Develop Bugs

PV HERMES Rom Expired????????

Hello.
I have installed a PV Hermes WM 6.1 Rom.
It now says : thank you for using this software...etc
I think it was for betatesters, and now it shows only a splash screen, and i CANNOT install another ROM.
I tried to install by starting in BOOTLOADER, but it does not help.
What can i do???

emipop said:
Hello.
I have installed a PV Hermes WM 6.1 Rom.
It now says : thank you for using this software...etc
I think it was for betatesters, and now it shows only a splash screen, and i CANNOT install anothor ROM.
I tried to install by starting in BOOTLOADER, but it does not help.
What can i do???
Click to expand...
Click to collapse
I think I read somewhere (but have not tried), do a hard reset, and when the screen that says Tap to begin using your device pops up, start attempting to flash from there.
But they "should" flash from the bootloader screen.

I had exactly the same problem. Tried all the tricks to go back to the previous ROM. I also tried boog321's hard reset idea, but it just puts you back into the bootloader. HOWEVER, when I then went through the screen alignment process (just for fun), lo! it works!

The problem is that i can`t get inside windows anymore. It stays at the screen 3 seconds after power up. Is there a way to hardware reset?

emipop said:
The problem is that i can`t get inside windows anymore. It stays at the screen 3 seconds after power up. Is there a way to hardware reset?
Click to expand...
Click to collapse
Just flash a different rom dude!! probably a expired beta rom.

i have tried to falsh 4 differnt ROM`s. It makes 2% and says rom orrupter or something.

Tried installing via MicroSD card? I installed the same ROM a while back...

Hey. I just re-flashed right now after I installed an expired beta by mistake.
Start with the Hermes connected USB, showing the splash out of luck screen.
1. Hold both Power and the ok button on the left and then RESET with the stylus. It should go in tri-color mode
2. Flash a known good ROM
Good luck!

Bro just flash your ppc using other ROM (flash it in bootloader mode) when its in the hermes rom upgrade tap the (force using safe SSPL) it will do the trick.

I already said i did that.
After 1% it stopped and says : ERROR 270. UPDATE ERRROR: The image file is corrupted please check your update utility.
I have done this with 5 roms now.
Will try microsd install.

Hope you have Hard SPL, you need it for sd card flash...

I solved the problem with the bad ROM.
I downloaded an official rom from here:
http://wiki.xda-developers.com/index.php?pagename=Hermes_Upgrades
I has done a clean install.
But i still can§t install another rom, from the forum.
Will try again.

emipop said:
I solved the problem with the bad ROM.
I downloaded an official rom from here:
http://wiki.xda-developers.com/index.php?pagename=Hermes_Upgrades
I has done a clean install.
But i still can§t install another rom, from the forum.
Will try again.
Click to expand...
Click to collapse
Are you sure you have HardSPL installed and CID unlocked your device?

Wiered screen

Does someone know what this mean? Every time i boot my device i`ve got this screen. If i push power button all my data will be lost, but if i push the round circle or do nothing devise boots normally.
I had this earlier and i did mtty and i assumed that this problem was gone, but no. I have my own rom (23053) and after flash ewerything was fine. This thing come up later when i had to do soft reset.

Nobody?? What is this?

something went worng in the flashing process of your own rom.
there are 2 ways of fixing this.... MTTY or flashing an original rom, an then reflash your own rom.
I recommend you the second one heheh
From MRM2007's signature you can find an original rom
http://ifile.it/_hq1nlzf/Diamond_ROM-Radio-SPL
Also the most safe way to do this is from your internal storage, puting diamimg file in your internal storage, go into bootloader ( press <-- + VolDown while softresetting) and follow instructions.
Flash that one, hard reset, flash your rom, hard reset and test it again...
Credit goes to mrm2007 that help me with this also.
Mariano.

I did earlier MTTY and i tought that everythin vas fine. But no. Earlier when i had some boot broblem, my device just did hard reset, no that kind of screen.
That`s not a broblem for me. I`m just courious what that might be.
By the way. I allways flash roms in internal storage.

In need of depsperate help!!!

Try to flash to JH2 (and repartition 512) - the stock B model firmware.
If it fails - try to push one of complete roms (doc_kalpik) and install it using clockwork.
Otherwise have no idea what is wrong.

.....
I will download the firmware files now,
any instructions on how to use clockwork? and install the complete rom?

Did you perform a repartition when you reflashed ?

ignore me wrong thread!

inshadesofgrey said:
I will download the firmware files now,
any instructions on how to use clockwork? and install the complete rom?
Click to expand...
Click to collapse
isnt there a install guide in doc-kaplik topic? In clockwork (might need to push update.zip and rom manually - dont remember how) choose install zip from sdcard and navigate to file you need.

i did......still didnt work

Sounds like what mine was doing when the internal SD died.

dupel said:
isnt there a install guide in doc-kaplik topic? In clockwork (might need to push update.zip and rom manually - dont remember how) choose install zip from sdcard and navigate to file you need.
Click to expand...
Click to collapse
will this work even if i didnt have clockwork on my phone?

I flashed the stock JH2 with 512.pit and reparition checked, but the phone goes to the samsung logo, and flash animation and to a blank screen with only the buttons lit up........ah, am losing all hopes really fast.

Now that you are on jh2 take out sim leave external sd inside charge it til full, turn on while and it will boot, saying no memory going internal or external.
So far that would be doa, unless someone found a way to fix or reformat external card but most people that sent it for repair with these symptoms had done doa exchange like me twice or samsung replaced external module meaning it was hardware issue. Sorry.
Sent from my i9000M

it's a long shot, but can I buy an external SD card and run android from there?

I am guessing the only hope is to buy a new phone then?

inshadesofgrey said:
Hi guys, I have been a silent observer of XDA for a while now and you guys have helped through the past 4-5 phones that I've had - but now, I am stuck, so I thought I'll ask for help.
I have a galaxy S (i90000-GT) - originally from Bell, Canada but unlocked. I was running the XJPH with lag-fix and two days ago, when the phone rebooted, it got stuck in a boot loop, samsung logo with black screen comes on, and it starts all over again. Now, I can get into download mode and I followed the process to install JM8, and the stock file (the US Vibrant stock file) and I tried this as well:howto-froyo-fw-i9000xxjpm-upgrade-via-odin-root-recovery-2e-lagfix/[
But to no avail. The boot loop is still there. With JM8, the phone boots up and the goes beyond the flash samsung logo (with the music) but loads to a black screen, with the lights on.
Am really frustrated as this is my only work phone (and I go back to work tomorrow). Without the phone, I am pretty much screwed. I dont care about the Data on the phone (have performed 3-4 data wipes during installing the above mentioned roms) . So anything you can advise, will help!
any ideas?
Click to expand...
Click to collapse
Have you wiped your data/factory reset & wiped your cache? Many phones get stuck at startup because of them.

[Q] Stuck in Bootloader

I've got a problem,
I've backed up my files and tryed to restore them with ''ROM manager''. (after i had cynogenmod 7 installed).
So my DHD did a reboot, since then my phone dint start up anymore, removed the battery and SD card and tryed several times a ''hard reset'' and finaly after a couple of times i could choose the ''restore'' option and managed to install ''4EXTRecovery v2.1.3 RC2'' so in that menu i can install *.zip files, but it doesnt matter what kind of program i install.... because every time the phone reboots im comming in the same problem over and over ! ...
When i restart my phone the battery indicator is flashing 5 times a green light and vibrates 5 times, and when i remove the battery and ''hard reset'' the battery indicator flashes 3 times orange :S ... but after a few times i get back into the menu's ...
(when the phone is stuck with a black screen there is a little red light on at the right side in the speaker ...
I realy need some help to create my phone back to factory defaults, or another firmware... because i cant do anything with it now..
Greetz, Nico

Download and/or install another rom. Your cwm may have made a bad backup. You may just want to start over with a fresh rom. Don't worry your phone is not bricked

I've downloaded 2 diffirent roms, maybe u got a idea what i should install ? maybe a quick link...

Make sure you have decent charge on your battery. I sounds like your phone doesn't have adequate charge

If nothing works, try reflashing the stock 1.32 firmware. I think you may need to re-root your phone with visionary+ afterwards tho

But do i need to wipe / format all things ? ''Wipe all partitions'' ??

I was stuck on bootloader before, going from CM7 to CoreDroid. What I did was finally get to recovery, mount as storage, used SuperWipe from Mike1986 and installed his Android Revolution ROM. Don't know if that'll help ya, but it worked for me.
Sent from my HTC Desire HD A9191 using XDA App

But then when i try to install the 1.32 version it says installation aborted , and with the SuperWipe from Mike1986 that is completed and when i install Android Revolution ROM it installs everything and then relaunches the phone and then it vibrates 3 times and freezes again :S

Are you trying to install the 1.32 PD98IMG via recovery?
The PD98IMG is a zip that has to be flashed in bootloader.
First, redownload the ROM you wish to use. You may have had a corrupt download.
Second, before you flash the ROM. Wipe everything manually.
System
Data
Cache
Dalvik Cache
Thirdly, Now flash the ROM then reboot.
Now if you still get the same results after doing all that, your problem maybe elsewhere.

i cant open bootloader, it wil reboot the phone again... so im back to basic again.... :S , But i found out if i connect it to the computer through usb ... and insert the batery without the telephone card and sd card it will flash orange/green a couple of times then it goes back to loading full orange... Is there a way to flash the ROM before i copy it to the SD card ?

I've made the misstake with reformatting my SD card... that EXP3 -> EXP4 thing.
So ive managed to install the HD rom ...
But now i still got the problem when i restart my phone into bootloader that it will get stuck... i cant startup HBOOT either.. I need to hold the ON button for 2 seconds and release it then it will startup in Normal mode...
So can anyone help me out to reinstall HBOOT ? or maybe a good link to it ?
Sry for the problems, and i still dont know what messed up my HBOOT, and why my phone needs to go on in this strange way.
Thx, Nico

[Q] nothing goes more

I hope somebody can help me.
My problem is:
I have the Vario V and wanted to flash.
Then after flah i get only a loop of the Bootscreen. Because I could not synchronise the mobile phone any more with the Pc, I have tried out another file with ending nbh.(i´ve copied it direct to microsd card).
Now it shows only the Bootloader with the original SPL and I cant flash other roms because they dont loading.
What can I do now?

did you hard spl first?
did you read the instructions on first time flashing for noobs?
take the battery out, put it back in
while pushing the reset button with your stylus, power on the phone, then reflash a stock rom, goo luck

Thanks for reply.
yes i have read it.
i have done whta you say and i get always the bootloader with a error.a