When i get or make a phonecall my speaker turn automatically on.
Even on the lowest volume it's still loud.
I also have to turn off the volume myself.
Is there any solution to this.
Related
Hi,
I just wondered if you can set volume for the integrated hands free function of the artemis. When you turn on this function, volume is too high. You can't change the volume. Any ideas?
Do you mean the hands-free that comes in the box? It has a small side slider for volume adjustment.
I mean the integrated hands free function. It's activated by pressing and holding the green phone button.
That's the speakerphone. Actually u can lower the volume a bit with the volume adjustment but even at its lower setting its rather loud.
On the other hand I usualy activate the speakerphone in the car where there is a lot of noise so its not a problem.
Maybe someone else knows how to lower it still, yet u wouldnt want a speakerphone u can't hear unless u put it beside your ear.
Yes, the speakerphone, sorry .
It's very loud. Perhaps someone knows the registry settings ?!
I have the same problem. Even on when the volume slider is all the way down, the speakers start to make a cracking noise and is too loud.
Hi,
yesterday I restarted my HTC Desire GSM running CM7 and during the first call I noticed that the voice of my interlocutor was caming from behind the phone (rear speaker). I tried turning the Speaker on/off several times during the call and rebooting as well but still the call speaks out from behind.
Any clue/suggestion for me? That's pretty uncomfortable
Sounds weird, do you mean it goes into speaker mode? If you do maybe there is a problem with your accelerometer. In the Sound settings is 'Flip for speaker' on, if so try turning it off. This setting may be causing your phone to enter speaker phone even though your phone isn't flipped.
I'm not an expert but maybe this is causing the problem.
It's not exactly the "speaker" because the volume is very low, exactly like a normal call but instead it comes from the rear speaker. Moreover I can turn the speaker on, which makes the volume louder but still from behind the phone (as it should be).
However I checked the call settings and the proximity is disabled. I tried enabling/disabling a couple of times but no luck at all
Any other suggestion please? Still can't hear from the right side of my phone and rear speaker definitely s**ks
It seems that when you are in a call, the volume is FULL VOLUME, and you cannot turn it down without turning the volume UP and then DOWN. Anyone else seeing this?
tested mine(grey) on inbound/outbound calls....volume worked as it should
It seems to be the first time if you restart the phone. The phone earpiece is full volume, then you press volume UP and it goes quiet. It seems to be OK after that. So a minor issue apparently.
So everything about the watch is beautiful except for one annoying fact. Whenever I place a call or receive a call, the sound of the other person is so low, that I can hardly hear them. I have the volume on my phone on high for phone calls and music plays loud on my watch, so what is the deal?
Has anyone else experienced this?? Should I go immediately to the store and get a replacement ASAP? or is this a bug that is common with the update or fixable?
Help a girl out, please!:fingers-crossed:
Have you tried adjusting the volume during a phone call on your phone? I think you have to have an active call to be able to adjust the bluetooth volume.
Hello,
I have noticed that for some time now whenever I try to adjust the volume of a call (during that call, using the volume buttons) the Bluetooth volume is adjusted instead of the in call volume, leaving me to either not hear well enough or too hearing too loud.
I have tried rebooting and noticed that for a few seconds after each reboot (about 15) whenever I place a call I can adjust the in call volume just fine. There is a definite point in time, though, when the in call volume in replaced with adjusting the Bluetooth volume during the same call after boot.
Notice that I do not have Bluetooth enabled and have never used a Bluetooth headset.
How can I debug this? This looks like some service starting and messing things up. How do I find which service is that?
Thanks.