have been running Vicious 4.1.1 for a few days now. When trying to listen to music, specifically dar.fm app, the volume is cut in half after answering and finishing a call. Volume adjustment doesn't do much. The only way to restore full volume is to reboot the phone.
Anyone see this type of volume issue?
quick update, after ending the call, if I go into the volume control area under settings and move the slider around then back, the volume will restore to full.
Sounds like a bug.
Related
Hello,
Does anyone know how I stop the volume buttons from adjusting my ringer volume? It's very annoying to sometimes accidentally press them without realizing it, and then have the phone explode at maximum volume when a call comes in.
Thanks!
I can do this, but without testing it im not sure what it will do. Meaning, it may disable the button completely in the rom. (will still work in recovery though). But its worth a try.
It seems that when you are in a call, the volume is FULL VOLUME, and you cannot turn it down without turning the volume UP and then DOWN. Anyone else seeing this?
tested mine(grey) on inbound/outbound calls....volume worked as it should
It seems to be the first time if you restart the phone. The phone earpiece is full volume, then you press volume UP and it goes quiet. It seems to be OK after that. So a minor issue apparently.
I play music off my phone in the car. After I answer a call, the music resumes at a much lower volume, despite the fact that I haven't touched the volume on the phone or car. I have to press volume up 3 times and it doesn't go gradually up, but instantly from the low volume to the high it was at. Is there a setting to get the music volume to maintain? Using poweramp. Thanks
Anyone have a similar issue? I remember having it on the GNex as well but fixed it somehow. Cannot remember how, though. Any help would be appreciated. Thanks
I continue to experience this same problem on stock 4.1.2 ROM. I suspect it is a bug in the ROM. I don't know how to duplicate the problem because I have gotten calls and the volume was correctly restored. I've also tried making calls and the volume was correctly restored.
check all your sound setting and make sure that the volume is up on the system part of the sound menu...i had the same problem ...that seemed to fix it for me...
Sent from my SAMSUNG-SGH-I317 using xda app-developers app
My volume buttons will only adjust the call volume, even when I'm not in a call.
Yesterday I was listening to music and tried to adjust the volume from the lockscreen, but when I did the phone adjusted the phone volume instead. So I went into my music player app and tried there, same result. I pressed the volume again, and this time expanded the volume panel, and was able to adjust the volume from there. I then started playing around with the volume to see what it would do. I toggled vibrate/mute and the volume panel showed no change in the phone volume. It was after this that I noticed that the label on the volume panel next to what was normally the ringtone volume read "call volume" instead. I figured it was a weird one-time glitch, so I rebooted. No change. Pulled the battery, success! But a few minutes later I had the issue again. Hard reset again, same result. So it seems my phone thinks it is always in call.
I can only adjust music volume from the panel and only adjust ringer volume from the sound settings.
Any ideas as to why it is doing this?
Problem solved!
Apparently having www.weavesilk.com open in my chrome browser was causing the problem. I closed the weavesilk tab and my volume works just fine now. Weird.
Hello,
I have noticed that for some time now whenever I try to adjust the volume of a call (during that call, using the volume buttons) the Bluetooth volume is adjusted instead of the in call volume, leaving me to either not hear well enough or too hearing too loud.
I have tried rebooting and noticed that for a few seconds after each reboot (about 15) whenever I place a call I can adjust the in call volume just fine. There is a definite point in time, though, when the in call volume in replaced with adjusting the Bluetooth volume during the same call after boot.
Notice that I do not have Bluetooth enabled and have never used a Bluetooth headset.
How can I debug this? This looks like some service starting and messing things up. How do I find which service is that?
Thanks.