Just wondering if anyone else has installed the Casemate Screen protector for the i747 S3? I've been having trouble with first one I installed -- the edges of the screen protector don't seem to want to stick down, so around the entire edge of the screen the protector isn't sealed. I have a feeling dust will slowly creep in and eventually peel off the screen protector. Is this just me or as anyone else had this problem?
Anyone got any recommendations for a better screen protector?
Related
I bought the Body Glove Dimensions Case from an AT&T store along with the Visor AG screen protector (the only protector they had) But with the case on the screen protector keeps lifting up.. Anyone had any luck with this case (Which i really like) and a different screen protector? I'm leaning towards the Rearth protector cause it looks like it is cut a little smaller and might work...
are you sure it's the case causing the screen protector to lift off? I've seen a few reports that some screen protectors are lifting off the glass because it is curved at the edges.
Just got the Body Glove case today. I've had the Rearth screen protector on since I've had the phone. The case clears the screen protector all around by a few millimeters. No issues with pealing.
I have applied my rearth screen protector with no bubbles/dust underneath.
I love the clairity and feel of it.
However, after about a week or so of using this screen protector, i am noticing that small lint/hair/dust is collecting underneath the screen protector some how.
At first i thought that i missed this when i was applying my screen protector, however, about another week after i noticed even more dust/hair/etc...
Has anyone else experienced this or am i losing my mind?
It seems like it is creeping in through the edges or something... If i push my nail down on the edge it seems like it would allow something to go in.
Hey guys,
so in the past I've found that when i use a case, especially the snap on ones, they start pinching away at my screen protector and the screen protector eventually gets **** inside and i need to remove it.
This happened on my Sgs2.
I have a screen protector for the s3 and i really want a case but i don't wanna get one that ruins screen protector or pinches against it.
Any case you guys would recommend for phone with screen protector?
Thanks!
Just wondering if anyone has removed the built in screen protector? I bought it today and it looks like the usual junk they use. I am supposed to get my phone tomorrow so how does it work with it?
I always remove the BI Screen Protector...hate it !! I just use a tempered glass instead but love the protection from the case itself
Not sure why #otterbox is only restraining to releasing a Defender series case for this phone. Would love to go for a commuter series.
Sent from my LG-H990 using Tapatalk
I am using a defender, popped out the screen protector cleaned up the residual glue that held it on and applied a tempered screen protector to the phone.
I do have issues with the edges peeling up the screen protector, so I filed the sharp lip of the case back a tiny bit so when it flexes it goes over the screen protector instead of lifting it up.
All is good, phone is massive and I don't think I will by physically breaking this phone anytime soon with it.
Hi, I know the watch has a sapphire crystal screen but I still want a screen protector. The one I have bought is tampered glass one but it still leaves a gap around the edge. Have any of you got a tampered glass screen protector that is pretty much a perfect fit. If so can you leave a link to where you got it please.
yeah i'm thinking about going this route as well... anyone have any recommendations?