My phone's proximity sensor is not working. Long story short, I had a guy change the display and after that when I call the display always blacks anyway probably he put something in front of the sensor. Anyway, I can't go to a proper technician because they are in another city far from here. In the oxygen os, if I press the power button, the display comes during call but in custom rom like Pixel Experience, Skydragon, Havoc it doesn't. However, in skydragon rom, I found a option in dialer, Disable Proximity Sensor which is actually life saving for me. But I want to use the Pixel Experience rom. Is there any way to get the Dialer app from Skydragon rom ? Or, any way to disable the Proximity Sensor ? I tried the Xposed app; didnt work though.
Right Dialer and Simple Dialer have the option to disable use of the Proximity Sensor. I was using the Sensors Off QS tile (under Developer Options) option previously automated under Tasker but it was kinda hit/miss. Unfortunately these apps don't support call recording it seems.
Related
Hi,
as measured by Z-DeviceTest, the proximity sensor on my Desire is stuck at 0.000 cm in all lighting conditions (including a very bright torch right on top of it).
At first I suspected this was the known problem with dust settling on the sensor, but I've blown and sucked (teh-eh) with everything I have, from every angle, and the sensor is still stuck at that value.
The problem shows up both in CM7 and with the stock firmware.
I have to assume the sensor is broken.
I'm looking for ways to disable the proximity sensor, and in particular to stop it from locking the screen during calls. Naturally, since the sensor is stuck at 0.0000 cm, any time a call is initiated the screen locks up, preventing me from ending the call, dialing tones and so on.
Alternatively, I'd be happy with a way to override the screen lock via hardware buttons. The power\unlock button doesn't work
Inserting a headset during a call does unlock the screen, but naturally this is not a satisfying solution (for example, I can't use this method to make calls while driving, using the speaker).
Solutions tried with no positive effect:
- editing build.prop with "ro.proximity.delay=0"
- using trackball\volume button wake
- using screebl, screen off to control automatic screen locks
Thank you for your time.
Anyone have any pointers?
Is it really hopeless?
Are you root? If so have you considered flashing a rom with the option to disable the proximity sensor? (for example miui-au has that option)
Yes, I have a rooted device. I didn't know miui had that options, I'll check it out; thank you!
Since earlier today I started experiencing problems on my HTC Desire with the proximity sensor. For those that does not know, the proximity sensor switches the screen off when you receive or make a call and places the phone against your ear. When the call is completed and you remove the phone from your ear, the screen become active again.
In my case the moment I make or receive a call, the screen gets disabled. I do not even have to put the phone against my ear. It also means that the touchscreen is disabled and all buttons are disabled which means I cannot end the call, switch on the speaker or enable the keypad. None of the buttons, even the power one works. When the call gets ended by the other party the the screen will be enabled again. The only way to get a working phone again when there is nobody on the other side to end the call is to remove the battery.
What I also find weird is where the sensor should be, top left next to the HTC logo, is nothing. Does not matter how I look at it, there is just the black strip.
I have searched to see if there is some app that can disable the proximity sensor since I do not really need it but have found nothing. So if anybody knows of an app that can disable the proximity sensor then I would appreciate the link. If you have any other suggestions, please comment below.
Can't you enable your screen by the power button?
No i can`t
Vous.Thal said:
Can't you enable your screen by the power button?
Click to expand...
Click to collapse
I just installed CM7on my phone and the power button works.
My first suggestion would have been to test if and how the proximity sensor works, for example with this app:
play. google.com/store/apps/details?id=com.tigermonster.proxfinder
Otherwise, for just disabling the sensor there should be another app (which however requires root):
play. google.com/store/apps/details?id=com.hatcyl.android.Hardware_Disabler
(you have to remove the space in the link because as a new user I'm not allowed to post links... they don't like new users here, right?)
A bad kernel flash can cause it... flash another kernel according to the android version and rom you are using.. If cm7 and android 2.3.7 then snq- 's kernel would be nice .. if on ICS then I recommend tiamat's kernel..
http://forum.xda-developers.com/showpost.php?p=25782354&postcount=3
My screen is cracked over the proximity sensor so when i make calls the screen goes black until the call ends or i reset the phone.
In touchwiz there is an option to turn off proximity during calls but I would like to use PA, so does anyone know of an app, hack, mod, or setting that will disable the proximity sensor on aosp roms?
TIA,
dL
Possible solutions:
build.prop tweak:
http://forum.xda-developers.com/showthread.php?t=1626611
ICS mod, might work?
http://forum.xda-developers.com/showthread.php?t=1874297
App, looks like it might have a setting somewhere to help you:
http://forum.xda-developers.com/showthread.php?t=2237777
ALWAYS back up yo junk first.....
Try an app called Tasker.
Sent from my SPH-L710 using Tapatalk 4 Beta
Running 7.1.1 on my nexus 5x with google dialer 8.0.148481159.
When in call proximity sensor is not disabling or enabling the screen.
Very annoying to have to hit the power button to activate/deactivate screen so that my face doesn't hit all sorts of buttons while in call!
Downloaded AIDA64 to test if proximity sensor working properly, values change normally when putting hand in front of sensor.
Anyone else have this problem? Is it an issue that google is aware of and is working on?
This weekend I unlocked the bootloader and installed LineageOS 14.1 (rooted) on my LG G4 / UK h815. I have a flipcover case and I want to stop the screen turning on/off when I open/close the cover. There doesn't seem to be an option within Nougat/LOS 14.1 to disable this feature. I've found a few apps that claim to disable the proximity sensor but none fixed this issue so I presume it must depend on the magnet sensor instead? Has anyone else been successful in disabling this? How did you do it?
I flashed TWRP to my recovery partition following the instructions here:
https://wiki.lineageos.org/devices/h815/install
fastboot said it flashed OK but I have not been able to enter into TWRP by doing the VOLUME DOWN + POWER BUTTON dance. All I get when doing that is the stock factory reset menus so I have only been able to boot into TWRP by using fastboot. Is there something missing from that guide or is there a better guide thats guaranteed to enable me to boot into TWRP by using the boot button trick?
I knew the LOS camera wasn't going to be as good as the stock one so I used ES File Manger to dump the camera apk from the stock rom but the apk failed to install, claiming it was corrupt. Maybe it would've worked if I dumped it using a different app or maybe its not compatible with Nougat? Can I download a working apk of the stock camera from somewhere?
Finally, does Quick Charge work under LOS? Under the stock rom it would say 'Fast charging' when I use my quick charge charger and cable but it always says 'Charging slowly' under LOS whether I use quickcharge gear or not.
Thanks
The first showstopping (really annoying) bug I've come across with LOS 14.1 is that the screen randomly goes very dim, even when the battery is fully charged, and adjusting the screen brightness slider (if you can make it out) has no effect. The only fix when this happens seems to be rebooting.
I won't be putting up with that happening multiple times a day so unless someone has a fix I'll be looking for another ROM.
pfmdan said:
The first showstopping (really annoying) bug I've come across with LOS 14.1 is that the screen randomly goes very dim, even when the battery is fully charged, and adjusting the screen brightness slider (if you can make it out) has no effect. The only fix when this happens seems to be rebooting.
I won't be putting up with that happening multiple times a day so unless someone has a fix I'll be looking for another ROM.
Click to expand...
Click to collapse
Thats Live Display. Sensor is Reading Brightness and Adjust Screen brightness. Sometimes that takes 2-3 Sec.
With case You should disable it in Options otherwise you will deal with it most everytime.
Next:
Did you know what you are doing? Stock camera on custom rom? really?!! With LOS 14 u installed a custom kernel, so stock camera isnt supported anymore. NO driver / different Driver for camera as cause. Use Google Camera or other. use Search.
next:
Quick Charge work, but it is only a flaw of los that it shows slow charging.
other suggestions would be it is a kernel setting.
Hi uweork
Sounds like I need to disable live display to avoid the dim screen problem then. The screen brightness slider shouldn't stop working though, surely?
You say I should be able fix my flipcase screen problem by disabling it in options (do you mean Settings?) but where exactly? I have tried disabling 'Flip cover' under settings but that doesn't stop the cover turning the screen on/off when I open/close the flip cover. The only solution I can think of is working out which devices (under /dev/input probably) are used for the magnet and proximity sensors then writing a script that will delete them at boot but that seems like an awful hack to me - I'm hoping there is a nicer fix.
Thanks!
pfmdan said:
Hi uweork
Sounds like I need to disable live display to avoid the dim screen problem then. The screen brightness slider shouldn't stop working though, surely?
You say I should be able fix my flipcase screen problem by disabling it in options (do you mean Settings?) but where exactly? I have tried disabling 'Flip cover' under settings but that doesn't stop the cover turning the screen on/off when I open/close the flip cover. The only solution I can think of is working out which devices (under /dev/input probably) are used for the magnet and proximity sensors then writing a script that will delete them at boot but that seems like an awful hack to me - I'm hoping there is a nicer fix.
Thanks!
Click to expand...
Click to collapse
About your Problem with Flipcase is didn´t mention a thing. so ich dont know what to do.
But live display you find in Settings-> Display (i didn´t use Los 14 so maybe someone other can be of more help here)
pfmdan said:
Hi uweork
Sounds like I need to disable live display to avoid the dim screen problem then. The screen brightness slider shouldn't stop working though, surely?
You say I should be able fix my flipcase screen problem by disabling it in options (do you mean Settings?) but where exactly? I have tried disabling 'Flip cover' under settings but that doesn't stop the cover turning the screen on/off when I open/close the flip cover. The only solution I can think of is working out which devices (under /dev/input probably) are used for the magnet and proximity sensors then writing a script that will delete them at boot but that seems like an awful hack to me - I'm hoping there is a nicer fix.
Thanks!
Click to expand...
Click to collapse
Live display is a colour temp change (basically a night mode). Sounds more like a bug that you can't change brightness manually.
As for the flip cover, why do you want to disable it fully? I don't think you can even on stock LG can you?
I've fixed my screen woes with xposed and the Magnet Sensor Control module 1.1. It only claims to support Nexus devices but it seems to work fine with the G4 too.