Hi all
I have recently had a problem with my XDA-ii locking up. Loosing visibility of the backpack memory card.
When I decided to reload from scratch and do the Rom upgrade I get the error message on the screen 'UPGRADE RADIO STUCK PLEASE WAIT'.
I wait and wait but it does nothing then I reboot. It then starts to load everything but wont run stable at all.....
Any ideas
Related
Hello
I tried upgrading ROM for O2 mini inthis process iam left with only a blank screen with ** USB , Ver 1.00
Please help me out with this problem
I even dont have the rom Backup on to My SD card.
Please Help ME **
have this problem, too can anybody help pleaseeeeeee!!!!!!!!!!!!
What kind of upgrade did you do, sd-flash or shipped-rom? You're now stuck in bootloader.
So try a reset first, maybe it boots. If not put it in bootloader again & do a shipped-rom upgrade (again). If this fails & you still got warrenty use it.
Regards, M
had problem on k-jam, first upgrade just stopped.
started again and all upgraded ok, just restarted the upgrade program.
Hi to everyone on the forum,
right here goes
Tried to do a ROM upgrade on my EXEC, but it crashed half way through!
Now got boot loader screen etc and try to run ROM upgrade again, it completes
but when i do the reset all I get is a screen full of different coloured bands!!
what am i doing wrong?
all help much appreciated
Hey iam new to this upgrading,CID unlocking etc.
I just bought my Cingular 8125 three weeks before.
I tried upgrading to WM 6.0 The update process completed successfully but after the reboot my mobile was back to factory default with wm 5.0.
without tring the lokiwiz to unlock, i used shelltools to flash the wm6.0.
it was successful, it asked me to do a hard reset.
Since then i am stuck up with the boot screen.
I can't get my Mobile back working.
i tried flashing with the Offical rom but of no use.
i have tried button rom, love rom. nothing works out.
without much knowledge i upgrade my spl & IPL to 3.08
now i am not able to downgrade that too.
tried flashing different roms but of no use, still it stucks up in the boot screen.
the only hope iam having is i am able to get into the boot loader.
I am not sure, where to post this thread, my appologize if i have posted in the wrong page.
below is the information i have on the screen
IPL 2.26
SPL 3.08
GSM 01.12.10
OS 1.5.4.2
Some one please help me out. i am very much worried, any help is very much appreciated.Thanks a bunch in advance !
dosai.
Have you tried flashing from the bootloader to an official rom?
thanks for reverting, i have tried that too, but of no use.
Sounds to me like you didn't run the Cert_SPCS and EnableRapi cab files before flashing with ShellTool. Being stuck at the splash screen is a dead giveaway.
I never did understand why someone would attempt to flash a ROM without doing ALL the steps. . .
i did ran Cert_SPCS and EnableRapi cab before running the shelltool. shell tool took around 10 mins to complete the update.after restart, my phone stucked up in the boot screen!. (i remember not unlocking the cid before proceeding with the shelltool) .
is there any way to get the mobile working i am too worried.
Solution
Hi, press and hold the CamShot Button and press the Power button, when you see a multi-color screen you can make a update again.
Hello all Im new here and have the same problem. I followed all the steps and followed all the instructions to fix this problem but nothing. I am stuck on the multi-color screen and i can't do nothing! HELPPPPPPPPPPPP!
Hi i am a newbee in this forum and i have trouble with my XDA star (nike), because it stucks in boot-mode and i can not get it alive....
Her is what i did:
- i installed the CleanBlack2ReloadedOffice in german on my XDA Star - it worked perfectly ...
- Today i wanted to upgrade the radio from Nike_Radio_1.58.16.27 to the better one Nike_Radio_1.58.21.23_25.65.30.04S_Modded.
Result: the flashing stopped with 99% an now i am stuck on this boot-screen and my phone is a brick :-( It says:
RUUNBH
NIKI300
SPL-1.16.0000
CPLD-4
I tried several things to get the phone alive - but nothing helped every trial failed with the grey screen and a 0% on it - some 5 Minutes later aborted with error.
I copied the sspl-1.16-nike.exe on the device and started the Update. It stuck on 99% - ended with an error.
But now i am not able to install hard spl or anything else? I allways get the 0%-Load-Screen on the device and after 10 Minutes an 262-Error.
I tried now to load every shipped original rom - but the Rainbow-Start-Screen does not go away. Is there any other chance to get this device again working? Did anyone made experiences with this strange behavior?
I really would be glad, if there is a "howto" get into a working communication process between my "Pc" and my phone? Is there hope to get this device running? Any helpfull advices? Thanks in advance
Hello Everyone,
This is my first thread on this forum, which i am making because I ran out of options, and don't know what to do....
My Samsung Galaxy S4 mini(GT-I9192) were shut down automatically when i am using it.After then I started my phone again
it starts normally but after the details Samsung Galaxy S4 mini(GT-I9192)comes and it again turn off and again restarts and
this process is going again and again.As I tell you my phone doesn't stuck on a boot as my phone restarts again before the samsung logo comes.
I've tried Emergency firmware upgrade and Initialization through kies but after entering model no. and S/N,
It says 'GT-I9192' does not support initialization. I've done that before with kies it never gives that error I don't know why now.
After That I tried to install stock firmware by Odin in download mode, The process gets completed pass message comes after that my phone reboots in recovery mode and a message print on the bottom "did not match size '/system/csc/common/system/csc/others.xml' (no data available)" i don't know what is that for and after that i reboot my phone and still same thing...
After all that I think maybe its an hardware issue but if it is an hardware issue then how my phone starts and again shutdown so i don't think it's an hardware issue btw i don't know what it is.
So Please If anyone Have any Solution please help me.
Thank You
I have same problem on my galaxy s4 mini gt-i9195 LTE.
first the phone doesnt wanna turn on at all, just show as QHSUSB_DLOAD
after xx hours googling for solution i try unbrick.img which bring the screen back in live:good:
then i try several roms but the phone reject the flash, so i try flash with original stock rom, that went successful
but that doesnt change something, still keep rebooting, even when load recovery it get reboot and keep rebooting.
I don't think that this might be a hardware issue, but something wrong with the android partitions.
I'll keep playing with it hope i find some solution.
If someone read this and has same or similar issue, please post what you have try so far, so we can work on it and find the problem.:highfive:
Thanks for your reply...
As my phone were start after flashing so many times and now it says Device Memory Corrupted Please reset your device to default
settings and there is a reset tab which doesn't working when i keep pressing that so now i think that maybe my eMMC chip was damaged well exactly i don't know that yet....
well for you just try connecting through kies and do a firmware upgrade and if that doesn't working than flash it through odin and also download PIT file for re-partition....