Um, ripped out when removing a sim, i did have it working fine for a few days with the old contact held in place with a thin piece of paper but now ive lost the contact :| Can i get a new sim connector soldered on or is that the end of GSM for my IIs??
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
If you don't remove your simcard that often, a temporary bodge can be made with some tinned strands of wire, a soldering iron and a gluegun. For a more permanent repair, most independant phone repair shops will do it for about £40 although the actual cost of the sim holder is around £2. And no, I don't have any
You could possibly butcher a suitable old mobile phone for one?
Richard
Do you know where i could pick up the sim holder? Can i send it the unit to HTC for repair?
Jammin said:
Do you know where i could pick up the sim holder? Can i send it the unit to HTC for repair?
Click to expand...
Click to collapse
HTCEurope won't look at an XDAIIs. o2's XDA helpline may deem it B.E.R - I don't know of any 'official' repair agent that will do a solder repair, most will just say you need a new mainboard and charge you accordingly :evil:
To get the simholders you need to buy m.o.q of 100 or so. Have you checked ebay?
Richard
edit - sorry b.e.r = beyond economic repair, m.o.q = minimum order quantity.
Related
Coucou !
I'm desesparate as I need some spare parts I don't know where to find.
It is the two goldent nuts stucked in the bezel, as shown on the picture below, top-left corner and bottom-left corner.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I also need a speaker grid for my HTC Rhodium, as it is stuck in glue.
I don't know where to buy them, so if you know a site, I'll be glad to buy them these parts.
Thanks a lot.
I seriously doubt that you can buy these parts separately. You may have to either purchase a damaged device and salvage the parts you need or purchase the entire front bezel to get them. I have never seen them sold separately.
Coucou !
In fact, I HAVE to buy a new bezel, but the ones I saw were NOT sold with these parts, neither the golden nut (I hope it's the correct word!) nor the speaker grid.
But if you know where to buy a bezel with these, I'll be glad to buy these there!
By the way, thanks for your answer.
Why not try to get them from the website you got the image from? It seems the gold nuts are included in that picture. Otherwise, just purchase a defective device for cheap and swap the parts.
Coucou!
Ask for these to that russian website? I have to admit I didn't think about it...
Now, I did it and I'm waiting for their answer. I'll stay in contact.
Thanks for the advice
Hi, yesterday my HTC Desire HD fell out of my hand and the screen cracked, the problem is I can live with a crack, but my touchscreen doesn't work anymore, now my question is, what part is broken, the LCD Panel or my screen panel? Which part do I need to replace to make it work again?
Only the area within the red box works and the rest doesn't work.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
How can I solve this, which part do I need to replace?
You need the lcd panel. It's glued to the digitizer so your best bet is to buy the lcd digitizer assembly and replace both parts in one go. Search youtube for instructions. Good luck.
Sent from my Motorola Startac running Atari 2600 software!
I had the same problem with mine. Dog pulled it out of my hands and it cracked on the street.
Do you have ensurance? if so, Just contact HTC and they will send you a new one. Took me 3 weeks and got a brand new.
No, I don't have ensurance, and I don't think my 2 years Factory warranty covers this.
I looked at ebay, but I can't find which part I need to replace. Can someone help me finding the right part on ebay or an other website where I can order the part i need?
Thanks
I found this one, I'm not sure if it's the part pwraggcan ment, but if it is isn't there a cheaper one?
Click
Well, I just ordered it for €45,- I hope it will arrive soon so I can use my beloved phone again
Hi guys,
My Verizon G3 took a dive out the car window and needs help. I bought a replacement screen, and I believe it probably works, but I'm not getting any image. I then noticed that there is a small component on the board that is broken. I was hoping someone could help me identify the part number. It is a small black piece right above the battery and below the ambient light sensor. I found the G3 service manual, and it says the part is U7303, but I am unable to find that anywhere, so I hoped there might be a number on the component itself that I could look up. Thanks for any help you can give!
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
...
Hi,
i think you will not get this part anywhere to buy, because it is integrated on motherboard. I recommend you to get a new motherboard or to find a broken G3 with working motherboard.
This is my choice good luck.
Bobek1988 said:
Hi,
i think you will not get this part anywhere to buy, because it is integrated on motherboard. I recommend you to get a new motherboard or to find a broken G3 with working motherboard.
This is my choice good luck.
Click to expand...
Click to collapse
Yeah I think that's my option at this point.. I did find a snippet that refers to U7303 as a fixed positive LDO regulator, rp103k121d-tr part number, but there's not really anywhere I can buy that from without going in bulk lol.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Ohh, and I'm tired of the update available prompt (rooted with custom kernel)
Want to go back to stock, and flash 6.0. But had two drops that damaged the corners and moulding holding the screen. Screen itself is fine, but worry that it will separate in time.
Just filed claim with Square Trade (bought at Staples), and their recommendation was to send me a check. Not sure how much?
I did have epoxy on one corner, but it chipped away. Need a more solid repair.
Any good source for parts? And how hard of a self repair?
What about sending g back to ASUS for repair?
Thanks for comments....
Sent from my Nexus 5 using Tapatalk
http://www.etradesupply.com/asus-google-nexus-7-lcd-and-digitizer-assembly-with-frame-black.html
$44
From the videos, it looks like the broken bezels are part of the front housing. But it also looks virtually impossible to separate the screen/digitizer from that without damaging it. I think this full assembly would be much easier.
Now what would be cost to send to ASUS, or to just get my check and apply a few more dabs of epoxy?
Does it really matter?
Mines chipped at three corners. Granted only one is as big as yours, but its working fine.
Yeah...works fine. But could look better. Was thinking it could degrade over time and effect display.
Squaretrade said to send it to them for $239 refund. Just had to order an Asus charger for $10 to include with my return.
Hello!
My phone didn't survive an adventure with water... I sent it to LG Poland, and after one month they sent phone back and answered that warranty is void due to water damage. I think that they should repair phone because of IP68 certificate. I just want to ask you, have you ever had a similar problem and had you sent LG's phone to warranty repair? What did LG's service answer?
There's one more thing... They resent phone with damage on bottom left corner...
Below I attach photos how phone looked before repair, and how it looks after repair...
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Sent my old G4 for repair during waranty (week gps signal when I got it back the screen was like yours.. They tried to fix it but couldent so they payed all my money back i paid when I bougt it..
dont try to connect it to any source of electricity or try to turn it on, put it on a bag of rice for about a week and then connect it and try to turn it on
LG has very bad aftersales service . my G7 constantly stops charging even with little bit of moisture.