Anyone no where i can get a new usb port to resolder on my wizard.
Related
Hi. I have the following problem: the miniUSB jack, the pins are bent. I can charge the cellphone, but activesync does not work, windows recognizes the device as an unknown device. I do not know how I see the the pins are properly bent. Is there a trick? I hope you can help me. Pascal
Same Problem, USB Jack pins for charging bent
I got a used Prophet from a customer wich doesnt charge
or sync's to Active Sync.
I recognized the two bent Pins and the task is now:
does any one know where to get a new USB jack?
I will solder it in my selfe but i need the partnumber of these
usb jack or i have to finde an identical one. (maybe I disassamble
one of the dead Prophet's in my collection ;(...) but getting this SMD
usb jack off the Mainbord without any damage is a bit difficult,
so i prefere a new part for these repair.
Does someone know where to get a
partlist / Boardlayout with partnames on it.
You need this
just correct it with the stylus .......
Insert the stylus or a toothpick to the port and straighten the 5th pin
cheers!!!
Aju
Hello,
I was thinking about using my LG G3 with MHL and OTG but i just found out that this device is using SlimPort and not MHL and from what I have seen its have only 5 pins and therefore its cant be used with an OTG cable at the same time (while the MHL port that support this feature has 11 pins) BUT when i looked into the micro usb port on the device with some light on it i saw that its a little dipper in the sides than it is in the middle and that in that dipper parts there is more pins SO I looked on port replacement pics and I saw that its have 11 pins that connects to the phone`s motherboard
so please if anyone can explain me what is those extra pins for and if there is any other cable that i can use?
Thanks in advance.
Anyone?
So my USB Port is broken. I use this phone as my back up. Also just swap out batteries. However I was wondering how easy/hard would it be to replace the USB Port. Has any else looked into doing this?
Hi,
the socket and the connector are broken, well I damaged them,
How ca I fix it?
Can I soldering the cable direkt on the whole socket or only to the small pin in the center of the socket?
Waiting for yor help?
Just get a new ANT board for approx USD10.00
I had a usb port replacement from local repair shop , it can charge but my PC doesn't detect it . I want to root it again what can I do ?
Let's have a look at the port. Please post a clear, high-res picture eg....