Hi Guys,
I have an unlock code from AT&T and I want to use it from the Stock ROM. I am currently running CM 11 nightlies.
I tried the standard method of using ODIN from PC to flash stock ROM. It doesnt seem to work. I am always stuck in ;NAND write Fail'.
Before installing CM a while ago I updated OTA to 4.3, and based on what I read everywhere this seems to have something to do with the issue.
Any help on how to proceed will be great.
I am using ODIN 3.07
Downloaded Stock ROM from sammobile.
This is what my download screen reads.
ODIN MODE
PRODUCT NAME: SGH-I747
CUSTOM BINARY DOWNLOAD: Yes (2 Counts)
CURRENT BINARY: CUSTOM
SYSTEM STATUS: Official
QUALCOMM SECUREBOOT: ENABLE
Warranty Bit: 1
BOOTLOADER AP SWREV: 2
SW REV CHECK FAIL: Fused 2 > Binary 0
Thanks!
Once you have the 4.3 bootloader, you cannot use Odin to install a stock AT&T ROM. You can try this: http://forum.xda-developers.com/showthread.php?t=2658486
audit13 said:
Once you have the 4.3 bootloader, you cannot use Odin to install a stock AT&T ROM. You can try this: http://forum.xda-developers.com/showthread.php?t=2658486
Click to expand...
Click to collapse
Thanks! I will take a look. Hopefully I can unlock my device at some point.
Was able to unlock based on the lead from post #2
hello, I bought this i747 in its current condition. I know nothing about its history.
when I power it on it goes to the phone, !, comp screen saying firmware upgrade encounter an issue, select recovery mode in kies.
in the top corner it says:
ODIN MODE
PRODUCT NAME: SGH-I747
CUSTOM BINARY DOWNLOAD: NO
CURRENT BINARY: SAMSUNG OFFICIAL
SYSTEM STATUS: CUSTOM
QUALCOMM SECUREBOOT: ENABLE
WARRANTY BITS: 0
BOOTLOADER RP SWREV: 2
Now when I connect to kies and run emergency firmware everything loads on kies, then gives an error, and
underneath BOOTLOADER RP SWREV: 2 it says: SW REV CHECK FAIL: Fused 2 > Binary 0 in red.
If this phone fixable? Any help would be appreciated.
mtsosie said:
hello, I bought this i747 in its current condition. I know nothing about its history.
when I power it on it goes to the phone, !, comp screen saying firmware upgrade encounter an issue, select recovery mode in kies.
in the top corner it says:
ODIN MODE
PRODUCT NAME: SGH-I747
CUSTOM BINARY DOWNLOAD: NO
CURRENT BINARY: SAMSUNG OFFICIAL
SYSTEM STATUS: CUSTOM
QUALCOMM SECUREBOOT: ENABLE
WARRANTY BITS: 0
BOOTLOADER RP SWREV: 2
Now when I connect to kies and run emergency firmware everything loads on kies, then gives an error, and
underneath BOOTLOADER RP SWREV: 2 it says: SW REV CHECK FAIL: Fused 2 > Binary 0 in red.
If this phone fixable? Any help would be appreciated.
Click to expand...
Click to collapse
Did you say it was recognized in Kies but firmware recovery failed? If so, and you were using Kies (not Kies 3), we may assume the last system update was not older than Android 4.1.1. I'll suggest you try these steps (in that order),i.e. if one doesn't work, try the next step ..
1. Try booting into recovery mode and doing a hard wipe/reset
2. Download the correct stock image from the thread below and flash via Odin. If you need help with flashing via Odin, please let me know
http://forum.xda-developers.com/showthread.php?t=1739426 or visit Sammobile.com to download the correct stock image.
3. Open Kies. Do not connect the phone yet. Go to Tools => Firmware Upgrade and Initialization. Enter your phone model name (SGH-I747)=>OK and serial number. Check device information inside the battery compartment. Wait for firmware download to complete and you are prompted to connect the phone and follow the rest of the on-screen instructions.
4. Contact the vendor to find out what they did wrong and see what refund options you have
Ok, so I also wasn't able to get into recovery.
I decided to flash cwm via odin. After it flashed the phone rebooted and turned on normally. I have turned it on and off like 5 times and everytime it boots normal.....But, there is still a problem... baseband version is Unknown and there is no IMEI Number.
Larry2999 said:
Did you say it was recognized in Kies but firmware recovery failed? If so, and you were using Kies (not Kies 3), we may assume the last system update was not older than Android 4.1.1. I'll suggest you try these steps (in that order),i.e. if one doesn't work, try the next step ..
1. Try booting into recovery mode and doing a hard wipe/reset
2. Download the correct stock image from the thread below and flash via Odin. If you need help with flashing via Odin, please let me know
http://forum.xda-developers.com/showthread.php?t=1739426 or visit Sammobile.com to download the correct stock image.
3. Open Kies. Do not connect the phone yet. Go to Tools => Firmware Upgrade and Initialization. Enter your phone model name (SGH-I747)=>OK and serial number. Check device information inside the battery compartment. Wait for firmware download to complete and you are prompted to connect the phone and follow the rest of the on-screen instructions.
4. Contact the vendor to find out what they did wrong and see what refund options you have
Click to expand...
Click to collapse
hi, yes those were the steps I tried and the result was fail. Now that I can boot it, it shows its 4.3 but no baseband and no imei.
mtsosie said:
hi, yes those were the steps I tried and the result was fail. Now that I can boot it, it shows its 4.3 but no baseband and no imei.
Click to expand...
Click to collapse
Oh, it's 4.3. Perhaps even better because you may be able to flash the 4.3 restore image. Your baseband/modem is corrupt or missing which is why it's showing the no baseband message.
Please see the thread below for the complete 4.3 stock restore image. Download the stock restore image and flash via custom recovery.
http://forum.xda-developers.com/showthread.php?t=2658486
Or you may just flash the 4.3 JB modem via custom recovery since you have custom recovery working. The modem zip can be found here ...
http://www.androidfilehost.com/?fid=23212708291681456
Larry2999 said:
Oh, it's 4.3. Perhaps even better because you may be able to flash the 4.3 restore image. Your baseband/modem is corrupt or missing which is why it's showing the no baseband message.
Please see the thread below for the complete 4.3 stock restore image. Download the stock restore image and flash via custom recovery.
http://forum.xda-developers.com/showthread.php?t=2658486
Or you may just flash the 4.3 JB modem via custom recovery since you have custom recovery working. The modem zip can be found here ...
http://www.androidfilehost.com/?fid=23212708291681456
Click to expand...
Click to collapse
:good: right on. you rock man. I flashed the modem and it works great now. thanks again.
mtsosie said:
:good: right on. you rock man. I flashed the modem and it works great now. thanks again.
Click to expand...
Click to collapse
You are most welcome. Glad to know it's now working.
hey guys am in trouble
Odin Refuse to flash
I747 warranty bit :1
bootloader rp swrev 2
SW rev check fail fused 2
Phone stuck on kies firmware upgrade encounterd
I Cant get 4.3 back again or downgrade to any older version
plz help me :'(
here is two screen shot in download mode while odin error
and in normal mode when i try 2 open
dark_darkness said:
hey guys am in trouble
Odin Refuse to flash
I747 warranty bit :1
bootloader rp swrev 2
SW rev check fail fused 2
Phone stuck on kies firmware upgrade encounterd
I Cant get 4.3 back again or downgrade to any older version
plz help me :'(
here is two screen shot in download mode while odin error
and in normal mode when i try 2 open
Click to expand...
Click to collapse
Can you try flashing custom recovery via Odin and then using custom recovery to do a stock restore to 4.3 following the instructions in the following thread ...
http://forum.xda-developers.com/showthread.php?t=2658486
can u share a link?
Larry2999 said:
Can you try flashing custom recovery via Odin and then using custom recovery to do a stock restore to 4.3 following the instructions in the following thread ...
http://forum.xda-developers.com/showthread.php?t=2658486
Click to expand...
Click to collapse
i've tried many custom roms
start flashing will and end with bug error at the end coz of warranty
can u share me a link for firmware tested ?
dark_darkness said:
i've tried many custom roms
start flashing will and end with bug error at the end coz of warranty
can u share me a link for firmware tested ?
Click to expand...
Click to collapse
I suggested custom recovery and not custom ROM. The idea is to get your phone back in working order first. Flashing a complete stock restore image should do it. Please refer to the thread I forwarded earlier. You should be able to flash custom recovery (like CWM or TWRP) to your phone via Odin and then use the custom recovery to flash the stock restore image.
This is what happened:
First I had Android 4.3 with KNOX
Then I flashed CyanogenMOD 11
I hated CyanogenMOD and tried to go back to stock firmware.
I downloaded the stock firmware from samfirmware.com and flashed with ODIN 3.09
Now i'm stuck on the Samsung Logo Boot Screen.
I have tried:
Reflashing
Using KIES emergency firmware recovery
Boot using safe mode.
Can you guys please help!?
Any error message in Odin? What is your current bootloader and which exact firmware are you trying to flash?
Androidwizzard said:
Any error message in Odin? What is your current bootloader and which exact firmware are you trying to flash?
Click to expand...
Click to collapse
CURRENT BINARY: Custom
SYSTEM STATUS: Official
KNOX WARRANTY VOID: 1
AP SWREV: A2
Trying to get stock Samsung firmware N7100UBUEMK4_N7100ZTOEMK3_ZTO
Odin does not shows error message...
RAFAMP said:
CURRENT BINARY: Custom
SYSTEM STATUS: Official
KNOX WARRANTY VOID: 1
AP SWREV: A2
Trying to get stock Samsung firmware N7100UBUEMK4_N7100ZTOEMK3_ZTO
Odin does not shows error message...
Click to expand...
Click to collapse
As your Knox counter says 1 I suppose you are trying to flash an older knox-enabled bootloader over a newer one.
Easiest way to succeed is to flash 4.4.2 firmware instead.
hi guys..
i have n7100 and it was customed on 4.1.2 rom.. i want to upgrade it to kitkat 4.4.2 so i download the firmware from sammobile and tried to flash it through odin but something went wrong and it keep restarting and on odin screen i get new lines
KNOX WARRANTY VOID : 1
AP SWAEV : A2
plz tell me what to do
firasel7elo said:
hi guys..
i have n7100 and it was customed on 4.1.2 rom.. i want to upgrade it to kitkat 4.4.2 so i download the firmware from sammobile and tried to flash it through odin but something went wrong and it keep restarting and on odin screen i get new lines
KNOX WARRANTY VOID : 1
AP SWAEV : A2
plz tell me what to do
Click to expand...
Click to collapse
It would nice if you tell what region your phone and ROM belong to. Also, provide info of the firmware you flashed.
Of course, your warranty is void. By using Odin to flash ROM you tripped the Knox. You should have research before doing anything.
Now about restart issue. Did your Odin flashed the ROM successfully?
If yes, then you should reboot to recovery. There wipe data/ factory reset & wipe cache partition. Restart the phone and you should be fine.
Report back for more.
Sent from my GT-N7100 using Tapatalk
Hi,
I got a Note II N7100 with DN3. Then I decided to upgrade to DN4 and install MJ5 bootloader. when mj5 bootloader fail on installation using Odin v3.09 my note II start to stuck on "Firmware upgrade encountered an issue. Please kindle select recovery mode in Kies & try again.". I have tried kies but it does nothing. I can still go on odin mode on my phone and this are the information:
Product name:GT-N7100
Current Binary: Samsung Official
System Status: Custom
Know Warrant Void: 0
RP SWREV: A2
How can i make my note back? please help
ezthony said:
How can i make my note back?
Click to expand...
Click to collapse
Download and flash latest stock rom from sammobile using Odin.
thanks
Can u give me a detailed guide on how to do that? Im so noob at this stuff right now and im afraid to fail. Thanks u so much
ezthony
I think you will find you have experienced an eMMC chip failure. I have the same problem and could not get any kind of flashing to work.
Sorry about that.