I was an idiot and did a factory reset (not while in recovery mode) and when everything restarted I ended up with my tablet stuck trying to load TWRP - I am/was running the lastest CM nightly from the end of May, I don't know what version of TWRP is currently on there. I just get the blue teamwin screen that stays there for about 5 seconds, flashes black, then back to the teamwin screen again. I got it into download mode one time, but as I was not in a situation where I could take advantage, and have since forgotten what I did to get it into download mode. (I think) I've tried all the button combinations with the tablet in the bootloop, and with it off (dead battery) to no avail. I've checked the forums and the few that I've found with the same situation as me, there is either no solution offered, or the solution was never posted, just that the situation was resolved - the thread most resembling my situation is this one http://forum.xda-developers.com/galaxy-tab-s/help/galaxy-tab-s-sm-800-stuck-flashing-twrp-t3219865.
Any help would be greatly appreciated. If you need more information, let me know. Thanks!
Related
Hi guys, hope you can help me I`ve tried everything I can.
Following a mishap yesterday, my Note 2 which was successfully running Resurrection Remix Android 5.1 for the past 6 months has now been bricked, i think is the term.
My son accidentally updated the RR5.1 to a newer version then the phone went low batt. I restarted the phone and got the message Encryption Unsuccessful --> Reset your phone, which i did. (I read somewhere afterwards that it might have been a mistake to hit reset.)
Now my phone is stuck in Teamwin screen mode which is flashing and it does nothing. I restarted the phone into Android Odin mode, Vol- + Home + Power button and it says "Downloading.... Do not turn off target!!" which has been now showing on my phone for more than 5 hours.
To top this wee problem, since I could use Odin on my laptop to mount a Teamwin Loader and flash a new ClockworkMod 5.1.1 OS on it which I have BUT...............and heres the big BUT.....
None of my USB ports recognize my phone, installed 2 versions of the Samsung USB drivers and still nothing. So WHAT can I do other than what I already have been doing.
And a reminder before anyone tells me to enter this and that on my keypad...... PHONE STUCK IN ODIN and TEAMWIN splash screen.
Cheers and hope someone gets back to me,
All I did was do a reset to factory settings on my tablet, it rebooted and it's now in a TWRP bootloop?
I see the TWRP logo come on and then the screen goes black and then the TWRP logo comes on again?
Please help! I have no idea what to do???
I searched all over Google but couldn't find anything that worked?
This has happened to a lot of people: http://forums.androidcentral.com/sa...p-after-factory-reset-cyanogenmod-12-1-a.html
So, I'm going to make this warning REALLY BIG so this doesn't happen to you as well:
If you are running CyanogenMod 12.1 and TWRP recovery, then DO NOT ever do a FACTORY RESET.
You will break your tablet.
HOW TO FIX:
The only way I was able to fix this was to use Odin and put the stock firmware back onto the tablet.
Hello, can anyone help me, where to download the stock firmware.
I think, I'm having a same problem here. My boot screen are blank, right after the Title screen
Hello guys,
Thank you for reading, any help is appreciated.
My device was running the latest release of CM13 (cm-13.0-20160418-SNAPSHOT-ZNH0EAO2NK-serrano3gxx) and TWRP v3.0.2-1
So yesterday afternoon my phone randomly shutdown and I was unable to get it turned back on until this morning.
However though when i did manage to get it powered on after hours of failed tries it was stuck on the Samsung boot screen.
I've since tried to access the TWRP Recovery (Pwr + Vol Up + Home) but it sticks on the TWRP slash screen and then attempts to reboot normally (which as i said stick on the Samsung boot screen).
I also tried re-installing TWRP via Odin and it appears to be installing properly and successfully but when i attempt to access TWRP it again sticks on the splash screen,
I've also tried installing CWM Record via odin and that also appears to be installing properly and successfully but when I attempt to access the recovery I am yet again greeted with the TWRP Slash Screen which has lead me to believe something is going wrong.
Any ideas or suggestions as to what may be going on here ?
Thanks in advance, any help is appreciated.
Hey again guys,
I have tried installing stock rom via Odin, It says Pass but nothing at all seems to be changing.
I'm beginning to think Odin may really not be working at all or something is wrong with the phone
Update: I tried flashing TWRP recovery via Heimdall and it appears to have completed successfully saying "RECOVERY upload successful" but when i reboot immediately after into Recovery mode it still sticks at the TWRP 3.0.0-0 Splash Screen then attempts to reboot normally which as mentioned earlier also sticks on samsung slash screen
Hi guys. I have a factory refurbished AT&T E980 that had stock 4.2.2 on it when I got it. Assuming it was the last OTA that was pushed out. I attempted to downgrade to 10g because I was still learning the recovery options for this phone. I've since flashed most of the available JB builds with similiar results. From off, the phone will show the AT&T logo for a few seconds, then go to a black screen for several seconds. Then I have to hit the power button twice to bring up the home screen. There is no boot animation, but you can hear the accompanying sound. I seemingly cannot get any roms to boot, other than stock, as they all hang at a black screen, even after wiping/factory reset. I also cannot get any variants of recoveries to work, other than the CWM packaged with GPro Recovery. The TWRP included with that only shows a black screen with the back and menu buttons lit up, and the home button cycling through colors.
I've searched through the forums and haven't seen anyone experiencing this issue. My only clue to the problem is reading something about another LG phone that, once refurbished, came with updated display drivers that caused a similar issue. Here.
Any insight would be appreciated.
*Edit
I flashed SphinX Pro v2.0 after posting this. It corrected the above issues, and allowed me to boot into the included philz recovery with no problems. I then tried to use philz to flash the Cloudy TWRP in preparation for installing Super Mini V6.5 but was unsuccessful. What I assume is supposed to be recovery is now a black screen. The bootanimation is gone, but I no longer have to cycle the power button to show the home screen once it boots all the way up.
Hello, everyone. A couple of days ago, I dropped my tab s while I was sleeping. When I woke up, I found that it was stuck in a boot loop. Since, I've had this problem twice before, I wasn't worried since the problem solved itself by waiting it out. However, this time it is just stuck in this screen
imgur . com/a/sLA22(can't post links, sorry. Just delete that space after imgur. ) . I've tried to access the recovery mode to no avail, so I googled and tried to install TWRP. To do that, I've installed Odin and downloaded twrp tar file for my lte edition tablet. I believe that the installation went smoothly, imgur . com/a/JlVvz but no matter what I do, I just can't get into recovery using the volume up, home button, and power button combination. I have even flashed twrp multiple times. Please help me because I have no idea what to do.
P.S: My tablet runs stock marshmallow.
I solved it. I did more Googling and found someone who suggested to hit the area near the power button; I did just that in addition to taking off the SD card for no reason and let my tab charge to 100%. So, if you can't get into recovery, and your phone is stuck in the Samsung tab s screen, try what I did.