action needs a connected device"
-Flashtool says my device is connected in Flash Mode
I can provide any more information if need be. Please help, I really don't know what to do and I'm in serious panick mode
here try this:
1.connect your phone to pc.hold power+volume up then wait till it vibrates three times.
2.open flashtool then choose the firmware you want to flash.
3. when it says connect your phone, hold power+volume up then wait it vibrates 3 times again then immediately hold power+volume down.
4. then it will flash the firmware.
Hello guys, I have a Xperia S LT26i in the Italian official version of software 6.1.a.2.55 rooted by E-Root v1.0.14 ( locked bootloader )
i wiped battery stats (after wiping data...cache ...all what we can wipe, mount and unmount every thing from the clockworkmod )
i reboot the mobile from the recovery then it crash in the Sony logo it crashes in the sony logo which stays a long time i forced restart by pressing Power button+volume(+) ( tried one viration and three vibrations )
Then the sony logo appeared and won't go away.. I cant boot anything. doesnt respond to hard reset (3 vibrates)
PC wont recognize my phone.
then the same thing happened until nothing displays on the screen and the notification led litghs red lights red when I connect with pc or AC power
then the mobile doesn't turn on or start on recovery mode again and is not recognized by Windows on Flashtool or on the SEUS
i tried to remove/insert battery, waiting to battery drain, charging the mobile without results
what should I do?
hold vol - when phone is powered off and connect usb cable (led should become green), than use flashtool to reflash any stock ROM
aiola1982 said:
hold vol - when phone is powered off and connect usb cable (led should become green), than use flashtool to reflash any stock ROM
Click to expand...
Click to collapse
When I hold vol(-), connect the phone to pc led become red most times and once in a way it become green for a short time then comeback to red not the time to do a full repair sony update Service or full flash with flashtool i did a successfull repair with the Sony update Service but stopped in the middle and then continued they said that's the phone is repaired successfully but i still have the problem ( won't turn on won't start recovery )
Can you try with another cable? Maybe the one you used is damaged. The phone normaly doesn't exit flashmode when recovery / repair is started.
If this doesn't help give it a try with newest flashtool, get a ftf file for stock fw .55 or any other version you want (would prefer any ICS version). Prepare everything in flashtool until you're told to connect the phone in flashmode than do so ( hold vol(-) ..., or do a soft reset and hold vol (-) with connected usb cable. If your phone enters flashmode (green led), flashtool should start flashing immediately.
After wiping out data and cache in CMW recovery, my phone automatically shuts down. now it wont turn on even by pressing the power button + vol+ or vol- . I Tried flashing stock firmware using the latest flashtool but it says * device connected with USB debugging off * . i left the phone plugged in to charge but only red light appears for hours and it still wont turn. Red light turns off every now and then . Please help i dont know what to do please help . What do i need to do get my phone working again ?
xxlongstarxx said:
After wiping out data and cache in CMW recovery, my phone automatically shuts down. now it wont turn on even by pressing the power button + vol+ or vol- . I Tried flashing stock firmware using the latest flashtool but it says * device connected with USB debugging off * . i left the phone plugged in to charge but only red light appears for hours and it still wont turn. Red light turns off every now and then . Please help i dont know what to do please help . What do i need to do get my phone working again ?
Click to expand...
Click to collapse
Try doing this.. Hold Volume Up and Power button until u get 3 vibrations after the 1st vibration.. Then put it to charge.. And if u r seeing a charging animation, let it charge fully.. And then try rebooting.. If it doesn't turn on, just flash stock ftf.. Hold volume down and connect the cable.. Don't let go of the volume down button until flashing starts..
sudhindrakv said:
Try doing this.. Hold Volume Up and Power button until u get 3 vibrations after the 1st vibration.. Then put it to charge.. And if u r seeing a charging animation, let it charge fully.. And then try rebooting.. If it doesn't turn on, just flash stock ftf.. Hold volume down and connect the cable.. Don't let go of the volume down button until flashing starts..
Click to expand...
Click to collapse
I held down volumn up and power button for at least 2 minutes there's no response , no vibrations whatsoever. i tried flashing stock ftf .But every time i connect my phone, flashtool displays * device connected with usb debugging off * despite holding down the volumn button for at least 3 minutes please help .
On a side note ive charged this phone for at least 20 hours now and it still only shows red LED no other colour
xxlongstarxx said:
I held down volumn up and power button for at least 2 minutes there's no response , no vibrations whatsoever. i tried flashing stock ftf .But every time i connect my phone, flashtool displays * device connected with usb debugging off * despite holding down the volumn button for at least 3 minutes please help .
On a side note ive charged this phone for at least 20 hours now and it still only shows red LED no other colour
Click to expand...
Click to collapse
Then i think u have some H/W problem.. May be something to do with Motherboard.. Get it serviced with Sony Service Center.. Tell them some joke excuse...
xxlongstarxx said:
I held down volumn up and power button for at least 2 minutes there's no response , no vibrations whatsoever. i tried flashing stock ftf .But every time i connect my phone, flashtool displays * device connected with usb debugging off * despite holding down the volumn button for at least 3 minutes please help .
On a side note ive charged this phone for at least 20 hours now and it still only shows red LED no other colour
Click to expand...
Click to collapse
Can you connect it in fastboot mode?
Dark Wraith said:
Can you connect it in fastboot mode?
Click to expand...
Click to collapse
No i could not . When i connect my phone to my computer with red LED nothing pops up on flashtool, when the red LED disappeared i tried connecting it in flashmode holding down the vol down buttom as guided by another thread. got no response and same goes with fastboot mode, no luck either ):
Hi guys,
I have been "gifted" by broken Xperia Z1C and I'm trying to fix it.
The issue is that when I try to power on, it's trying to boot, but it will turn off during blue animation, not sure if it's boot logo. However, when I try to charge the phone, it will show
"Your device turned off due to overheating. Charging will continue after the device has cooled down." and as you supposed, it will never happened.
I have tried:
- hard reset by volup + power button
- reset with red button near sim card
- xperia companion repair - result: successfully repaired, but nothing happend to device
- flashing older firmware D5503_14.5.A.0.270_Generic BAL.ftf using Flashtool - successfully but nothing happened
- some magic commands with fastboot.exe, nothing happened
Then I have tried to change battery from another Z1C, device is not responding on power on button (just 3 times red led blinks after charger connected) . Then I have put back the original battery to broken device, same overheating issue.
Now I think it's hardware issue, or do you have any ideas? Why another battery don't works?
Thanks