So Long Story,
Monday November 24, I Changed Out Battery Go To Restart Phone, Phone Wont Boot Stuck On LG Screens And Constantly Retrying. Tuesday Night November 25, I ReInstall Factory Firmware For G3 D852 – With Success – Phone Working. Wednesday November 26, I Decide To Root & Install TWRP – With Success – Phone Working No Issues. Friday November 28, This Is Where Sh*t Hits The Fan! I Get Crazy & Attempt To Install ChupaChups Lollipop Rom With TWRP – Seemingly Successful Install But After Reboot Wont Boot Stuck In Fast Boot. So I Attempt To Resolve This Following Other Forum Posts Using FastBootOV – WITHOUT Success – Now When Attempting To Boot Phone LG Screen Comes Up Top Left Corner Says “ERROR Boot Certification Verify” Below That Says “590 Secure Booting ERROR!” Then Black Screen With Flashing Red & Blue LED. I Attempted To ReInstall Factory Firmware For D852 With LG Flashtool Attempt Fails Stating Wrong Model Number – Phone States On Screen Near Bottom Now D855 Ver5.0 Below That D85520A.
Finally Success With Phone December 28, After Countless Hours Trying to Find Some Shred Of Info To Resolve This Including Posting Here For Help Without A Response. I Proceed To Attempt To Reinstall Factory Firmware For D852 - Failed Same Result Wrong Model Number D855. Actual Model D852. I Then Decided F**K It Ill Install D855 Factory 32G Firmware UK Version Why Not? At This Point Phones A Paper Weight In This Time Had To Purchase Another Phone (So I Dont Lose My Mind) - All Available Information Points To Send In For Warranty. So I Do So Again Attempting To Install The D855 UK Firmware Failed To Install Using LG FlashTool, This Time Stating Partition Errors. So I Find After Random Searching & Random Reading Of Everything LG G3. I Find A Generic LG G3 DLL File (LGUP_8974.DLL). Using The Generic LG G3 DLL & Factory Firmware D852 With LG FlashTool - This Time Working Up To 89%, Phone Reboots Shows Large 2, Crossing My Fingers Waiting For The Large 3. What Actually Pops Up Is A Large 0. I Attempt To Reboot Phone Goes To Mini OS, Set Phone To Reboot Normally - AND SUCCESS!!!!!! Factory OS Boots Up, The Usual YADAYADA Setup.
So Thats All, A Long Winded Story BUT Now There Seems To A Cure To Flashing WRONG Model G3 Roms To Your Device.
Hope This Works For Everyone - I Have Devoted Coutless Hours Trying to Avoid Sending My Phone In.
Good Luck!!
I Am Unable To Post Download Link For Generic DLL File Since I Am A New Member.
I did the exact same mistake with my D852 and my LG G3 says my phone is a D855 in the firmware update, I will try this out and hopefully it works!!!!
[email protected] said:
So Long Story,
Monday November 24, I Changed Out Battery Go To Restart Phone, Phone Wont Boot Stuck On LG Screens And Constantly Retrying. Tuesday Night November 25, I ReInstall Factory Firmware For G3 D852 – With Success – Phone Working. Wednesday November 26, I Decide To Root & Install TWRP – With Success – Phone Working No Issues. Friday November 28, This Is Where Sh*t Hits The Fan! I Get Crazy & Attempt To Install ChupaChups Lollipop Rom With TWRP – Seemingly Successful Install But After Reboot Wont Boot Stuck In Fast Boot. So I Attempt To Resolve This Following Other Forum Posts Using FastBootOV – WITHOUT Success – Now When Attempting To Boot Phone LG Screen Comes Up Top Left Corner Says “ERROR Boot Certification Verify” Below That Says “590 Secure Booting ERROR!” Then Black Screen With Flashing Red & Blue LED. I Attempted To ReInstall Factory Firmware For D852 With LG Flashtool Attempt Fails Stating Wrong Model Number – Phone States On Screen Near Bottom Now D855 Ver5.0 Below That D85520A.
Finally Success With Phone December 28, After Countless Hours Trying to Find Some Shred Of Info To Resolve This Including Posting Here For Help Without A Response. I Proceed To Attempt To Reinstall Factory Firmware For D852 - Failed Same Result Wrong Model Number D855. Actual Model D852. I Then Decided F**K It Ill Install D855 Factory 32G Firmware UK Version Why Not? At This Point Phones A Paper Weight In This Time Had To Purchase Another Phone (So I Dont Lose My Mind) - All Available Information Points To Send In For Warranty. So I Do So Again Attempting To Install The D855 UK Firmware Failed To Install Using LG FlashTool, This Time Stating Partition Errors. So I Find After Random Searching & Random Reading Of Everything LG G3. I Find A Generic LG G3 DLL File (LGUP_8974.DLL). Using The Generic LG G3 DLL & Factory Firmware D852 With LG FlashTool - This Time Working Up To 89%, Phone Reboots Shows Large 2, Crossing My Fingers Waiting For The Large 3. What Actually Pops Up Is A Large 0. I Attempt To Reboot Phone Goes To Mini OS, Set Phone To Reboot Normally - AND SUCCESS!!!!!! Factory OS Boots Up, The Usual YADAYADA Setup.
So Thats All, A Long Winded Story BUT Now There Seems To A Cure To Flashing WRONG Model G3 Roms To Your Device.
Hope This Works For Everyone - I Have Devoted Coutless Hours Trying to Avoid Sending My Phone In.
Good Luck!!
I Am Unable To Post Download Link For Generic DLL File Since I Am A New Member.
Click to expand...
Click to collapse
Man, this was a long story but I am so glad you have posted this. I always wondered what would happen if I by mistake flash the wrong file (diff model), and now I know. Can you please send me the link to the info and the files, just in case I end up where you were (email: elmspace at gmail dot com), I would appreciate it.
Thanks man. I was just wondering what is going to happen to my LG g3 D856 variant if i flash D855 kdz. Now um not gonna do that. Let's not flash any rom. I successfully rooted and am using D858HK twrp ( yeah D858HK) successfully.
hi hi
hi hi same problem after i want to root the phone my LG G3 D852 my phone stuck on fastboot mode blackscreen ,my pc see it like Android bootloader Interface BUT no other programs see it try lg flash tool or lg repair tool or cmd command nothing they don't see my G3 HELP HELP PLEASE
Sorry for the no response on this problem , got the same problem last year by flashing the d850 rom to a d852 model but this solution is not recommended. It works sometimes (was working with mine but I bring it to LG because the motherboard dies for no reason after one month of use lol) but the installation can go wrong and destroy your motherboard.
Envoyé de mon LG-D852 avec XDA Forums Pro.
Holy hell I ran into the same issue and spent countless hours getting my D852 back to life after flashing the wrong ROM. I found this and sure enough it came back!
plss help
sarktheshark said:
I did the exact same mistake with my D852 and my LG G3 says my phone is a D855 in the firmware update, I will try this out and hopefully it works!!!!
Click to expand...
Click to collapse
i tried custom rom cloudt g3 but insted of f400s i installed d855 now its stuck in fastboot plss help
:crying:
This is nice solution.
Many users will thanks...
?
Sent from my LG-D855 using Tapatalk
Hello,
I recently just got the unlocked LG G3, used to have an iphone so pretty new to the Android software itself. It froze while I was playing music so I did a hard reset and with that the firmware was updated to Lollipop. Calling, messaging, and music didn't work so I attempted to downgrade my LG G3 using Flashtool (Followed exact steps on here androidexplained/howtodowngradeLgG3, can't put URL because I'm a new user) and I used the Bell firmware (I'm sure the phone is originally from Bell because they had pre-installed apps). Everything went smoothly to the very end, however it got stuck on the screen where the LED light is flashing and the logo of LG continously shines (is this boot-loop?). I've tried using PC Suite to reset the software however it doesn't recognize my phone. Is there any suggestions you would recommend me?
Thank you for the help
federer13 said:
Hello,
I recently just got the unlocked LG G3, used to have an iphone so pretty new to the Android software itself. It froze while I was playing music so I did a hard reset and with that the firmware was updated to Lollipop. Calling, messaging, and music didn't work so I attempted to downgrade my LG G3 using Flashtool (Followed exact steps on here androidexplained/howtodowngradeLgG3, can't put URL because I'm a new user) and I used the Bell firmware (I'm sure the phone is originally from Bell because they had pre-installed apps). Everything went smoothly to the very end, however it got stuck on the screen where the LED light is flashing and the logo of LG continously shines (is this boot-loop?). I've tried using PC Suite to reset the software however it doesn't recognize my phone. Is there any suggestions you would recommend me?
Thank you for the help
Click to expand...
Click to collapse
Does it boot into download mode still?
this same thing has happened to me while trying to flash twrp i guess i didnt notice that there is a d852g as well as 852 (the one i used) now its stuck on logo and i cant flash a rom so what do i do now?
federer13 said:
Hello,
I recently just got the unlocked LG G3, used to have an iphone so pretty new to the Android software itself. It froze while I was playing music so I did a hard reset and with that the firmware was updated to Lollipop. Calling, messaging, and music didn't work so I attempted to downgrade my LG G3 using Flashtool (Followed exact steps on here androidexplained/howtodowngradeLgG3, can't put URL because I'm a new user) and I used the Bell firmware (I'm sure the phone is originally from Bell because they had pre-installed apps). Everything went smoothly to the very end, however it got stuck on the screen where the LED light is flashing and the logo of LG continously shines (is this boot-loop?). I've tried using PC Suite to reset the software however it doesn't recognize my phone. Is there any suggestions you would recommend me?
Thank you for the help
Click to expand...
Click to collapse
Try to re-flash it again with the LG Flashtool and be sure to follow all steps correctly. It should work. Don't disconnect the phone until the process is finished. If the process freezes at 85% it's ok, it means the phone is rebooting and wait until you see a blue screen with a "3" on it. Then disconnect the phone and take out the phone's battery and put it in again. It should boot correctly. The first time to boot is always a bit longer. Just be patience.
I don't know where to start. So I changed the resolution of my LG G3 F400L to 1080p via terminal. then I reboot it. The LG boot logo appear, after waiting for a while the logo won't go anywhere. the boot sound can be heard also when I touch the screen I can hear unlocking sound and touch feedback which means my device is working properly JUST the LG bootlogo covers up everything just like a curtain.
Another thing is, I tried to boot it to recovery to restore my firmware but it just won't work. My device has TWRP flashed by AutoRec. I used every button combination and tried like 100 times each that I found here: http://forum.xda-developers.com/lg-g3/help/f400l-recovery-t2960352 but the device won't boot to recovery. It just boots normally and stuck on LG bootlogo as I mentioned above.
Running to a dead end. I put my device to download mode (which the only mode that I'm able to do) to flash my device back to stock ROM using LG Flash Tool. After a few processes it stucks at S\W Upgrade part saying "Upgrade stopped due to an error". Just so you know I have the latest driver installed.
The stress and frustration really makes me want to bump my head to death. Any help and solution IS GREATLY APPRECIATED!
Please Help me.
Hi all, I've had some issues with my G3 and have got to the point where I need the advice of wiser heads to try and fix the problem!
The phone seemingly died during an update a few weeks ago, but I was able to fix it using LG's tool and upgrading to Marshmallow. Then a few days ago with no warning the phone froze, and gets stuck in a bootloop at the LG screen, with the flashing LED. If I try to factory reset, I just end up with the Android Droid with a red triangle and I can't get any further. I've tried numerous guides I've found to try and reinstall the stock firmware, all without success. (I haven't tried accessing bootloader as I have download mode available). LG's own tool gets stuck at 4% when I try to recover, and I've tried the LG Flash Tool but get an error at 6% (LAF_READ_GPT_FAILED) using the 8974 dll. I've also tried the LGUP tool but that gets stuck at 6% (Error can't communicate with phone[Kilo Packet]. The phone was not rooted and is a 16GB UK version (model D855). I just seem to be going in circles now trying to find a solution, I suspect somewhere along the line I'm using the wrong combination of programs/TOT/DLL files so I could really do with someone pointing me in the right direction here!
Hello, I wanted to unroot my phone from SuperSU, using the Fully unroot thingy that it has. After letting it be for awhile i realized it was just only at the bootup screen where the LG logo is and blue light was slowly blinking. Now I've tried LG flash tool to get me back to factory settings and I've tried different .kdz files, none of them seems to work. Furthest I got: I saw the firmware's name on my phone screen for a few seconds and then it dissappeared. Always LG Flash Tool fails after 9% and it says "Upgrade stopped due to an error." I have no idea what to do anymore with my phone. Any help is appreciated! Computer only recognises my phone when it's in firmware update mode.
Use LG UP...
Noksucow1 said:
Use LG UP...
Click to expand...
Click to collapse
Lg UP didn't work aswell, didn't recognize my phone, I already got it with LG Bridge, thanks!