So i'm sitting here at work with a new Battery Monitor Widget. I downloaded it because my EVO has had the tendency lately to discharge even while plugged into a wall outlet. I generally use it for streaming radio and originally used USB to keep it plugged in at my desk, but then decided that may be why it's not charging. It doesn't always do it, sometimes it charges correctly. Right now, for instance, it shows Charging (green) AC Plugged (green) and Current 46ma(Red). It's been plugged in since 7 am and there's only 7% battery left. I'm not streaming, 4g is off, wifi is off, I used task mgr to close all open apps and it's still in the red. Any ideas? I'm rooted with the Elite I rom. Thx!
Does it charge if you actually turn the phone off and leave it plugged into the wall? If not, then it might be either the battery or the USB port. Another thing to consider is the USB cable, are you using the same one to plug into the wall as the one you used when you were charging via PC? If so, try a different cable.
Just in case it is the USB Port, you could try cleaning it out with some 70% or 90% isopropyl and some sort of tiny rag or something (creativity may be required.) Obviously you'd want to make sure the phone is turned off at the time.
Related
so the option to not charge it is not ticked under power settings, and its set to charge via usb from advanced config and still no dice.
tried different usb ports and nothing
the led is orange, says its charging in power options
any thoughts?
Try a diffrent usb cable, some cables do not provide enough power to charge the phone. (guessing maybe they are old 1.1 cabels). But I know I have a few cables around that dont charge my phone and they also will not work with my portable external usb hard drive because they wont provide enough power for it. But they work just fine with my digital camera.
I´ve read somewhere that disabling USB charging is better for the battery life, so I have it disabled.
You've tried different USB ports, but were they on the different computers?
so i've tried different cables, different ports and 2 different PC's and 2 different laptops.
I know its not the cable i'm currently using because i plugged it into one of those A/C to USB adapters and charged fine.
I'm starting to think its my batter,
If you have tbattery installed, do u get values for all the boxes?
All mine except 3 or 4 are 0 :/
Well, you are not the only one having this problem. Mine is brand new. I started setting it up last night and had it hooked to the computer via usb. I installed a few .cabs such as google maps, myphone, and a few tweaks such as tether, disable sent notification, enable all camera modes, and manila start menu unlocker. While it was connected it said it was charging. When I went to bed I turned it off and connected it to another usb cable on another computer which is an a/c hub. I went to turn it on this morning and thought it was strange it was not fully charged. I continued to set it up a bit and take it for a spin. After a while I turned it off again and hooked it to the usb a/c charger again. I just tried turning it on and nothing was happening. I connected it to the usb again and it finally turned on, but I checked the battery level and it was at 0% and turned off. I have it connected to the a/c charger and giving it a little bit to see what will happen. One thing that seems strange is that the battery discharged more while it was off and attached to the usb a/c hub during the afternoon causing it to refuse to turn on at all. Any thoughts?
fone_fanatic said:
so i've tried different cables, different ports and 2 different PC's and 2 different laptops.
I know its not the cable i'm currently using because i plugged it into one of those A/C to USB adapters and charged fine.
I'm starting to think its my batter,
If you have tbattery installed, do u get values for all the boxes?
All mine except 3 or 4 are 0 :/
Click to expand...
Click to collapse
I think the odds are pretty good it's your battery. The orange light means power is going through the charging circuit, so you obviously have your settings correct.
I'm guessing you're in Austin or near? If you want to try popping my battery in it for a few minutes and see if it charges fine then, PM me and we can set something up.
the same thing is happening with mine. Sometimes it will charge, sometimes it wont. weird thing is that it only started doing this a few days ago... i know nothing has changed ROM wise, so only things i can think now is maybe the actual USB connector on the phone or the battery, but since I am getting a charge via wall chargers im not sure what to think lol
Just an update.
If i have the USB cable plugged in (and car charger to which doesn't charge as well ) after 15 min or so a warning appears saying that the current is too low to charge the device. Either closed unused apps or switch to a/c power.
I've ordered a 1800mah Mugen Power Battery. Gonna see if it resolves the issue, if it does then i'm gonna call at&t and see if they'll swap my battery for me.
I have found as have others here after reading some posts that if the phone is almost dead or battery is very low then it will not charge via the USB anymore. The orange light goes on and it says that its charging but the charging circuit seems to be protecting the phone and not letting the battery charge.
The only solution I have found, and it has only happened twice so far is to plug it into a wall charger and fully charge the battery. It will then charge via USB again and all is good. I normally only charge my phone with usb while connected to Activesync but once in a while you seem to need to top it up with a wall charger.
It is also highly recomended not to run Lithium Ion batteries right out.
How do you know it is not charging?
There is a difference in the wiring from a wall charger and a USB charger. There is a signal line in the wall charger telling it to charge at near 1000ma. In the USB cable that line tells it to limit the charge current to 500ma. That is the limit for current that you should pull from a USB port. If you are using the unit heavily, you may actually need more then the 500ma., those running the battery down possibly.
If the unit is idle, it will still take much longer to charger from USB then off of a wall charger.
worwig said:
How do you know it is not charging?
There is a difference in the wiring from a wall charger and a USB charger. There is a signal line in the wall charger telling it to charge at near 1000ma. In the USB cable that line tells it to limit the charge current to 500ma. That is the limit for current that you should pull from a USB port. If you are using the unit heavily, you may actually need more then the 500ma., those running the battery down possibly.
If the unit is idle, it will still take much longer to charger from USB then off of a wall charger.
Click to expand...
Click to collapse
If you are asking me, I know it was not charging because I also had the "not enough power to charge message" and the phone went from about 15% when I plugged it in to stone cold dead by the morning. The whole time it was pluged into a computer I have used repeatedly to charge it with. I then put it on a AC charger and it went to full charger in about an hour and a half or so.
Just been on a long run and used the satnav ( google ), and the whole time it was plugged into the cigarette lighter charger.
Despite this, the battery level was running down
Is this normal - that the battery drain using the satnav/gps is greater than the charging rate?
I used mine yesterday for about a 1/2 hr journey, was not plugged in, but batterey was down to about 30%, also seemd to use about 20mb for 15 miles, so watch your usage.
J-Zeus said:
Just been on a long run and used the satnav ( google ), and the whole time it was plugged into the cigarette lighter charger.
Despite this, the battery level was running down
Is this normal - that the battery drain using the satnav/gps is greater than the charging rate?
Click to expand...
Click to collapse
Its been discussed already, your charger is not powerful enough to charge it when using satnav, so the end result is that your charger is just slowing down the discharge. Happens when you are using 3rd party accessories.
Ah - That makes sense -- where can I get a decent one - at a decent price
I'm using the factory supplied lead and still get the same, also used to be a problem with my Touch Diamond 2 WinMo Phone, was hoping Desire would be better and it is... just... If I make sure it is fully charged before I set off I can do about 3 hours with it plugged in before it goes flat, I just keep switching it off while I know where I'm going and only switching it on when I don't! That way you can make it last until it is needed.
Another thing to check is that it is kept cool enough to charge, again, in common with my older HTC winmo phone, the Desire gets very hot while being used for GPS and this can be worse if it is in sunlight on your windscreen, sometimes this can stop it charging at all, (you can tell its in this state because the indicator light blinks alternately orange and green) I angle a vent so its blowing cold air on the phone and that seems to do the trick.
Weird thing with the Desire is that for me it shows the green charge light and battery full indicator right up till it is nearly dead... rather than showing that it is draining
I've also noticed with the Desire that even If I'm just browsing the web it drains quicker than it can charge, even using mains charger, I often get a message "the current is insufficient, please connect to AC" or something like that (when it is already plugged in)
I don't think the in car charger you use would make a big difference, the current/voltage for your cigarette lighter socket is limited by the vehicle electrics (I know mine is fused at 15 amps)
Pauly
You need a charger which supplies 1A. Most 12v cigarette lighter chargers only supply 500mA
I use this one, and plug the USB cable into the "quick charge 1A" socket
http://www.argos.co.uk/static/Product/partNumber/5140927/Trail/searchtext>BELKIN+CHARGER.htm
Are you using Bruts worldwide maps mod? I just installed it. I ran it for literally only 5 minutes, but my phone got really hot and the battery monitor shows the app used 10% of the charge (the phone has been unplugged for 24 hours). I have a strong suspicion that this app is faulty.
-------------------------------------
Sent via the XDA Tapatalk App
This has been discussed and solved here http://forum.xda-developers.com/showthread.php?t=670702
Basically most usb car chargers (even 1a rated ones) are recognised by your phone as a data connection and to protet delicate computer usb circuits will only draw 500mAh where your phone requires 950mAh.
An easy mod of either the charger or a data cable will solve the problem. Your charger MUST be able to supply up to 1a.
zzleezz said:
This has been discussed and solved here http://forum.xda-developers.com/showthread.php?t=670702
Basically most usb car chargers (even 1a rated ones) are recognised by your phone as a data connection and to protet delicate computer usb circuits will only draw 500mAh where your phone requires 950mAh.
An easy mod of either the charger or a data cable will solve the problem. Your charger MUST be able to supply up to 1a.
Click to expand...
Click to collapse
Thats why I use the Belkin one, it detects it as a charger only and charges at full rate when plugged into the 1A socket.
Ive had problems with charging since i bought it but i rooted so i cant take it in to sprint
sometimes it goes away though
i left it on for like an hour and it got to 16%
but now it was using the battery while it was charging because i turned the camera on just for one picture it was at 5%
is it suppose to be like this or should i unroot and try to take it into sprint
Are you using the stock charger?
Try plugging the USB wire directly into a PC/Laptop and see how it charges from there. If it charges normally, i'd say it's the main charger piece connected to the outlet. (The module between the cable and the outlet)
I've also gotten this issue 3rd party charges. The Evo is very picky on how it likes to charge =P
Anyone else notice that our Nitro is rather fickle about the power source it receives?
If my battery is completely drained, it MUST be plugged into a higher power source than USB (so far a wall charger that ouputs 750ma works) until it gets an initial charge (usually needs at least a couple of %)...Then it will accept charging from USB (USB provides 500ma).
I can tell when it's in this "state" because it remains dead if I plug it into USB and then if I plug it into a wall charger the touch buttons at the bottom flash for a few times and then the LG logo pops up and finally a charging battery icon comes on. Considering this sequence, this seems like a functionality of the phone. I wonder if this is common, my Nexus One certainly didn't have a higher-initial charge rate requirement when the battery was dead.
I've experienceed the same scenario.
Sent from my LG-P930 using XDA
I only have chargers that operate 1.8amps and higher.
As the battery is an issue the higher the amps the faster it will charge
sent from LG OPTIMUS LTE using Tapatalk
Well I did notice that if it was on usb...and I had bluetooth...gps, and wifi...plus running some apps and stuff...the battery actually continued to drain I think they have the usb thing as a safety measure...for some reason...I think it's odd...but meh
try a usb cable that has 2 jacks plugs to connect to tyhe computer. These cables are often supplied with external hard drives as they they require more power than can be supplied by just one usb connection.
I was also having the problem of my p-930 discharging while plugged into compute usb jack - even when screen off nad only in charge mode. I have since bought a dual plugged usb cable and it charges now. Although I haven't tried it from a completely discharged state.
my spectrum is the same way.. i can charge it with usb.. but it takes about 15-20 minutes to get enough charge to turn on
Epyoch said:
Well I did notice that if it was on usb...and I had bluetooth...gps, and wifi...plus running some apps and stuff...the battery actually continued to drain I think they have the usb thing as a safety measure...for some reason...I think it's odd...but meh
Click to expand...
Click to collapse
This! I only charge with a wall adapter now. I had a hard time charging it until someone here recommended this to me.
Recently I've noticed that my Gnex battery will LOOSE charge when plugged into any power source that isn't the Samsung charger. Weird right? If i plug it into my laptop, car charger, an LG wall charger the battery will drain. It has happened multiple times where i've hit 15% battery life and plugged it into my laptop or car charger and it will loose a 1% about every 2-3 minutes.
I've switched roms with no luck. What is going on?
Its not uncommon for this to happen from a laptop port - especially if the phone is being used while plugged in. The USB output on laptops is likely not very high.
Check the amperage of the alternative chargers you are using. If its too low, they won't be able to keep up. Make sure its the same as what the stock Samsung one puts out. Can't recall its exact specs off the top of my head...
Laptop and car charger are 500mah or less. Your phone is using battery faster that it's recharging. Nothing odd about that.
charger
I'm charging on my laptop with a cable of blackberry and no loss there. Charging with at the wall I'm using only samsung utilities so I can't help you out there..
Despite that I don't understand what that has anything to do with rom's?